Form No. 3373-801 Rev A

Weight Kit

Z 2000 Series Riding Mower

Model No. 121-7576

Installation Instructions

Loose Parts

Use the chart below to verify that all parts have been shipped.

Description

Bolt (1/4 x 1-5/8 inches) for 3 weights

Bolt (1/4 x 2-1/4 inches) for 5 weights

Flat washer

Weight

Nut

Qty.

2

3

2

2

2

Install the weight

Installing the Weight

1.

Lift up on the floor pan and remove it from the machine.

2.

Insert a flat washer and the appropriate bolt into the

footrest as follows: (Figure 1).

• If installing 3 weights, use the 1-5/8 inch bolts.

• If installing 5 weights, use the 2-1/4 inch bolts.

Use

1

2

3

3

2

1

3

2

1 g019271

Figure 1

3.

Use this hole when securing the weights

1.

Bolt

2.

Flat washer

3.

Slide each weight, one at a time onto the bolts and

secure them using 2 nuts (Figure 1 and Figure 2).

1.

Bolt

2.

Flat washer

4

Figure 2

3.

Weight (3 shown)

4.

Nut g019272

4.

Install and lower the floor pan.

© 2012—The Toro® Company

8111 Lyndale Avenue South

Bloomington, MN 55420

Register at www.Toro.com.

Original Instructions (EN)

Printed in the USA.

All Rights Reserved *3373-801* A

Notes:

2