advertisement
◉
Touch to zoom
INSTRUCTION/INSTALLATION SHEET SATELLITE SURGE SUPPRESSOR 301 Fulling Mill Road, Suite G Middletown, PA 17057 Phone (800) 321-2343 / Fax (717) 702-2546 www.onqlegrand.com IS-0285 REV. A 1. Introduction The On-Q/Legrand Satellite Surge Suppressor, P/N 364746-01, protects the home’s satellite products from voltage spikes. It can be mounted on the On-Q RF Coax Conditioning Module, P/N 364679-01, (see Figure 1) which is typically installed in an On-Q enclosure or placed in-line on a coaxial satellite feed line. Figure 1 2. Description The On-Q Satellite Surge Suppressor features nondegrading performance over time, low (65V) clamping voltage, 500 Ampere surge capability and no voltage overshoot. Its response time is 1 nanosecond and it is self-resetting. Both ends of the Satellite Surge Suppressor contain female “F” style connectors. One female end can be unscrewed to expose a male “F” style connector. 3. Installation NOTE: If applicable, refer to IS-0232 for specific installation instructions concerning the RF Coax Conditioning Module. A. Secure the Satellite Surge Suppressor to the RF Coax Conditioning Module mounting tab using the provided retaining hex nut, if applicable (as shown in Figure 1). B. Attach the satellite feed cable to the Satellite Surge Suppressor. C. Connect the other end of the Satellite Surge Suppressor to the satellite or auxiliary inputs of the video distribution module. NOTE: Plan installation so that coaxial cable bends are not less than 2” radii for RG6 Quad Shield Coaxial Cable. ©Copyright 2007 by On-Q/Legrand All Rights Reserved. Page 1 of 1
advertisement
Related manuals
advertisement