G O 6 ’ I N S TA L L AT I O N G U I D E
These components are typical for each corded wireway installation:
TOP CAP
Snaps into bottom track
WIRE MANAGEMENT CLIPS
Secures cabling in wireway
POWER DEVICE
GROMMET
Metal device and
plastic cover
Exits cabling
at wall
BOTTOM TRACK
END CAP
Slots into bottom track at both ends
Secured with set screws
Connectrac GO is ADA compliant.
However, it is not recommended for high-traffic areas.
Q U E S T I O N S ? C A L L U S AT 8 7 7 . 4 8 0 . 5 6 3 7 !
C ON NECTRAC GO INSTAL L AT IO N
(0 9 0 5 2 0 1 7 ) 1
C O NN ECTRA C.CO M
I N S TA L L AT I O N B A S I C S
ATTACH END CAPS
PASS CABLING THROUGH GROMMET
Flip the track and tighten the set screws.
Then snap the grommet into the track at the wall.
Upside-down
track
You can use double-sided or friction tape,
or fasten the track to the floor
depending on your application.
MOUNT POWER DEVICE
INSTALL TOP CAP
Install the small piece of top cap at the end of the track,
then slide the device under it.
Manage cabling with included metal clips,
then install the longer piece of top cap.
Mount the device with included double-sided tape.
C ON NECTRAC GO INSTAL L AT IO N
(0 9 0 5 2 0 1 7 ) 2
C O NN ECTRA C.CO M
IN STALL T HE COVER
Terminate any data cabling in the included modules, or leave open to pass cabling through.
Snap the trim skirt into the bottom of the device cover - attach the plastic cover to the device,
T HEN GO!
TELECOM MODULES
DEVICE COVER
TRIM SKIRT
POWER DEVICE
DEVICE INFORMATION
NAME:
Connectrac GO Duplex Receptacle
DESCRIPTION:
The GO power receptacle is a pre-wired outlet device. The wiring system contains a 3-wire / single-circuit system, and the metal housing contains (2) NEMA
5-15R receptacles. It includes a plastic cover which incorporates a modular
telecom opening capable of mounting (4) keystone connectors.
ELECTRICAL
LISTING:
US: This device has been tested to UL Subject 962A standards and listed by ETL
/ Intertek. The device is identified with the ETL Listed Mark.
Canada: This device has been tested to CAN/CSA 22.2 #21 and is listed by
ETL / Intertek. The device is identified with the cETL Listed Mark.
C ON NECTRAC GO INSTAL L AT IO N
(0 9 0 5 2 0 1 7 ) 3
C O NN ECTRA C.CO M
G O 1 2 ’ I N S TA L L AT I O N T I P S
USE INCLUDED COUPLERS
FASTEN IT DOWN
Insert as shown, then tighten set screws.
This is necessary when combining tracks.
These help align the bottom tracks.
Use grooves on either
side to stagger screws
TIP!
Leave room for
electrical device
STAGGER BOTTOM TRACK
AND TOP CAP
CAN BE TRIMMED TO LENGTH
The wireway can be trimmed if you need
Offset the bottom track joint from the top cap joint.
a different length.
This helps strengthen the assembly.
Stagger
joint
CON NECTRAC GO IN STALL AT IO N
(0 9 0 5 2 0 1 7 )
4
CO NNECTRA C.CO M
Download PDF
Similar pages