Scosche GM2500B Vehicle Audio & Video Installation User Manual

GM5200B
SCOSCIG
IN-DASH INSTALLATION KIT FOR
2005-UP CADILLAC STS
BRACKET
LEFT SIDE
6408 POCKET
6409 MOUNTING
BRACKET RIGHT SIDE
6711
MOUNTING PANEL
INTRODUCTION/PRELIMINARY
This premium installation kit is for 2005-Up Cadillac STS vehicles. Included are all the parts you need to mount
your car stereo/cassette or CD player into your vehicle’s dash. Refer to the individual instruction in this manual
to remove your vehicle’s factory radio and assemble the kit.
CAUTION:
DISCONNECT YOUR VEHICLE’S NEGATIVE BATTERY TERMINAL BEFORE THE INSTALLATION
TO HELP PREVENT ELECTRICAL DAMAGE. WE RECOMMEND THE USE OF A VOLT/OHM METER
OVER A TEST LIGHT TO CHECK WIRING. A TEST LIGHT OR GROUNDED WIRE PROBE CAN CAUSE
DAMAGE TO THE VEHICLE’S COMPUTER AND/OR DIAGNOSTIC SYSTEMS. AVOID ALL FACTORY
AIR BAG WIRING - AIR BAGS CAN ACCIDENTLY DEPLOY CAUSING SERIOUS INJURY OR DEATH.
NOTES:
* See your vehicle's instructions for any special tools your installation might require.
* Read all instructions accompanying your car stereo/cassette player for proper wiring and mounting
instructions.
FACTORY WIRING CODES
For Factory Wiring Codes go to: www.scosche-cars.com
CAR STEREO CONNECTORS
PROVIDE EASY CONNECTION OF YOUR CAR STEREO
TO FACTORY WIRING HARNESS.
GM21SR CRAB
2007-up select General Motors 2002-up Chrysler/Jeep
with OnStar replacement interface antenna adapter
LIABILITY DISCLAIMER
This instruction booklet is based on carefully documented data and research of automobile dash disassembly, wire
harness/codes and information pertaining to installation of this GM5200B kit for 2005-Up Cadillac STS vehicles. Scosche
Industries, Inc. can not be held responsible for discrepancies/inconsistencies that may occur due to the automobile
manufacturing changes or options, or damage that may occur in the automobile during the installation of components
while using this booklet.
1-800-621-3695x3
SI 12/08 GM5200B (3000003)
If you have any further questions, call our toll free technical help line at:
©2009 SCOSCHE INDUSTRIES, INC.
FACTORY STEREO REMOVAL
2005-UP CADILLAC STS
1. Using a panel removal tool unsnap trim around stereo.
2. Extract (4) 8mm hex screws securing the factory radio.
3. Lift away disconnect and remove.
MOUNTING THE STEREO
ISO DIN MOUNT
1. Snap the 6409 left and right brackets to the 6711 kit panel.
2. Align the 6408 pocket to the lower edge of the panel.
Secure the pocket to the 6409 mounting
brackets with the two (2) supplied
screws in the installation kit.
3. Mount stereo to brackets
with the radio’s supplied
screws.
DOUBLE DIN MOUNT
1. Snap the 6409 left and right brackets to the 6711 kit panel.
2. Align, position and bolt the aftermarket double DIN-ISO head unit SUPPORT
to the 6409 mounting brackets. Use the hardware supplied with STRAPS
the aftermarket double DIN-ISO head unit to secure the mounting
brackets to the aftermarket stereo.
NOTE:
_ REAR SUPPORTING THE RADIO
% ADDS TO THE INSTALLATION'S
STRUCTURAL INTEGRITY.
_ REAR SUPPORT AVAILABLE
“a SEPARATELY.