Adtran PPTP VPN Pass-through on TA 600 Owner manual
Add to my manuals
12 Pages
ADTRAN PPTP VPN Pass-through on TA 600
The ADTRAN PPTP VPN Pass-through on TA 600 is a device that allows you to create a virtual private network (VPN) connection between two networks. This can be useful for connecting remote offices or employees to a central network, or for providing secure access to a network from a public Wi-Fi hotspot.
The TA 600 supports a single PPTP VPN tunnel. The device also includes a built-in firewall to protect your network from unauthorized access.
To use the TA 600, you will need to configure the device with the IP addresses of the networks that you want to connect. You will also need to create a VPN user account on the device. Once the device is configured, you can connect to the VPN by using a VPN client on your computer or mobile device.
advertisement
Configuring Port Forwarding for PPTP VPN Pass-through on TA 600s Performing NAT Overview: The TA 600 can support pass-through of a single VPN tunnel. If more than one tunnel is attempted, no tunnel will work properly. This guide assumes that NAT is already configured and working properly on the TA 600. Configuration Steps: 1. Configure the translation table entry for PPTP 2. Configure the translation table entry for GRE Configure the translation table entry for PPTP 1. Enter the NAT menu by pressing Ctrl+N 2. Arrow down to Translation Table and hit Enter 3. Press the right arrow key and then hit Enter with the index number highlighted. If you already have an entry in the Translation Table, press the letter i to add a blank entry, and then hit Enter. 4. If the IP address you will be bringing the tunnel up to is the same IP address that is on your WAN interface, leave Public Address Mode set to NAPT Addr. If the public address you are bringing the tunnel up to is different from the IP on your WAN interface, change the Public Address Mode to Specified and then set the IP address. -- or -- 5. Next, set the Protocol Mode to TCP or UDP 6. Then set the Public Port Mode to Specified 7. Then set Public Port Start and Public Port End to 1723. Public Port End should be filled in automatically when you enter Public Port Start. 8. Set Private Address Mode to Specified. 9. Set Private Address to the address that you want the VPN traffic to be forwarded to. In this example, we are using 192.168.1.253. 10. Set Private Port Mode to Specified. Private Port should automatically populate with 1723 when Private Port Mode is set to Specified. However, if this does not happen, set Private Port to 1723. 11. Press the letter h to get back to the main menu so that the config will be saved Configure the translation table entry for GRE 1. Enter the NAT menu by pressing Ctrl+N 2. Arrow down to Translation Table and hit Enter 3. Press the right arrow key and then press highlight the index number of the entry you just created for PPTP. Then press the letter c to copy the values from that translation table entry. 4. Next, press the letter i to add a blank translation table entry. With the index number of the blank entry highlighted (which should happen automatically), press the letter p to past the contents you just copied from the other entry. This will allow the translation table entry for GRE to be created more easily. After pressing the letter p, hit Enter to display the translation table entry. 5. Next, change the Protocol Mode to Specified 6. Set the Protocol to 47 7. Press the letter h to get back to the main menu so that the config will be saved.
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
Related manuals
advertisement