Instruction Manual for PIXAPRO Firmware Update Software G2

Instruction Manual for PIXAPRO Firmware Update Software G2
Preparing for updates
1. The firmware update software G2 can be run in operating systems Windows 10
(64bit), Windows 8.1(64bit), Windows 7 (32bit or 64bit) or Windows XP (32bit or
64bit).
2. Before installing this application, please shut down other applications especially
antivirus software.
Download and Install the Application
1. Download the G2 application from the official website and complete the installation
according to the guide.
Upgrade the Device with G2
G2 Interface
Upg
grade Methods
Step
p 1: Select the Document
oad the relevant produ ct firmware (model.dfu)
Plea
ase downlo
Then, cli ck the “Sele
ect File” to open the .dfu file.
Step
p2: Connectt the Device
1. Please disccharge the device before
e updating.
Name of Device
Discharge Metthods
PIKA200,
ST-III O,
Re
emove the b attery and press the OFF/ON butto n for 2 seconds
(p
press the test button if do not have OFF/ON button) .
ST-III F
2. For the firstt firmware update, Wind
dows will prompt you to install a US B driver. Ple
ease
nishing the d river installation. When
click “Conne
ect” after fin
n getting cor rect connec
ction,
“STM Devicce in DFU Mode” will dis play in about 1 minute.
3. Updating.
Firmware software G2, can be downloaded from
www.essentialphoto.co.uk/firmware
Download PDF
Similar pages