Oil-Water-Separator ÖWAMAT 10 without

Oil-Water-Separator ÖWAMAT 10 without preseparator
Efficient oil-water separation of oil-contaminated compressed air condensate. Especially co-ordinated to
suit varying sizes of air compressor installations. The oil-water separator ÖWAMAT conforms to the
requirements with regard to the current state of the art laid down in the German Water Resources Act. By
awarding the test mark Z-83.5.9 (Institute of Constructional Engineering) confirms the operating functions
and safety of the ÖWAMAT. Profitability and efficiency have been approved in preceding examinations of
the DEKRA Umwelt GmbH.
Characteristics
· cast container made of recyclable polyethylene
· pressure-relief and sound absorption chamber with an integrated exhaust-filter mat
· special conical adsorption filter, combined with an oleophilic pre-filter
· sampling valve
· ready for connection
Included in the supply
· 1 pc. opaqueness reference tube
· 1 OEKOSORB filter set
· Wall fixture and fittings for wall and floor assembly
The filter should be replaced at the latest after six months, depending on the output turbidity. SAP-OrderRef.: 4010719
ATTENTION! The ÖWAMAT is not able to separate stable emulsions!
Note:
Automatic oil-water separation is only possible when the condensate is drained
automatically without turbulence. The best and most economic solution is our BEKOMAT
electronic capacitive controlled condensate drain.
Technical Data and dimensioned drawing, see next page…
Technical Data ÖWAMAT 10 without preseparator
Installed compressor capacity:
Receptacle capacity:
Filling volume:
Prefilter:
Mainfilter:
condensate inlet (hose):
water outlet (hose):
Weight empty:
1,4 - 2,4 m³/min
10 l
4,3 l
2,5 l
2,0 l
2 X G½ (di=10mm)
G½ (di=10mm)
3,5 kg
Dimensioned drawing
A
B
C
D
E
F
G
528 mm
464 mm
290 mm
100 mm
222 mm
110 mm
330 mm
OWAMAT 10
2/2
Oil-Water-Separator ÖWAMAT 11 without preseparator
Efficient oil-water separation of oil-contaminated compressed air condensate. Especially co-ordinated to
suit varying sizes of air compressor installations. The oil-water separator ÖWAMAT conforms to the
requirements with regard to the current state of the art laid down in the German Water Resources Act. By
awarding the test mark Z-83.5.9 (Institute of Constructional Engineering) confirms the operating functions
and safety of the ÖWAMAT. Profitability and efficiency have been approved in preceding examinations of
the DEKRA Umwelt GmbH.
Characteristics
· cast container made of recyclable polyethylene
· pressure-relief and sound absorption chamber with an integrated exhaust-filter mat
· special conical adsorption filter, combined with an oleophilic pre-filter
· sampling valve
· ready for connection
Included in the supply
· 1 pc. opaqueness reference tube
· 1 OEKOSORB filter set
· Wall fixture and fittings for wall and floor assembly
The filter should be replaced at the latest after six months, depending on the output turbidity. SAP-OrderRef.: 4011999
ATTENTION! The ÖWAMAT is not able to separate stable emulsions!
Note:
Automatic oil-water separation is only possible when the condensate is drained
automatically without turbulence. The best and most economic solution is our BEKOMAT
electronic capacitive controlled condensate drain.
Technical Data and dimensioned drawing, see next page…
Technical Data ÖWAMAT 11
Installed compressor capacity:
Receptacle capacity:
Filling volume:
Prefilter:
Mainfilter:
condensate inlet (hose):
water outlet (hose):
Weight empty:
2,8 - 4,9 m³/min
18,6 l
11,7 l
4,7 l
3,7 l
2 X G½ (di=10mm)
G½ (di=10mm)
4 kg
Dimensioned drawing
A
B
C
D
E
F
G
H
595 mm
368 mm
110 mm
31 mm
534 mm
140 mm
90 mm
254 mm
OWAMAT 11
2/2
Oil-Water-Separator ÖWAMAT 12 with preseparator
Efficient oil-water separation of oil-contaminated compressed air condensate. Especially co-ordinated to
suit varying sizes of air compressor installations. The oil-water separator ÖWAMAT conforms to the
requirements with regard to the current state of the art laid down in the German Water Resources Act. By
awarding the test mark Z-83.5.9 (Institute of Constructional Engineering) confirms the operating functions
and safety of the ÖWAMAT. Profitability and efficiency have been approved in preceding examinations of
the DEKRA Umwelt GmbH.
Characteristics
· cast container made of recyclable polyethylene
· pressure-relief and sound absorption chamber with an integrated exhaust-filter mat and dirt
collection basin
· multiple-connection adapter (rotatable at 3 positions) for up to 4 condensate inlet lines
· operator-friendly cartridge technology enables quick and clean replacement
· sampling valve
· integrated level detector for filter monitoring
· overflow-proof oil reservoir kit, a vertically adjustable oil drainage pipe allows easy interchanging of
basins
· ready for connection
Included in the supply
· 2 pcs. PE container set with connection-set
· 1 pc. opaqueness reference tube
· 1 OEKOSORB filter set
The filter should be replaced at the latest after six months, depending on the output turbidity. SAP-OrderRef.: 4010711
ATTENTION! The ÖWAMAT is not able to separate stable emulsions!
Note:
Automatic oil-water separation is only possible when the condensate is drained
automatically without turbulence. The best and most economic solution is our BEKOMAT
electronic capacitive controlled condensate drain.
Technical Data and dimensioned drawing, see next page…
Technical Data ÖWAMAT 12 with preseparator
Installed compressor capacity:
Receptacle capacity:
Filling volume:
Prefilter:
Mainfilter:
condensate inlet (hose):
water outlet (hose):
Weight empty:
4,2 - 7,3 m³/min
30,6 l
22,7 l
2,5 l
5,9 l
3 X G½ (di=10mm);1 X G1 (di=25mm)
G½ (di=10mm)
13,5 kg
Dimensioned drawing
A
C
D
F
G
H
698 mm
357 mm
544 mm
320 mm
340 mm
200 mm
OWAMAT 12
2/2
Oil-Water-Separator ÖWAMAT 14 with preseparator
Efficient oil-water separation of oil-contaminated compressed air condensate. Especially co-ordinated to
suit varying sizes of air compressor installations. The oil-water separator ÖWAMAT conforms to the
requirements with regard to the current state of the art laid down in the German Water Resources Act. By
awarding the test mark Z-83.5.9 (Institute of Constructional Engineering) confirms the operating functions
and safety of the ÖWAMAT. Profitability and efficiency have been approved in preceding examinations of
the DEKRA Umwelt GmbH.
Characteristics
· cast container made of recyclable polyethylene
· pressure-relief and sound absorption chamber with an integrated exhaust-filter mat and dirt
collection basin
· multiple-connection adapter (rotatable at 3 positions) for up to 4 condensate inlet lines
· operator-friendly cartridge technology enables quick and clean replacement
· sampling valve
· integrated level detector for filter monitoring
· overflow-proof oil reservoir kit, a vertically adjustable oil drainage pipe allows easy interchanging of
basins
· ready for connection
Included in the supply
· 2 pcs. PE container set with connection-set
· 1 pc. opaqueness reference tube
· 1 OEKOSORB filter set
The filter should be replaced at the latest after six months, depending on the output turbidity. SAP-OrderRef.: 4010712
ATTENTION! The ÖWAMAT is not able to separate stable emulsions!
Note:
Automatic oil-water separation is only possible when the condensate is drained
automatically without turbulence. The best and most economic solution is our BEKOMAT
electronic capacitive controlled condensate drain.
Technical Data and dimensioned drawing, see next page…
Technical Data ÖWAMAT 14 with preseparator
Installed compressor capacity:
Receptacle capacity:
Filling volume:
Prefilter:
Mainfilter:
condensate inlet (hose):
water outlet (hose):
Weight empty:
8,4 - 14,6 m³/min
61,3 l
46,3 l
6,7 l
11,0 l
3 X G½ (di=10mm);1 X G1 (di=25mm)
G1 (di=25mm)
18, 5 kg
Dimensioned drawing
A
C
D
F
G
H
876 mm
416 mm
594 mm
420 mm
460 mm
240 mm
OWAMAT 14
2/2
Oil-Water-Separator ÖWAMAT 15 with preseparator
Efficient oil-water separation of oil-contaminated compressed air condensate. Especially co-ordinated to
suit varying sizes of air compressor installations. The oil-water separator ÖWAMAT conforms to the
requirements with regard to the current state of the art laid down in the German Water Resources Act. By
awarding the test mark Z-83.5.9 (Institute of Constructional Engineering) confirms the operating functions
and safety of the ÖWAMAT. Profitability and efficiency have been approved in preceding examinations of
the DEKRA Umwelt GmbH.
Characteristics
· cast container made of recyclable polyethylene
· pressure-relief and sound absorption chamber with an integrated exhaust-filter mat and dirt
collection basin
· multiple-connection adapter (rotatable at 3 positions) for up to 4 condensate inlet lines
· operator-friendly cartridge technology enables quick and clean replacement
· sampling valve
· integrated level detector for filter monitoring
· overflow-proof oil reservoir kit, a vertically adjustable oil drainage pipe allows easy interchanging of
basins
· ready for connection
Included in the supply
· 2 pcs. PE container set with connection-set
· 1 pc. opaqueness reference tube
· 1 OEKOSORB filter set
The filter should be replaced at the latest after six months, depending on the output turbidity. SAP-OrderRef.: 4010713
ATTENTION! The ÖWAMAT is not able to separate stable emulsions!
Note:
Automatic oil-water separation is only possible when the condensate is drained
automatically without turbulence. The best and most economic solution is our BEKOMAT
electronic capacitive controlled condensate drain.
Technical Data and dimensioned drawing, see next page…
Technical Data ÖWAMAT 15 with preseparator
Installed compressor capacity:
Receptacle capacity:
Filling volume:
Prefilter:
Mainfilter:
condensate inlet (hose):
water outlet (hose):
Weight empty:
16,9 - 29,3 m³/min.
115,5 l
84,3 l
18,5 l
20,4 l
3 X G½ (di=10mm);1 X G1 (di=25mm)
G1 (di=25mm)
36,5 kg
Dimensioned drawing
A
C
D
F
G
H
1088 mm
530 mm
764 mm
505 mm
550 mm
270 mm
OWAMAT 15
2/2
Oil-Water-Separator ÖWAMAT 16 with preseparator
Efficient oil-water separation of oil-contaminated compressed air condensate. Especially co-ordinated to
suit varying sizes of air compressor installations. The oil-water separator ÖWAMAT conforms to the
requirements with regard to the current state of the art laid down in the German Water Resources Act. By
awarding the test mark Z-83.5.9 (Institute of Constructional Engineering) confirms the operating functions
and safety of the ÖWAMAT. Profitability and efficiency have been approved in preceding examinations of
the DEKRA Umwelt GmbH.
Characteristics
· cast container made of recyclable polyethylene
· pressure-relief and sound absorption chamber with an integrated exhaust-filter mat and dirt
collection basin
· multiple-connection adapter (rotatable at 3 positions) for up to 4 condensate inlet lines
· operator-friendly cartridge technology enables quick and clean replacement
· sampling valve
· integrated level detector for filter monitoring
· overflow-proof oil reservoir kit, a vertically adjustable oil drainage pipe allows easy interchanging of
basins
· ready for connection
Included in the supply
· 2 pcs. PE container set with connection-set
· 1 pc. opaqueness reference tube
· 1 OEKOSORB filter set
The filter should be replaced at the latest after six months, depending on the output turbidity. SAP-OrderRef.: 4010714
ATTENTION! The ÖWAMAT is not able to separate stable emulsions!
Note:
Automatic oil-water separation is only possible when the condensate is drained
automatically without turbulence. The best and most economic solution is our BEKOMAT
electronic capacitive controlled condensate drain.
Technical Data and dimensioned drawing, see next page…
Technical Data ÖWAMAT 16 with preseparator
Installed compressor capacity:
Receptacle capacity:
Filling volume:
Prefilter:
Mainfilter:
condensate inlet (hose):
water outlet (hose):
Weight empty:
33,8 - 58,5 m³/min.
228,4 l
158,8 l
36,2 l
40,3 l
3 X G½ (di=10mm);1 X G1 (di=25mm)
G1 (di=25mm)
53 kg
Dimensioned drawing
A
C
D
F
G
H
1158 mm
659 mm
939 mm
535 mm
580 mm
200 mm
OWAMAT 16
2/2
Download PDF
Similar pages