Mood lighting starter kit Instructions

Mood lighting starter kit Instructions
Contents
Flexible LED strip
Remote control
LED controller
12V power supply
Preparation
Always thoroughly clean and then dry the surface to which the strip is
being attached – even if it is new. The LED strip can be cut down to
size if required using a sharp knife. The cut points are shown here :
↑
cut
When cutting the strip, press down hard on the blade with a ‘rocking’ action – do not use a ‘sawing’ action as this can
damage the strip.
Fitting the LED strip (*see note below)
Place the strip on the cleaned surface and slowly peel back the backing tape whilst feeding the tape in position. To
bend the strip through a right angle, bend in 3 or 4 places rather than in 1 position, thus avoiding bending the strip
through acute angles at any one point. Once in place, press the strip firmly along the length, except at the bend
points.
Positioning
The domed Infra Red sensor on the LED controller (see right) must be visible, or almost
visible to the remote control in order to achieve an acceptable range. Hence the LED
controller should be positioned such that the sensor dome faces the remote control.
Connecting up
Connect the LED strip to the LED controller output connector as follows.
Align the arrow on the LED controller connector with the white (or black)
wire of the LED strip as shown on the right.
Then connect the power jack from the 12V power supply into the LED
controller power socket as indicated in the diagram on the right.
The final step is simply to plug the 12V power supply into a wall socket.
*Important Note
If the LED strip is to be attached to the rear of a TV, please ensure that the strip does not cover any ventilation holes.
Remote control functions
There are 16 pre-defined colour buttons including white
Button
Function
OFF
Switches the lighting off (standby mode)
ON
Switches the lighting on
Increases the brightness/speed
Decreases the brightness/speed
Flash
6-colour jump mode, speed adjustable using brightness up/down buttons
Strobe
White fade in -fade out, speed adjustable using brightness up/down buttons
Fade
Smooth colour fade mode, speed adjustable using brightness up/down buttons
Smooth
3-colour jump mode, speed adjustable using brightness up/down buttons
Download PDF
Similar pages