RM23512 QUICK INSTALLATION GUIDE
Major Components
Installing 3.5” Hot-Swap HDD
1. Install 3.5” HDD on the tray.
2. Secure the 3.5” HDD with four screws as shown.
3. With the lever open, insert the 3.5” HDD assembly into the chassis opening
and push until the locking lever engages.
4. Push in the lever to lock it into place.
2U Single or Redundant
Power Supply (Option)
Top Cover
Max. PWM Fan (4pcs)
4
Extended ATX M/B
1
2
3
12 x 3.5” Hot-Swap HDD Trays
Front Controls and Indicators
Installing Backplane Assembly
Front Panel Control and Indicators
A
D
E
F
B
C
1. Insert backplane vertically into the HDD cage; ensure that alignment screw holes
and standoff match up.
2. Secure the backplane with six screws as shown.
A. System Reset Button
B. Mute Button
C. Power LED
D. Power Button
E. Warning LED
F. LAN1, LAN2 Activity LED
2
1
G. USB 2.0 Port x 2
2
2
Rear Window Configuration
B
A
Installing Middle Fan Module
D
C
A. Power Supply (Option)
B. 40mm Exhaust Fan (Option)
C. System I/O (Depend on M/B Specification)
D. 7 x Low Profile Slot Opening
E. 3 x FH PCI Slot (Option)
1. Clip the fan latch device in the direction as shown while slide down the fan until
the latch lock it into place.
E
Top Cover Opening
1
1
!
2
1
2
CAUTION
!
This unit must be operated
with the chassis
TOP COVER installed to
ensure proper cooling
1
Installing Power Supply
1. Remove two screws on the rear window and two screws on both sides as shown.
2. Slide the top cover back and lift up to remove it.
1. Secure the PSU bracket on the PSU with six screws as shown.
2. Install the PSU into chassis; ensure that alignment screw holes and bracket match up.
3. Secure the PSU with two screws as shown (from outer to inner).
4. Secure the PSU with three screw on the rear window as shown.
Installing 12 Bay 3.5” H/S HDD Cage
1
1
1
1
4
2
1
1
4
2
1
2
1. Remove six screws from top, four screws from bottom,
and two screws from both as shown.
2. Carefully remove the HDD cage.
1
3
V1.0
2016.12
Download PDF
Similar pages