Phone Adapter 2
Installation Guide
User Guide
www.sonici.com
03
Table of Contents
General Warnings
7
Introduction9
Phone Adapter 2 Overview
10
Installation11
Activating the Phone Adapter 2
for the First Time
12
Setting Up the Phone Adapter 2
13
Pairing SoundGate with the Phone Adapter 2
16
Instructions for Use19
Additional Information
24
Visual Indicators
25
Technical Information
26
Information and Explanation of Symbols
31
Service32
04
05
Congratulations on the purchase of your
new Phone Adapter 2 wireless accessory.
Your Phone Adapter 2 is intended to be used
together with Sonic SoundGate devices and
Sonic hearing instruments. This enables
you to communicate wirelessly with a phone
conversation partner via a landline phone
(analogue/PSTN). Great care and attention
has been paid to ensure that your device
has the highest quality and is easy to use
and maintain.
Please read the entire contents of this booklet before
using your Phone Adapter 2. It contains instructions
and important information about its use and handling.
06
07
General Warnings
Familiarize yourself with the following general
warnings before using your Phone Adapter 2.
Products to be connected to external equipment
The safety of the use of the Phone Adapter 2
with the auxiliary input cable is determined by
the external signal source. When the input cable
is connected to mains-operated equipment,
this equipment must comply with IEC-60065,
IEC-60601, IEC-60950, or equivalent safety
standards.
The Phone Adapter 2 is designed to comply
with the most stringent Standards of International
Electromagnetic Compatibility. However,
the Phone Adapter 2 may cause interference
with other medical devices. Please contact
relevant personnel to obtain permission before
using the Phone Adapter 2 in hospitals
or similar venues.
08
The Phone Adapter 2 is not a toy and therefore
should be kept out of the reach of children
or anyone else who might swallow parts or
otherwise cause injury to themselves. Special
attention should be paid to smaller components
in order to prevent children from swallowing
them and choking. If a part is swallowed, see
a doctor immediately.
The Phone Adapter 2 is intended for residential
use with an analog phone line. The Phone
Adapter 2 is not intended for use with digital
phones that may be part of a digital/commercial
system. Unintended use with a digital phone
system may result in lack of functionality,
malfunction or damage to the Phone Adapter 2
and will invalidate the warranty. If you are unsure
of the type of phone system in use in your home,
or at your workplace, we recommend that
you contact your local phone company before
installing the Phone Adapter 2.
09
Introduction
The following items are included within your Phone
Adapter 2 package and will be covered within this
instruction guide:
Phone Adapter 2
Model: BS-H200
Phone Adapter 2
Installation Guide
User Guide
Power adapter
www.sonici.com
5
SN2_ILLU_Charger_HI
40
Standard
analog phone cable
SN2_ILLU_NewPhoneCableToOut_BW_HI
Installation Guide
and User Guide
10
Phone Adapter 2 Overview
1
2
SN2_ILLU_PhoneAdapter_backside_BW_HI
3
4
5
1 Power indicator
2 Status indicator
3 Power input
6
4 AUX input*
5 Phone “IN“ connector
6 Phone “OUT“ connector
* For a wireless headset connection to digital office phones using the Phone Adapter 2 Office Phone Kit. For further information,
please ask your hearing care provider.
11
INSTALLATION
12
Activating the Phone Adapter 2
for the First Time
Before using with your landline telephone, the Phone
Adapter 2 must be connected to a power outlet and
an active landline telephone.
The following pages offer easy step-by-step
instructions on how to install and operate your
Phone Adapter 2 device.
13
Setting Up the Phone Adapter 2
Ensure the Phone Adapter 2 is connected to a power
outlet using the power adapter included in the
Phone Adapter 2 packaging. The power indicator on
the Phone Adapter 2 will illuminate green when
power is connected.
14
Remove the telephone cable from an active landline
telephone (or base station).*
Insert the telephone cable removed from the landline
phone38
into the Phone “IN” connector of the Phone
Adapter 2.
SN2_ILLU_RemovePhoneCableFromPhone_BW_HI
SN2_ILLU_InsertPhoneCableToAdapterIn_BW_HI
15
Insert one end of the standard analog phone cable
included in the Phone Adapter 2 packaging into
the Phone “OUT” connector of the Phone Adapter 2.
Insert the opposite end of the same standard analog
phone cable into the landline telephone (or base
station).*
Lift the handset from your landline phone. You should
now be able to hear the dial tone from the handset
speaker.
* If your telephone or base station does not have a detachable
plug for the landline connection, you should either try using
an alternative phone or a technician must be contacted to complete this installation.
16
Pairing SoundGate with the Phone Adapter 2
Phone Adapter 2 may be used with all versions
of SoundGate. Please follow the instructions below,
specific to the version of your SoundGate.
SoundGate 2
SoundGate
SN2_ILLU_SoundgateProfile_HI
Note!
Pairing is done only once and will normally
not have to be repeated.
17
Pairing with SoundGate 2
Ensure the Phone Adapter 2 is connected to a power
outlet and the SoundGate 2 battery is charged and
powered ON. The power indicator on the Phone
Adapter 2 and the SoundGate 2 should be illuminated
green.
1. Press and hold the SoundGate 2 power key for
5 – 6 seconds until the SoundGate 2 status indicator
starts flashing blue rapidly.
2.Place the SoundGate 2 on top of the
Phone Adapter 2 – the pairing can take up
to 60 seconds. The pairing is completed
when the Phone Adapter 2 power indicator
turns stable blue.
30
SN2_ILLU_TopLedFlashingBlue_HI
18
Pairing with SoundGate
Ensure the Phone Adapter 2 is connected to a power
outlet and the SoundGate battery is charged and
the key lock is in the unlocked (green) position.
The power indicator on the Phone Adapter 2 should
be illuminated green.
1. Press and hold the Bluetooth® key for 6 – 8 seconds
until the blue light flashes rapidly.
2.Place the SoundGate on top of the
Phone Adapter 2 – the pairing can take up
to 60 seconds. The pairing is completed
when the Phone Adapter 2 power indicator
turns stable blue.
19
INSTRUCTION FOR USE
20
For optimal use with the Phone Adapter 2, ensure
the SoundGate is worn with the neck strap antenna
and that the hearing instruments are powered on.
Make a phone call
1. Press the SoundGate phone key. You will hear
a dial tone in the hearing instruments and
the SoundGate phone key will illuminate green.
The Phone Adapter 2 status indicator will also
be illuminated green while streaming a call.
2.Pick up the handset from your landline phone
and dial a phone number. Then return the handset
to the landline phone cradle. You will now hear
the call tone.
3. When the other party answers the call, the phone
conversation can begin. To ensure optimal sound
quality for the person you are speaking with, it is
recommended to wear your neck loop and position
the SoundGate microphone 4–12 inches (10–30 cm)
from your mouth.
12 Inch
30 cm
21
21
SN2_ILLU_MouthToMicrophone_HI
4.To end the phone call at any time, press
the SoundGate phone key. The phone key on
the SoundGate and the phone indicator on
the Phone Adapter 2 will no longer illuminate
and the previous listening program will
resume in the hearing instruments.
22
Answer a phone call
1. You will hear a call tone in your hearing instruments
when your landline telephone receives an incoming
call. The phone indicator on the Phone Adapter 2
and the phone key on the SoundGate will blink
green.
2.Press the SoundGate phone key to accept the call.
The SoundGate phone key and the Phone Adapter 2
status indicator will illuminate green.
3. The call is now directed to the hearing instruments
and the phone conversation can begin. To ensure
optimal sound quality for the person you are
speaking with, it is recommended to wear your
neck loop and position the SoundGate microphone
4–12 inches (10–30 cm) from your mouth.
Note!
For SoundGate 2 only
If you wish to reject the incoming call,
simply press and hold the volume down key
on the SoundGate 2 for 2 – 3 seconds.
23
4.To end the phone call at any time, press
the SoundGate phone key. The phone key on
the SoundGate and the phone indicator on
the Phone Adapter 2 will no longer illuminate
and the previous listening program will
resume in the hearing instruments.
24
Additional Information
Turn off the Phone Adapter 2
If you do not wish to receive calls to your SoundGate,
turn off the Phone Adapter 2 by disconnecting
the power adapter. For normal use, the Phone
Adapter 2 uses very little power so it is not necessary
to turn it off.
Range
The Phone Adapter 2 has a range of up to around
98 feet (30 meters) to your SoundGate 2, depending
on furniture and walls between the devices.
24
SN2_ILLU_GreenLedFlashing_HI
SN2_ILLU_GreenLed_HI
SoundGate 2
top status
14
27
25
12
SoundGate
front status
When the call is initiated,
you will hear a short
beep to indicate the
connection to your
hearing instruments.
Phone ringing. You will
hear an incoming call
tone in your hearing
instruments.
SoundGate and Phone
Adapter 2 connected.
No active phone call.
Description
25
Visual Indicators
Phone Adapter 2
SoundGate 2
front status
SN2_ILLU_SoundgatePhoneKeyGreenFlash_HI
SN2_ILLU_SoundgatePhoneKeyGreen_HI
SN2_ILLU_SoundgatePhoneKeyNoLight_HI
26
Technical Information
Due to the limited size available on the device, many
of the relevant approval markings are found in this
document.
The emission power from the Phone Adapter 2 is max.
39 dBμV/m @ 3 meters and is well below international
emission limits for Human Exposure. The Phone
Adapter 2 complies with international standards
concerning Electromagnetic Compatibility.
This instrument contains a module with:
FCC ID UXZBSH200
IC: 8191A-BSH200
The device complies with Part 15 of the FCC rules
and RSS-210 of Industry Canada.
27
FCC Statement
Operation is subject to the following two ­conditions:
1. This device may not cause harmful interference.
2.This device must accept any interference received,
including interference that may cause undesired
operation.
To comply with FCC RF exposure requirements,
the device and the antenna for this device must
be installed to ensure a minimum separation
distance of 20 cm or more from a person’s body.
Other operating configurations should be avoided.
Note!
This
equipment has been tested and found
to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide
reasonable protection against harmful
interference in a residential installation.
This equipment can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may
cause harmful interference to radio
communications. However, there is no
guarantee that interference will not occur
in a particular installation.
28
If this equipment does cause harmful interference
to radio or television reception, which can be
determined by turning the equipment off and on,
the user is encouraged to try to correct the
interference by one or more of the following
measures:
·· Reorient or relocate the receiving antenna.
·· Increase the separation between the equipment
and receiver.
·· Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
·· Consult the dealer or an experienced radio/TV
technician for help.
IC Statement
Operation is subject to the following two c­ onditions:
1. This device may not cause interference.
2.This device must accept any interference, including
interference that may cause undesired operation
of the device.
29
This equipment complies with IC radiation exposure
limits set forth for an uncontrolled environment.
End users must follow the specific operating
instructions for satisfying RF exposure compliance.
This transmitter must not be co-located or ­operating
in conjunction with any other antenna
or transmitter.
Changes or modifications not expressly approved
by the party responsible for compliance could void
the user’s authority to operate the equipment.
30
This Phone Adapter 2 (model BS-H200) is in
compliance with the essential requirements
and other relevant provisions of Directive 1999/5/EC.
Declaration of conformity is available at:
Sonic Innovations, Inc.
2501 Cottontail Lane
Somerset, NJ 08873
USA
This product is intended for connection to
the public switched analogue telephone network
and may be operated in EU and EFTA countries.
31
Information and Explanation of Symbols
The CE conformity marking indicates
conformance to all applicable
European Directives
This symbol indicates that it is
important for the user to read
and take into account the relevant
information in these instructions
for use
This sign indicates important safety
information that must be observed
to minimize risks or to avoid
hazardous situations
Important information for handling
and product safety
The crossed-out wheeled bin
indicates that the European Directive
on waste of electronic equipment
applies
32
Service
If the information listed on the previous pages
did not solve a problem you are having with your
Phone Adapter 2 device, please contact your
hearing care professional. Do not attempt
to repair your Phone Adapter 2 device yourself.
Place stamp with dispenser name and address here:
33
Notes
34
Notes
135453 | UK
Distributed by
World Headquarters
Sonic Innovations, Inc.
2501 Cottontail Lane
Somerset, NJ 08873 USA
+ 1 888 423 7834
International
Sonic AG
Morgenstrasse 131B
3018 Bern, Switzerland
+ 41 31 560 21 21
Australia
Sonic Innovations Pty Ltd
Wholesale & Equipment Division
629 Nudgee Road
Nundah QLD 4012
+ 61 7 3250 0369
Canada
Sonic Innovations Canada Ltd.
2885-B le Corbusier Blvd
Laval, Québec H7L 4J5
+ 1 800 667 7664
11.13 | 139500 | UK
www.sonici.com
Download PDF
Similar pages