Instruction Manual
AVT-3320
Analog Video to UXGA Scaler
Table of Contents
1.0
Introduction
2
2.0
Specifications
4
3.0
Checking Package Contents
5
4.0
Connecting the Hardware
5
5.0
Operating The Unit
6
6.0
Troubleshooting
6
7.0
Limited Warranty
7
8.0
Regulatory Compliance
8
9.0
Contact Information
9
1.0
INTRODUCTION
Thanks for purchasing this product from the AV Toolbox Division of TV One. The
AVT-3320 Analog Video to UXGA Scaler is designed to convert interlaced NTSC
or PAL Video––S-Video or Composite Video format––to XGA, SXGA or UXGA
resolutions which allows the viewing of standard television images on your PC
monitor. This is but one of our complete range of video and audio products.
1.1
Liability Statement
Every effort has been made to ensure that this product is free of errors. TV One
cannot be held liable for the use of this hardware or any direct or indirect
consequential damages arising from its use. It is the responsibility of the user of
the hardware to check that it is suitable for his/her requirements and that it is
installed correctly. All rights reserved. No parts of this manual may be
reproduced or transmitted by any form or means electronic or mechanical,
including photocopying, recording or by any information storage or retrieval
system without the written consent of the publisher.
TV One reserves the right to revise any of its hardware and software following its
policy to modify and/or improve its products where necessary or desirable. This
statement does not affect the legal rights of the user in any way.
All third party trademarks and copyrights are recognised. The TV One logo, AV
Toolbox logo, TV One-task and CORIO are the registered Trademarks of TV
One. All other trademarks are the property of their respective holders.
1.2
Features







Automatically detects either NTSC or PAL Television Inputs.
Either Composite or S-Video (Y/C) Inputs
High Res PC Video outputs: XGA, SXGA, UXGA
3 Years Parts and Labor Warranty
Light Weight – Less than 1.2 pound
Ergonomically Friendly Design
Small, palm size footprint
2
1.3
Getting the Best Results
There are many factors affecting the quality of results when scaling video signals.
Some basic precautions will ensure the best possible performance from your Up
Converter.
 Output display device – The quality of the output signal will depend
largely upon the type and quality of display device used. For instance,
some video projectors just look better than others.
 Distance between the Up Converter and the display device – This
plays a major role in the final result. Long distances are possible, but
special measures should be taken in order to avoid cable losses.
These include using high quality cables. Line amplifiers may also be
necessary.
 Input/Output connection cables – Low quality cables are susceptible
to interference. They degrade signal quality due to poor matching and
cause elevated noise levels. Therefore, cables should be of the best
quality. Coax-type computer cables are recommended because of
their superior internal shielding characteristics.
 Interference from nearby electrical devices – These can have an
adverse effect on signal quality. For example, an older computer
monitor often emits very high electromagnetic fields that can interfere
with the performance of video equipment in its proximity.
3
2.0
SPECIFICATIONS
Supported Inputs
Input Connectors
Input Signal Types
Supported Output
Output Connector
Signal Characteristics
Input Types
Input Formats
Output Format
Output Signal Type
Human Interface
Device Control
Environmental
Operating Temperature
Operating Humidity
Storage Temperature
Storage Humidity
Warranty
Limited Warranty
Regulatory Approvals
Main Unit
Power Supply
Mechanical
Dimensions–HxWxD
Weight
Power Requirement
External Power Supply
Accessories Included
1x Power Adapter
1x User Manual
Model Number
AVT-3320
1x RCA, 1x S-Video Connector
Composite Video or S-Video
HD-15 VGA
PAL or NTSC Analog Video
480i or 576i
Analog PC Video
XGA, SXGA, UXGA
Via Top Mounted Buttons
0° to +40° C (+32° to +104° F)
20% to 90%, Non-condensing
-10° to +60° C (+14° to +140° F)
20% to 90%, Non-condensing
1 Year Parts and Labor
FCC, CE, RoHS
UL, CUL, CE, PSE, GS, RoHS
0.9”x3.9”x2.5” (24x100x64mm)
0.44lbs (200g)
100~240VAC to 5VDC Adapter
US, UK or Euro
AVT-3320 Analog Video to UXGA Scaler
4
3.0
CHECKING PACKAGE CONTENTS
Before attempting to use this unit, please check the packaging and make certain
the following items are contained in the shipping carton:
 1x AVT-3320 Video to PC Up Converter
 1x 100~240VAC to 5VDC Power Adapter
 1x User Manual
Note: Please retain the original packing material should the need ever arise to
return the unit. If you find any items are missing, contact your reseller or TV One
immediately. Have the Model Number, Serial Number and Invoice available for
reference when you call.
4.0
CONNECTING THE HARDWARE
The first step is to connect a Video Source to the input of the AVT-3320 Analog
Video to UXGA Scaler, connect its output to a PC monitor and lastly connect the
AC to DC Power Adapter. The drawings below show the locations of the input,
outputs, power switch and power connector.
The Input Select
Switch and Input
Indicator LED are
located on the top
of the unit.
The input side of the AVT3320 is where the Composite Video, S-Video and
the 5VDC Power Adapter
connectors are located.
The output side of the
AVT-3320 is where the
HD-15 PC Video
connector and the Output
Resolution Switch are
located.
5
4.1
Connecting the Monitor to the AVT-3320
To make certain your monitor is working properly, check that a PC can produce a
picture on it before attempting to use it with the AVT-3320 then connect the
monitor to the output of the AVT-3320 using a high quality cable.
Note: If you do not know the maximum resolution that your monitor is capable of
accepting, set the AVT-3320 to XGA resolution using the three position switch
located on the output side of the unit initially.
4.2
Connecting the Input to the AVT-3320
You can connect either a NTSC or a PAL input signal to the AVT-3320. The unit
will automatically determine which type signal it is receiving. For the signal cable
type, you’ll want to use S-Video if possible because it will produce the best
picture in most cases. With either input always use a high quality cable, as short
a length as possible, for best results.
4.3
Connecting Power to the AVT-3320
The AVT-3320 is shipped with a Power Adapter to convert 100~240VAC@5060Hz to 5VDC. Connect the DC Output Cable from the Power Adapter to the
back of the unit and then plug the Power Adapter into an AC Receptacle. The
AVT-3320 has no power switch. As soon as the Power Adaptor is connected, the
unit is receiving power.
5.0
OPERATING THE AVT-3320
Once the AVT-3320 is connected to a monitor and an appropriate input signal is
connected, you can apply power. If you have connected a Composite Video
signal to the AVT-3320, press the input switch on the top of the unit until the LED
indicator turns Green. If you have connected an S-Video (Y/C) signal, press the
input switch until the LED indicator turns Orange. The unit will automatically
determine if the input signal is NTSC or PAL format. As previously noted, unless
you know for certain that your monitor will accept one of the available higher
resolutions, you should start with the lowest resolution by moving the Output
Resolution switch on the side of the unit to the XGA position. Once you have an
XGA image on the monitor, you can then experiment with the higher resolutions
to improve the image quality.
6.0
TROUBLESHOOTING
Other than checking for faulty cables, the only common problem would be
choosing a resolution setting that your monitor does not support. Make certain
you have a good NTSC/PAL input signal and the Power Adapter is securely
plugged in both to the AC receptacle and to the AVT-3320.
6
After trying the above suggestions sh ould the problem still persist, contact your
dealer for additional suggestions before contacting TV One. Should the dealer’s
technical personnel be unable to assist you, contact TV One via our support
website: http://tvone.crmdesk.com. Create a technical support request on the
site and our support team will respond within a short period of time.
7.0
LIMITED WARRANTY
LIMITED WARRANTY – With the exceptions noted in the next paragraph, AV
Toolbox warrants the original purchaser that the equipment it manufactures or
sells will be free from defects in materials and workmanship for a period of one
year from the date of purchase. Should this product, in AV Toolbox’s opinion,
prove defective within this warranty period, AV Toolbox, at its option, will repair or
replace this product without charge. Any defective parts replaced become the
property of AV Toolbox. This warranty does not apply to those products which
have been damaged due to accident, unauthorized alterations, improper repair,
modifications, inadequate maintenance and care, or use in any manner for which
the product was not originally intended.
Items integrated into AV Toolbox products that are made by other manufacturers,
notably computer hard drives and liquid crystal display panels, are limited to the
term of the warranty offered by the respective manufacturers. Such specific
warranties are available upon request to AV Toolbox. If repairs are necessary
under this warranty policy, the original purchaser must obtain a Return
Authorization Number from AV Toolbox and return the product to a location
designated by AV Toolbox, freight prepaid. After repairs are complete, the
product will be returned, freight prepaid.
LIMITATIONS - All products sold are "as is" and the above Limited Warranty is
in lieu of all other warranties for this product, expressed or implied, and is strictly
limited to one year from the date of purchase. AV Toolbox assumes no liability to
distributors, resellers or end-users or any third parties for any loss of use,
revenue or profit.
AV Toolbox makes no other representation of warranty as to fitness for the
purpose or merchantability or otherwise in respect of any of the products sold.
The liability of AV Toolbox with respect to any defective products will be limited to
the repair or replacement of such products. In no event shall AV Toolbox be
responsible or liable for any damage arising from the use of such defective
products whether such damages be direct, indirect, consequential or otherwise,
and whether such damages are incurred by the reseller, end-user or any third
party.
7
8.0 REGULATORY COMPLIANCE
The AVT-3320 has been tested for compliance with appropriate FCC and CE
rules and regulations. The Power Adaptor/Supplies have been tested for
compliance with appropriate UL, CUL, CE, PSE, GS Rules, Regulations and/or
Guidelines. These Products and Power Adapters are RoHS Compliant.
9.0
CONTACT INFORMATION
Should you have questions or require assistance with this product in areas not
covered by this manual, please contact TV One at the appropriate location.
AV Toolbox USA
2791 Circleport Drive
Erlanger, KY 41018
USA
Tel 800-235-3280
Tel 859-647-1077
Fax 859-282-8225
sales@avtoobox.com
www.avtoolbox.com
AV Toolbox Europe
Continental Approach
Westwood Industrial Estate
Margate, Kent CT9 4JG, UK
Tel +44 (0)1843 873307
Fax +44 (0)1843 873312
sales.europe@avtoolbox.com
www.avtoolbox.com
AV Toolbox Latin America
6991 NW 82nd Avenue #8
Miami, FL 33166
USA
Tel 305-396-6275
Fax 305-418-9306
sales.latinoamerica@tvone.com
www.tvonela.com
AV Toolbox Mercosur
Av. Diaz Velez 3965 #PB
(1200) Capital Federal
Buenos Aires, Argentina
Tel +54 11 5917-2525
Fax +54 11 4032-0281
sales.mercosur@tvone.com
www.tvonela.com
AV Toolbox Asia
16F-4, No.75, Sec.1
Hsin Tai Wu Rd., Hsichih
Taipei Hsien 22101
Taiwan R.O.C.
Tel +886 2 2698-2296
Fax +886 2 2698-2297
sales.asia@tvone.com
www.tvoneasia.com
AV Toolbox China
Room 1007, Golden Peach Building
No. 1900 Shangcheng Road
Pudong, Shanghai
China 200120
Tel +86 21 5830-2960
Fax +86 21 5851-7949
sales.china@tvone.com
www.tvoneasia.com
End of Manual
8
Download PDF
Similar pages