Setup

1 4 2

1 2

3

or

5 8 6 7 9 5 6 7 Error No. Problem 0 2 3 4 8 8.

A B, C, D Remedy Flash memory overflowing PCB hardware failure EEPROM failure Physical damage on the printhead Loose printhead Running out of media Incorrect sensor selection or sensitivity setting Contact the place where you bought the printer.

Cutter disconnected or cutter failure while in cutter mode Contact the place where you bought the printer.

Flash ROM read error Data overflowing Wrong setting of data transmission between the computer and the printer. (This error is applicable only when RS-232C I/F is used.) Contact the place where you bought the printer.

Contact the place where you bought the printer.

Contact the place where you bought the printer.

Contact the place where you bought the printer.

Close the top cover until it firmly latches.

Load a new roll of labels.

Contact the place where you bought the printer.

Press the power button to turn off the printer. Press the power button again to turn on the printer. Reprint the labels.

Check the data transmission settings, or contact the place where you bought the printer for appropriate settings such as baud-rate, parity, and Data/Stop bit.

PN: 9001181 @ 2008 Sato America, Inc. All rights reserved.