LG CD-3230A Owner’s Manual

CD/RADIO
CASSETTE RECORDER
Owner's Manual
MODEL
:
CD-3230A
Please read this manual
carefully
(AM/FM)
before
operating your
set.
WARNING
To avoid electrical shock; do not open the cabinet. Refer
servicing
to
qualified personnel only.
Shock Hazard
-
IMPORTANT
The wires in this mains lead
do not open.
with the
CAUTION
Use of controls
procedures
or
other
adjustments or performance of
than those specified herein may
are
coloured in accordance
codes:
following
Blue
:
Neutral
Brown
:
Live
As the colours of the wires in the mains lead of this
result
in hazardous radiation exposure.
appliance may not correspond with the coloured
markings identifying the terminals in your plug, proceed
as
This class B
digital apparatus meets all requirements
the Canadian Interference Causing Equipment
Regulations.
of
follows:
The wire which is coloured brown must be connected to
the terminal which is marked with the letter L
-
or
coloured
red.
The wire which is coloured blue must be connected to
For the customers in
the terminal which is marked with the letter N
Europe
Laser component in this product is capable of
radiation exceeding the limit for Class 1.
CLASS 1 LASER PRODUCT
KLASSE 1 LASER PRODUKT
LUOKAN 1 LASER LAITE
This
Compact
as a
CLASS 1 LASER
Disc
emitting
a
is used,
a
player is classified
product.
KLASS 1 LASER APPARAT
The CLASS 1 LASER PRODUCT
label is located
3 amp BS1363
3 amp BS1362
either in the
Warning:
CLASSE 1 PRODUIT LASER
on
black. If
plug
or
coloured
or
plug or any other type of plug
approved fuse must be fitted
at the distribution board.
do not connect either wire to the earth
marked with the letter E
coloured green
or
with the earth
or
green and
pin,
symbol
or
yellow.
the exterior.
WARNING
This label is
CAUTION:INVISIBLE LASER RADIATION WHEN OPEN AND
INTERLOCKS DEFEATED. AVOID EXPOSURE TO BEAM.
LASERSTRALNING
OPPNAD STRALEN AR FARLIG.
VARNING:OSYNLIG
located
NAR DENNA DEL AR
on
the
To reduce the risk of fire
this
interior.
appliance
to rain
or
or
electric shock, do not expose
moisture.
ATTENTION:Quand
s'exposer
aux
l'appareil est ouvert, ne pas
radiations invisibles du faisceau laser.
CAUTION
supply
This
in the OFF
product
position.
is conformed to EMC
!
RISK OF ELECTRIC SHOCK
DO NOT OPEN
The power switch of this unit is secondly mounted and
does not disconnect the whole unit from the mains
CAUTION:
TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT
REMOVE COVER(OR BACK).
regulation
NO USER SERVICEABLE PARTS INSIDE.
89/336/EEC and is therefore marked with the CE-label.
REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
Notice for customers in the United
Kingdom
The
WIRING INSTRUCTIONS
graphical symbols marked on the bottom
mean the following explanation.
or
back of
the set
appliance is supplied with a BS1363 approved 3 amp
plug. When replacing the fuse always use a 3
BS1362
amp
approved type. Never use this plug with the
fuse cover omitted. To obtain a replacement fuse cover
contact your supplying dealer or "LG Electronics U.K. Ltd."
This
fused mains
lightning flash with arrowhead within an
equilateral triangle is intended to alert the
The
to the presence of uninsulated
"dangerous voltage" within the product's
user
enclosure that may be of sufficient
magnitude to constitute a risk of electric
If the mains sockets in your home differ, or are not
suitable for the type of plug supplied, then the plug
should be removed and
refer to the
wiring
shock to persons.
suitable type fitted. Please
instructions below :
a
The exclamation
triangle
The mains
Warning:
of this appliance
plug
must be
bared wires is hazardous if
severed from the mains lead
destroyed. A
engaged in a
mains
plug
!
with
mains output line
socket.
-2-
point
within
an
is intended to alert the
equilateral
user
to the
presence of important operating and
maintenance (servicing) instructions in the
literature
accompanying
the
appliance.
Location of controls
12
3454678
9
10
15
11
14
12
13
16
19
18
-3-
17
Location ps
Specifications
1
VOLUME Control
h
2
FUNCTION Switch
Frequency
RADIO SECTION
range
AM...............................522~1,611kHzor 530~1,610kHz
3
CD PLAY/PAUSE buttons ( kII )
4
CD SKIP/SEARCH buttons
(Ijj/jj
FM............................................................87.5~108MHz
,
kk/ kkI)
Intermediate
frequencies
AM.......................................................................455kHz
5
CD REPEAT button
6
CDSTOPbutton(l)
7
CD OPEN button
8
FM STEREO indicator
9
TUNING dial
10
Deck controls
11
CD SYNC indicator
12
CD TRACK indicator
13
CD Pause indicator
FM.....................................................................10.7MHz
Antenna
AM.....................................................Ferrite bar antenna
(i)
FM....................................................Telescopic
h
antenna
CASSETTE SECTION
Recording system......................4 tracks 2 channel stereo
Frequency response.....................................125~8000Hz
S/N ratio................................................35/40dB(rec/play)
h
CD PLAYER SECTION
Frequency response...................................100~18000Hz
ratio..........................................................60dB(1kHz)
S/N
14
CD
15
CD RPT 1/ALL indicator
16
RIF/FM MODE switch
17
AC Power
18
Voltage Selector (optional)
19
Battery compartment
Play indicator
input socket
h
GENERAL
Speakers.............................................................8Ω 2
2
Out power(10%T.H.D)......................................1.0W
AC operation.......................... .........Refer to the indicated
voltage on the bottom of set
Battery operation...............................DC 9V, six "C"(R14)
batteries(not supplied)
Power consumption....................................................11W
Dimensions(W H D)......................338 178 230mm
Weight.......................................................................2.7kg
NOTE:
Design and specifications are subject to
change without notice for improvement.
-4-
A
Power Source
The AC Power cord Connection
Set(see fig.
A
)
2.
connecting the AC power cord, check that the
operating voltage of your set is idential with the voltage
of your local power supplied.
Connect one end of the AC power cord(supplied) to
3.
the AC IN socket located at the backside of your set.
Plug the other end into the wall outlet.
1. Before
Unplug
the AC power cord from the wall outlet if you
do not to
to mains
use
for
extended
an
period
of time.
(wall outlet)
Adjusting
the
voltage(optional)
If your set is equipped with a voltage selector at the back
side, be sure to set it to your local power supplied before
connecting the AC power cord.
B
Battery
Installation
Set(see fig.
B
)
1. Press open the battery cover.
2. Put six "C"(R14) batteries(not
compartment making
3.
positioned.
Replace the
sure
the
supplied)
+
and
-
into the
are
correctly
cover.
NOTE:
1. To avoid
damage
from
for
an
2. When the batteries
with
3.
+
-
+
+
-
+
+
-
+
+
---
6 "C"
+
-
(R14)
-5-
are
set
weak, replace all the batteries
new ones.
During
the AC power cord connect to the wall outlet,
the batteries
-
possible battery leakage,
plan to use the
the batteries if you do not
extended period of time.
remove
are
not
worn
out.
Sound
CD
Adjustment
Operation
ToPlayaCD
VOLUME:
Turn VOLUME clockwise to increase the sound level,
anti-clockwise to decrease it.
or
1. Set FUNCTION to CD.
2. Press
3. Load
OPEN(
a
i
printed
Operation
2. Tune in
station
a
3. Set FUNCTION
STEREO
or
or
5. Press
6. Press
FM.
using TUNING dial.
to TAPE(OFF) to turn
When
7. Press
off your set.
PLAY/PAUSE( kII )
to
listening
to
an
to pause.
will flash in the
particular
playing:
a
display.
resume
play.
section of music
on
backwards
light.
listening to
this function will
The track
Press and hold SKIP/SEARCH Ijj or kkI to search
or forwards, you will be able to faintly hear
FM stereo
broadcast. The FM ST. indicator will
Selecting
begin play.
display.
PLAY/PAUSE( kII ) again to
the track that is
2. Set FM MODE to MONO when
stereo broadcast.
PLAY/PAUSE( kII )
a track is paused II
8. How to search for
MONO:
1. Set FM MODE to ST. to
show the
total number of tracks.
number will be shown in the
1. Set FUNCTION to AM
compartment.
side
facing up.
compartment. The display will
4. Close the disc
Radio
to open the disc
)
disc with the
an
the track
FM
substantially
reduce the noise, however the stereo effect will be lost.
being played at high speed.
a particular track
9. How to search for
on
the current
disc:
Press SKIP/SEARCH Ijj
or
kkI to search for
a
particular track. After each press of this buttons the
new track number will be shown in the display.
NOTE:
10. Press
the antenna to get more clear reception.
1. AM: The antenna is built within the set and rotate the
Adjust
STOP(
l
)
to
stop playing
a
disc.
set for better
2. FM: Pull the
angle
reception.
telescopic antenna
out and
and direction for better
adjust
reception.
NOTE:
the
1. Do not tilt
or move your set with discs loaded. If you
do you may damage the discs and your set.
2. Do not touch the playing side of CD; the side without
any printing on it.
3. Clean your CD from the middle outwards with
a
soft
lint free cloth.
Cassette
Repeat Play
Operation
By repeatedly pressing REPEAT
displayed in the display.
1. Set FUNCTION to TAPE.
2.
Open
3. Insert
by pressing l / i ST/EJ.
push close the door.
a
cassette and
PLAY( k ) to playback.
Press PAUSE(II ) to pause. Press
resume play.
6. Press
following options
the cassette door
RPT 1
4. Press
5.
the
will be
FF( kk)
or
REW(jj)
One track is
PAUSE
to fast forward
again
or
rewind
RPT ALL
the tape.
An entire disc is
7. Press l / i ST/EJ to
automatically stop
played repeatedly
to
stop play.
played repeatedly.
Your cassette deck will
at the end of the
tape.
The next press of REPEAT will cancel the feature.
-6-
Recording Operation
NOTE:
1.
Recording levels have been preset at the factory
optimum conditions and cannot be changed.
under
2. Your set
can
record onto Normal ;
CrO2 tapes and metal tapes cannot be used.
Basic
Recording
1. Set FUNCTION to
2. Insert
one
which you wish to record from.
blank cassette.
a
3. Press REC h. PLAY k goes down
4.
(Press REC h and PLAY k at the
easily operationg.)
Start playing your CD or RADIO.
5. Press l / i ST/EJ to finish
deck will
Set RIF
which
recording.
automatically stop
on
one
automatically.
time for
same
Your cassette
at the end of the
the side of set to 1,2
or
more
tape.
3, depending
on
best reduces the noise when AM broadcast
recording.
CD
Synchro Recording
This feature
automatically
records
an
entire CD onto
a
cassette.
1. Load
2. Insert
disc and set FUNCTION to CD.
a
a
blank cassette
.
3. Press REC h. PLAY k goes down
REC h and PLAY k at the
(Press
easily operationg.)
When recording from
a
automatically.
same
CD, the disc will
time for
start
more
playing
after about 7 seconds.
4. Press l / i ST/EJ to finish
STOP(
l
)
to
stop playing
recording
a
and press
disc.
-7-
P/NO
:
3828R-A030B