4 Ports 60W per Port Power over Ethernet Ultra PoE Midspan

WWW.PHIHONG.COM
4 Ports 60W per Port Power over Ethernet
Ultra PoE Midspan
Features
• Fully Compliant Detection,
Disconnect and Voltage Control
IEEE802.3af
• Proprietary Detection, Disconnect and
Overload Protection
• Full Protection OCP, OVP
• Optional Mounting Kit for 19” Rack
Applications
• LCD Displays
• Wireless Access Points
• High Power Radios
Safety Approvals
• cUL/UL
Mechanical Characteristics
• Length: 224.9mm (8.85in)
• Width: 200mm (7.87in)
Output Specifications
•
•
Limited Power Source
Gigabit Compatible
•
•
•
•
Diagnostic LEDs
SNMP Management
Full Power at 60W per port
1 Year Warranty
•
•
Computer Stations
Kiosks
•
CE
•
•
Height: 48.5 mm (1.91in)
Weight: 1.59Kg (3.5lbs)
Model
POE240U-4UP-N
Number of Ports
4
Optional 19” Rack mounting adapter to mount 1 POE125U or 2 side by side; order P/N POE125U-ACCY01
Reference files:
1. SNMPv2c_User_Manual-Rev1.7.pdf
2. SNMPv2c_Firmware-Rev1.7.zip
3. SNMPv2c_MIB_10_30_2009.zip
Phihong is not responsible for any error, and reserves the right to make changes without notice. Please visit our website at www.phihong.com for
the most up-to-date specifications and contact information.
Revision 1/10/2018
POE240U-4UPN Characteristics
INPUT:
AC Input Voltage Range
90 to 264VAC
Input Frequency
47-63Hz
Input Current
5A (RMS) max for 90VAC
2.5A (RMS) max for 230VAC
Leakage Current
3.5mA max at 254VAC 60Hz
AC Inrush Current
30A (RMS) max for 115VAC
60A (RMS) max for 230VAC
OUTPUT:
Total Output Power
60W per port at 56V+1/-2
Total power on all ports 240W
Ripple and Regulation
250mV max
Efficiency
75% (typical) at max load,120VAC 60Hz
Hold-up Time
10mS min. 120VAC and max load
Transient O/P Voltage Protection
60V max at switch on/off at any AC line Phase
Turn-On Delay Time
20 sec max at max load,120VAC 60Hz, 25Hz
ENVIRONMENTAL:
Temperature
Operation
0 to +40°C
Non-operation
-25 to +65°C
Humidity
5 to 90%
WWW.PHIHONG.COM
EMC
EN55022 Radiate Class A
EN55022 Conducted Class B
Isolation Test
Primary to Secondary: 4242VDC for 1 minute
Primary to Ground: 2121VDC for 1 minute
Secondary to Ground: 2121VDC for 1 minute
Insulation Resistance
Primary to Secondary: >10M OHM 500VDC
Primary to Field Ground: >10M OHM
500VDC
Immunity EN50082-1
ESD:
EN61000-4-2. Level 3
RS:
EN61000-4-3. Level 2
EFT:
EN61000-4-4. Level 2
Surge:
EN61000-4-5. Level 3
CS:
EN61000-4-6. Level 2
Voltage Dips EN61000-4-11
Harmonic:
EN61000-3-2 Class A
IEEE 802.3af Interoperability
If 25kohm is detected the unit operates in
“IEEE802.3at mode” 33.6W 2 pair powering.
12.5k detection resistance required for full
power
UNH Interoperability report available on
request
FEATURE:
Cisco Legacy detection
No extern parts required for Legacy devices:
VoIP Phones:
7910, 7912, 7940, 7960
Access Points:
350, 1100, 1200, 1250
Over Voltage/Current Protections
Outputs equipped with short circuit protection
and overload protection as per 802.3af
specifications except for max average current
is 1.69A
Short Circuit Protection
The output can be shorted permanently
without damage
Output Connection
4-pair powering for full power
Pins 3,6, 4,5(+) Pins 1,2, 7,8 (-)
Over Temperature Protection
Automatic Shutdown without damage
2-pair powering for IEEE802.3at mode
Pins 3,6(+) Pins 1,2 (-)
Indicators
Green LED: Power detected “CONNECT” at
60W
Flashing GREEN: IEEE802.3at detected
“CONNECT” at 30W
Yellow LED: Fault detected
Warranty
1 Year
Input Connector
AC Input IEC320 3 pin
POE240U-4UPN Dimension Diagram (mm)
Façade Display Showing Optional Rack Mounting
WWW.PHIHONG.COM
Download PDF
Similar pages