- Computers & electronics
- TVs & monitors
- Flat panel accessories
- Enclume
- WR5 HS
- Installation instructions
Enclume WR5 HS Handcrafted 48 in. Wall Rack Utensil Bar w 12 Hooks Hammered Steel Installation instructions
Add to My manuals1 Pages
advertisement
UTENSIL BARS
WR0, WR1, WR2, WR3, WR4, WR5
Pictured with PHS pot hooks
Enclosed you will find everything needed for the installation and use of your storage rack. Two people make installation easier.
Hardware included:
2 – 1 ½ " Wood Screws
Thank you for choosing Enclume!
Enclume racks are the ultimate quality,
design, strength and function.
WARNING:
READ
ALL
OF
THE
INSTRUCTIONS
BEFORE
ASSEMBLING
AND
USING
YOUR
RACK
If you need help, please call 1-877-ENCLUME
Enclume
Design
Products
24 Colwell Street, Port Hadlock, WA 98339
Phone 360 ‐ 385 ‐ 6100
Fax 360 ‐ 385 ‐ 6156 www.enclume.com
1 – Hex key
1 – Toggle Kit – ¼ x 20
Components included:
1 – Utensil Bar
12 – Essentials Straight Pot Hooks – 48” bar
12 – Essentials Straight Pot Hooks – 42” bar
6 – Essentials Straight Pot Hooks – 36” bar
6 – Essentials Straight Pot Hooks – 30” bar
6 – Essentials Straight Pot Hooks – 24” bar
6 – Essentials Straight Pot Hooks – 18” bar
INSTALLATION INSTRUCTIONS
1)
'
Determine where you wish to mount your rack. Make sure you locate your wall studs if you want to mount into solid wood. You will want to use a level (not included) to make sure that the rack is level. You may not be able to mount both ends to a wall stud as they are typically spaced at 16". If it is not convenient to hang your rack directly into a wall stud you may use the included DRYWALL anchors enclosed with your rack. See Toggler® brand manufacturer recommendations for weight limits included in the instructions in the Toggler kit.
2) Locate the mounting keyholes on the back tabs of the bar. Hold the bar against the wall in its desired location, mark the keyholes. Carefully measure the area where the rack is to be hung and install the 1 1/2 " wood screws directly into the wall studs (or use the toggle instructions for drywall mount). Do not screw flush to the wall, leave enough space for the rack.
Using the keyhole (largest part down), place the rack on the screws and drop into place. Tighten the screws.
WARNING
It is important that your rack is installed correctly. If the unit is installed or used incorrectly, it could become unstable and collapse, possibly causing injury.
Warranty. This product is warranted to be free of material defects for a period of five years from the date of purchase.
Your exclusive remedy for breach of this warranty shall be the repair or replacement of the defective product when delivered, postage prepaid, to Enclume Design Products at 24 Colwell St. Port Hadlock, WA. 98339. There is no other warranty, expressed or implied, and there is specifically NO WARRANTY OF MERCHANTABILITY OR FITNESS FOR A
PARTICULAR PORPOSE. In no event will Enclume Design Products be responsible for any incidental or consequential damages related to use of this rack.
advertisement
Related manuals
advertisement