Kanguru Use U2D USB Duplicator Quick Start Guide

The Kanguru USB Duplicator has external USB HDD support.

Please follow these instructions when duplicating an external

USB HDD using the Kanguru

USB Duplicator:

HDD Usage with the Kanguru USB Duplicator

1

Power on the Kanguru USB Duplicator.

2

Power your external HDD using the power cord that was included with your hard drive.

AC Adapter Y-Type USB

3

Follow the diagrams below to connect your external USB hard drive to the duplicator.

3.5” HDD with AC Adapter 2.5” HDD with Y-Type USB Cable

2.5” HDD with Hub 2.5” HDD with Y-Type USB Cable and Hub

If you are still having trouble duplicating your external

USB HDD, try the following:

• Use an uniteruptible power supply with the USB Duplicator and USB HDDs to maintain constant electrical voltage.

• Power off the unit, connect the HDDs and then power it back on.

• Check the file system being copied and what copy mode the USB Duplicator is set to (Brief mode is limited on whch file systems it can duplicate).

Legal terms and conditions available at www.kanguru.com. Please review and agree before use. Thank you. 09.25.10 vrs. 1.0 © 2010 Kanguru Solutions