WIRING DIAGRAM
Connect to
12 Volt Ignition
RED WIRE
BLACK WIRE
BLUE WIRE
GREEN WIRE
SV-800.CSB
CONTROL BOX
Ground
Front Camera
Control
No Connection
Yellow RCA (Rear Camera)
RED Power Plug
Power Plug
Front
Camera
Reverse Light
Ground
Yellow RCA
Video Plug
Video Out
(Connect to montior)
Reverse Camera
MAIN CONTROL WIRES
1.
Connect the RED wire of the control box to positive 12 volts Ignition power.
2.
Connect the BLACK wire of the control box to chassis ground.
3.
The BLUE wire controls the turn-on for the front camera. Connect this wire to the positive 12 volt ignition source in the
vehicle to activate the front camera constantly as long as the ignition is on. You may need to install a toggle switch on this
wire to turn the camera on and off
4.
Leave the GREEN wire disconnected
VIDEO PLUGS
1.
Connect the “Back Camera” Yellow RCA to the reverse camera video output. This input is activated automatically when the
reverse camera is powered on and will stay active unit the reverse camera shuts off. This video input takes priority over the
front camera input so it will automatically switch on when the reverse camera comes on.
2.
Connect the “Front Camera” Yellow RCA to the front camera video output. This input is activated when the BLUE wire is
powered by turning the key on. The front camera is the constantly activated as long as the ignition is on and you may need a
toggle switch on the BLUE wire to switch the camera on and off. This camera input will automatically shut off when the
reverse camera is activated and will turn back on when the reverse camera is shut off.
3.
The RED plug is a 12 volt power supply plug for the front reverse camera
4.
The “Video Out” Yellow RCA connects to the video input of your monitor
Download PDF
Similar pages