RFI for SSL VPN Gateway Upgrade Project

BASIC SYSTEM REQUIREMENT FOR POE GIGABIT ETHERNET SWITCH
Switch type:
-
10/100/1000 Gigabit PoE switch
-
Switch can be either Layer2 or Layer3
Network Interfaces:
The PoE switch should be able to provide at least 24 x 10/100/1000 Ethernet PoE Interface and
fulfill following network interface requirements
-
At least 4 x 1000 SFP Uplink Interface
-
Uplink interface support 1000BASE-LX SFP
-
Uplink interface support 1000BASE-SX SFP
-
(Optional) Supports at least 2 x 10G SFP+ uplink interface if 10G uplink is provided
-
(Optional) Supports switch stacking/switch virtualization through dedicated interface or
10G Ethernet interfaces
PoE specification:
-
Support IEEE 802.3af
-
Support IEEE 802.3at
-
Support Legacy PoE
-
Total PoE power capacity: Total at least 370 watts or above
Switch performance:
-
40 Gbps forwarding bandwidth or above
-
40 Mbps packet forwarding or above
Basic Layer 2 features:
-
Support hybrid mode port
-
Support 802.1q
-
Support IEEE 802.1D, IEEE 802.1w, IEEE 802.1s
Page 1 of 3
-
Support IEEE 802.1x with RADIUS & LDAP
-
Support RADIUS accounting log features
-
Support MAC authentication
-
Support IEEE 802.1AB (LLDP) for “Device discovery and advertisement”
-
Support IEEE 802.1AB (LLDP) for “Voice VLAN support using LLDP-MED”
-
Support 802.3ad (LACP)
-
Number of link aggregation: 8
-
Number of ports per aggregation: 8
-
Support at least 4096 VLAN
-
MAC addresses capacity: 8,000 or above
-
At least supported Jumbo frames size: 9,198 bytes
-
Spanning tree protocol supporting the following features:
-
Portfast/edge mode
-
Root guard/protection
-
BPDU guard/protection
Multicast features:
-
Multicast routing
-
PIM sparse mode (PIM-SM) / Dense mode
-
IGMP v1/v2
-
IGMP snooping
-
Multicast listener discovery (MLD) v1
Quality Of Service features:
-
Support 802.1p
-
Support DSCP
-
Support IP precedence
-
Support QoS trust (802.1p/DSCP/Auto)
-
Support QoS classification by ACL (L3/L4), user and interface
-
Support egress strict priority queuing
Supporting IP Phone:
-
Detect Cisco IP Phone without the need of IEEE 802.1x authentication, the PC connecting
to the same switch port via the Cisco IP Phone need IEEE 802.1x authentication
Page 2 of 3
Device management and monitoring interface / protocols:
-
Allow Non menu base command line interface (serial, telnet, SSH)
-
Support GUI management interface by HTTP / HTTPs
-
Support SNMP v1, v2c, v3
-
Provide port mirroring features
-
Support remote monitoring (RMON)
Device operating environmental:
-
Operating temperature: 0 ⁰C to 45 ⁰C
-
Storage temperature: 0 ⁰C to 45 ⁰C
-
Operating humidity: 10% to 90%
-
Operating altitude: 1000 meters or above
Page 3 of 3
Download PDF
Similar pages