Cordless 2-in-1 Stick
Vacuum Cleaner
G18SVR16
Instruction Manual
Contents
Safety Warnings........................................................................................................................4
Unpacking...................................................................................................................................7
Product Overview.....................................................................................................................8
Preparation Before Use...........................................................................................................9
Operation................................................................................................................................. 12
Cleaning the Dust Tank and Filter.................................................................................... 13
Cleaning the Agitator........................................................................................................... 16
Hints and Tips......................................................................................................................... 17
Specifications.......................................................................................................................... 17
Safety Warnings
For your continued safety and to reduce the risk of injury or
electric shock, please follow all the safety precautions listed
below.
• Read all the instructions carefully before using the appliance
and keep them for future reference.
• Retain the manual. If you pass the appliance onto a third
party make sure to include this manual.
• Check that the voltage marked on the rating label matches
your mains voltage.
• Consult your dealer if you are ever in doubt about the
installation, operation or safety of your appliance.
• Do not remove any fixed cover as this may expose
dangerous voltages.
• Do not allow any electrical appliance to be exposed to
dripping or splashing.
• To protect against electrical shock, do not immerse mains
adapter, or any part of the appliance in water or other
liquids.
• Never vacuum up water or any other liquids. Never vacuum
up flammable substances and do not vacuum up ashes until
they are cold.
• Never use the appliance without the motor protection
filter. This damages the motor and shortens the life of the
appliance.
• If a blockage is found in the brushes, hoses or tubes, it
should be removed before use.
• Store and use the appliance well away from heat sources
such as radiators or gas/electric fires.
• Do not run over any cord with the appliance.
• Close supervision is necessary when any appliance is used
by or near children.
4
• This appliance is not to be used by persons (including
children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction concerning
use of the appliance by a person responsible for their safety.
• Keep the appliance and its cord out of reach of children.
• Children should be supervised to ensure that they do not
play with the appliance.
• Do not point the hose, tube or any other accessory at the
eyes, ears or mouth during operation.
• Unplug the appliance from the mains socket when it is not
in use and before replacing filter.
• Allow the appliance to cool completely before cleaning or
storing.
• Do not use the appliance for other uses than its intended
use.
• The use of accessories not recommended by the appliance
manufacturer may cause injuries.
• Do not use the appliance outdoors.
• Do not operate an appliance with a damaged DC power
supply (or mains adapter), or in an abnormal state. If the
mains adapter is damaged it must be replaced by the
manufacturer, its service agent, or similarly qualified persons
in order to avoid a hazard.
• Do not continue to operate the appliance if you are in any
doubt about it working normally (e.g. abnormal noise, smell,
smoke), or if it is damaged in any way - switch off, withdraw
the DC power supply (or mains adapter) and contact GVA
customer care for advice.
• Any maintenance and repair must be handled by a
professional technician. Do not try to repair by yourself.
• This appliance should only be used with the power adapter
provided.
5
• Check and ensure the brush is rotating normally during
operation.
• The cord of the mains adapter cannot be replaced; if the
cord is damaged, the mains adapter should be scrapped.
• Make sure all the parts and accessories are properly installed
before use.
6
Unpacking
Cradle for
Handheld Unit
Handheld Unit
Main Body
Nozzle
Handle
Nozzle Tube
Stand with Nozzle Holder
Power Socket Stand
Brush
Instruction
Manual
Mains Adapter
Instruction Manual
* All images in this instruction manual are for indication only; please refer to your individual unit for details.
7
Product Overview
1
2
10
4
3
5
11
6
12
8
13
14
15
7
16
9
8
12. Power Socket Stand
1. Handle Power Button
6. Dust Tank
2. Speed Control Buton
7. Filter
13. Nozzle
3. Main Unit Release Button
8. Brush Release Button
14. Nozzle Tube
4. Main Unit Power Button
(LED indicator)
9. Brush
15. Nozzle Holder
10. Locking Screw
16. Stand
5. Dust Tank Release Button
11. Power Socket
Preparation Before Use
Connecting Handle to Main Body
1.
2. Use a flat head screwdriver to secure the screw.
Installing the Unit Stand
1.
9
2.
3.
Connecting to the Brush
10
Charging the Vacuum Cleaner
1.
2.
Power Socket Stand
Power Socket
Mains Adapter
•
When charging, the red light will illuminate.
•
When charged, the green light will illuminate.
Always unplug from the mains socket when no vacuum cleaner is charging.
11
Operation
• Always unplug from the mains socket when the vacuum cleaner is in use.
• Do not vacuum large objects as they may cause blockage to the brush and
tube/nozzle.
Cleaning as Upright Cleaner
1. Pull the cleaner off the stand. Hold down the stand while pulling the cleaner off the stand.
2. Press the Handle Power Button to turn the vacuum cleaner on or off.
3. Adjust the suction power by pressing the Speed Control Button. There are 2 speed levels.
Cleaning as Handheld Cleaner
1. Press the Main Unit Release Button to release the handheld unit from the cradle.
2. Insert the nozzle (together with the nozzle tube) into the opening of the handheld unit.
You can adjust the nozzle head to use.
3. Press the Main Unit Power Button to turn the vacuum cleaner on or off. Only 1 speed
level is available when using as handheld cleaner.
4. After using, put back the handheld unit into the cradle until a click is heard.
• Steady green LED means the cleaner is operating in full power.
• Flashing green LED means the cleaner is operating in half (or less than half )
power.
12
Cleaning the Dust Tank and Filter
• Always ensure the unit is switched off and unplug from the mains before
emptying or washing the dust tank.
• The dust tank must always be emptied when the dirt level reaches the “MAX” line
on the dust tank to maintain optimum performance. You cannot empty the dust
tank when the cleaner is fully assembled.
• Always make sure the dust tank is completely dry before installing back to the
main unit. A damp dust tank will create electrical hazard.
• Filters should be cleaned regularly to maintain optimum performance.
• Always unplug from the mains socket before cleaning the filters.
• Always make sure the filters are completely dry before installing back. Damp
filters will create electrical hazard.
1. Press the Main Unit Release Button to remove the handheld from the cradle.
13
2. Press the Dust Tank Release Button to remove the dust tank from the handheld unit.
3. Take out the nozzle filter bracket and shroud assembly.
4. Remove the nozzle filter sponge.
Nozzle filter
Nozzle filter sponge
14
5. Throw away the dirt from the dust tank.
6. Wash all of them under water. For the shroud assembly, make sure that no dirt is hidden
inside the valve.
✔
✗
7. Make sure to dry all of them thoroughly before re-assembling.
8. Re-attach the dust tank to the handheld unit until a click is heard.
Cleaning the motor filter
1. Take out the motor filter from the motor body.
2. Wash it under water.
3. Replace only after drying thoroughly.
Motor filter
15
Cleaning the Agitator
• The agitator should be cleaned if worn out to maintain optimum performance.
• Always unplug from the mains socket before cleaning the agitator.
• The agitator shaft collar should be kept clean to maintain proper agitator
rotation.
1. Press the Brush Release Button to remove the brush from the main body.
2. Use a coin or flat head screwdriver to turn the lock to the unlock position.
3. Remove the agitator cover.
4. Take out the agitator. Pull off the agitator shaft collar. You may need to exert more strength
to remove the agitator shaft collar. You can use a flat head screwdriver to pry it off. Remove
any dust or hairs that are tangled. Push back the agitator shaft collar. Put back the agitator.
5. Put back the agitator cover and turn the lock to the lock position.
16
Hints and Tips
Problem
Possible Causes
Remedy
Green and red
LEDs flash together
around 3 times then
switch off.
Battery failure.
Recharge the unit. If still fails,
contact GVA customer care
for advice.
Green and red LEDs
flash alternately
around 3 times then
switch off.
Fault in the unit.
• Over-current during
charging.
• The brush does not move
normally and smoothly
during operation.
• Overloading of the motor.
• Short circuit
• Check if using the correct
mains adapter model.
• Clean the agitator shaft
collar.
• Empty and wash the dust
tank.
• Contact GVA customer care
for advice.
Brush stops rotating
during operation.
• Agitator shaft collar is
dirty.
• Dirt level in the dust
tank exceeds maximum
capacity.
• Filters and shroud
assembly are dirty.
• Clean the agitator shaft
collar.
• Empty and wash the dust
tank.
• Clean the filters and shroud
assembly.
Brush does not
rotate while in
parking position.
This is not a fault.
Specifications
Model
G18SVR16
Voltage (mains adapter)
100﹣240V ~ 50/60Hz
Maximum Dust Tank Capacity
0.15L
Power Adapter Model
YLS0241A-A222050
Battery Model
18650-5S1P
Battery Rating
18V, 2150mAh, 18650 Li-on
Brush Head Rated Voltage
18V DC
We continually strive to improve our products, specifications may change without prior notice.
17
M.E.W. (Australia) Pty Ltd
15 Vaughan Street
Essendon Fields VIC 3041
ACN 152 719 036
1300 725 885
customercare@gvaproducts.com.au
gvaproducts.com.au
While every effort has been made in the preparation of this instruction manual, the publishers
cannot be held responsible for the accuracy of the information contained herein or any
consequences arising from it.
Download PDF
Similar pages