MATERIAL SAFETY DATA SHEET
I T E M
1 4 0 9 7 5 2
Original Release Date:
0724/08
Issue:
1
Revised Date:
Section I - Company / Product Identity
Product Identification:
Company :
Color “ B_ Black ” - replacement cartridge for HP
LaserJet CP 4005
TG95P6504
HMIS Hazard Rating:
0 = Minimal
3 = Serious
1 = Slight
4 = Severe
2 = Moderate
Turbon International GmbH
Ruhrdeich 10
D-45525 Hattingen
(4005)
NFPA Hazard Rating:
0 = Minimal 3 = Serious
1 = Slight
4 = Extreme
2 = Moderate
Germany
+49-(0)2324-504-471
HMIS Rating :
NFPA Rating :
Telephone:
Health
Health
Fax:
+49-(0)2324-504-133
Flammability = 1
Flammability = 1
Contact Person:
Mr. Rob Aukema
Reactivity
= 0
Instability
= 0
PPE
= Section VIII
Special
= None
= 1
= 1
Section II - Composition / Ingredients
This product consists of new and remanufactured parts that are originally manufactured by the OEM.
The cartridge consists of light sensitive drum, toner , a developer unit and several blades.
Main components:
Plastics:
PE, PP, PS, ABS, PU, Acetal, mixed with FR
Metals:
Iron, Sheet steel. Some components electrolyze nickel-plated.
Non-metals:
Aluminum
Foam:
Expanded polyuthane, polyester base
Elastomer:
Polyurethane
The toner used in this cartridge consists of the following components.
Description
CAS number
Percent
R+S phrase
Symbol
1 - 20
None assigned
None assigned
Silica, amphorphous
Proprietary
Proprietary
<5
None assigned
None assigned
Styrene Acrylate Copolymer
Proprietary
70-95
None assigned
None assigned
Black Pigment
The drum used in this cartridge consists of the following components.
Description
CAS number
Percent
R+S phrase
Symbol
Substrate: Al-cylinder
None assigned
> 99%
None assigned
None assigned
Coating: Organic photoconductor
None assigned
< 1%
None assigned
None assigned
Page 1 of 5
MATERIAL SAFETY DATA SHEET
Section III - Hazards Identification
Primary entry routes:
Inhalation :
Slight irritation of respiratory tract
Ingestion:
NA
Skin contact:
Repeated contact may cause irritation or an allergic skin reaction.
Eyes effects:
Dust may cause irritation by mechanical abrasion
Chronic effects:
If use generates airborne particles, treat as a Nuisance Particulate (ACGIH TLV = 10mg/cu meter)
Potential environmental hazard:
No particular hazards known. The cartridge is made in accordance with all known legal requirements.
Section IV - First Aid Measures
Inhalation:
Remove person to fresh air. If symptom’s persists consult a physician.
Ingestion:
Rinse mouth with water and drink one or two glasses of water. If symptoms occur, call a physician.
If symptom’s persists, consult a physician.
Wash well with soap and running water. If symptoms occur, call a physician.
Skin contact:
Eyes contact:
Immediately flush with large amounts of clean lukewarm, low pressure water for at least 30
minutes. If irritation persists, consult a physician. Remove any contact lenses to facilitate flushing.
Section V - Fire and Explosion Measures
Flash point:
No data available.
Ignition temperature:
No data available.
Flammability
Slight (HMIS, NFPA)
Flammability limits
No data available.
Extinguishing media:
Water Fog, foam, CO , dry chemicals, or halon-type extinguishers.
Special fire fighting procedures:
To avoid inhalation of toxic fumes, wear MHSA/NIOSH approved self-contained breathing
apparatus. Do not release runoff from fire control methods to sewers or waterways.
Toner may cause a dust explosion. Explosive limits of toner particles suspended in air are
equal to coal dust.
Un-usual fire / explosion hazards:
2
Section VI - Accidental Release Measures
Spill and leakage procedures:
Environmental precautions:
Wear personal protective equipment. Avoid breathing dust. Minimize the release of
particles. Vacuum or sweep the material into a bag or other sealed container. If a vacuum
cleaner is used, the motor must be rated as dust tight. Dispose of waste toner in
accordance with local requirements.
Do not discharge into drains.
Section VII - Handling and Storage
Advise on safe handling and protection against fire:
Keep material out of reach of children. Avoid inhalation of dust and contact with eyes. Keep away from excessive heat, sparks
and open flames.
Requirements for storage rooms and advise on storage compatibility:
Keep out of reach of children. Keep container closed and store at room temperature. Keep away from strong oxidizers.
Page 2 of 5
MATERIAL SAFETY DATA SHEET
Section VIII - Exposure Limits / Personal Protection
USA OSHA (TWA) / PEL:
15 mg/m3 (Total Dust)
ACGIH (TWA / TLV)
10 mg/m3 (Inhalable Particulate)
5 mg/m3 (Respirable Fraction)
3 mg/m3 (Respirable Particulate)
DFG (MAK)
6 mg/m3 (Dust Concentration)
In Canada, consult local authorities for acceptable provincial values.
Respiratory protection:
Not required under intended use.
Ventilation:
General ventilation should be sufficient under intended use.
Protective gloves:
Not required under intended use.
Eye protection:
Not required under intended use.
Other protective equipment:
Not required under intended use.
Section IX - Physical and Chemical Properties
Boiling point:
Not applicable
Melting point:
100° -150 Celsius
Particle size:
Fine
Vapor pressure:
NA
Solubility in water:
Negligible
Other Solubility’s:
Partial soluble in Toluene & Xylene
Vapor density ( air =1 )
Heavier than air
Evaporation rate:
Not applicable
Color:
Cyan
Appearance:
Fine powder
Odor:
Faint
o
Section X - Stability and Reactivity
Stability:
Stable under conditions of normal use
Incompatibility:
NA
Hazardous decomposition
products:
Hazardous polymerization:
Combustion will produce carbon dioxide and possibly toxic chemicals such as carbon
monoxide.
Will not occur.
Page 3 of 5
MATERIAL SAFETY DATA SHEET
Section XI - Toxicological Information
Toxicological info according to OSHA Hazard communication standard and commission directive 67/548/EEG.
Toner:
Drum:
Ames test:
Negative. LD50 > 5000 mg/kg
Ingestion:
Not toxic.
Eye contact:
Not toxic.
Skin contact:
Not toxic.
Chronic toxicity:
No data available.
Carcinogenicity:
Not expected to be carcinogenic
Chronic health hazard comments
No known health hazard when used as intended in printer
Exposure limit:
Not known.
Inhalation:
Not toxic.
Ames test:
Ingestion:
Negative. (mutagenicity test from Prof. Ames, Berkeley University California,
USA)
Not toxic.
Eye contact:
Not toxic.
Skin contact:
Not toxic.
Chronic toxicity:
Not toxic.
Carcinogenicity:
Not known.
Chronic health hazard comments
None.
Exposure limit:
Not known.
Inhalation:
Not toxic.
Section XII - Ecological Information
Avoid spills and dispose of in accordance with applicable laws and regulations.
Section XIII - Disposal Considerations
Observe all federal, regional, and local regulations when disposing of the product.
Contact your local Turbon dealer for returning your used and empty cartridges.
Tel: 800 -282-6650
Fax: 800 -257-1619
Section XIV - Transport Information
International transport information:
UN no.:
None
UN shipping name:
None
Hazards class:
None
Packing group:
None
Special precautions:
None
Page 4 of 5
MATERIAL SAFETY DATA SHEET
Section XV - Other Information
New components are purchased from international reputable producers. The information in this MSDS is based on our present
state of knowledge.
In normal use there are no exceptional health, safety or fire hazards associated with this range of products. Please obey the
usage and storage instructions.
This product is distributed, manufactured, and sold by Turbon. IBM, the IBM logo, the IBM trademarks and IBM
Trade Dress are owned by International Business Machines Corporation and are used under a license from IBM.
Disclaimer: Judgements as to the suitability of information herein are the purchaser’s responsibility.
Although reasonable care has been taken in the preparation of such information, The Turbon Group
extends no warranties, makes no representations, and assumes no responsibility as to the accuracy
or suitability of such information for application to the purchaser’s intended purpose or for the
consequences of its use.
Page 5 of 5
Download PDF
Similar pages