Hasbro Musical Dream Screen 5688 Instructions

 Ages: Birth & Up
PLAYSKOOL 5688
Musical Dream Screen“
CAUTION: when toy is used in crib, the crib sides
should be raised and the crib mattress should be in one of
the lower positions.
CAUTION: To avoid head entrapment, do not attach
lower strap on toy to mesh-sided cribs or playpens.
To Insert batteries
JL
= \ BATTERY € COMPARTMENT
1. On back of toy, Toosen the : 7 screws in n battery compartment
cover, and remove cover (screws will remain attached to cover).
2. Insert 4 "C" batteries. (Refer to illustrations on cover for proper
placement.)
3. Replace cover and tighten screws.
CAUTION: TO AVOID BATTERY LEAKAGE
1. Be sure to insert the batteries correctly and always
follow the toy and battery manufacturers' instructions.
2. Do not mix old batteries and new batteries.
3. Do not mix alkaline, standard (carbon zinc) or
rechargeable (nickel-cadmium) batteries.
4. Always remove exhausted or dead batteries from
the product.
To Start Musical Dream Screen
— NN * Press the "ON" button. Music will
—) begin to play and bright, sparkling
lights will roll across the screen.
The music and lights will continue for
approximately 6 minutes, after which
| the toy will automatically shut off.
“|e You can also shut off the toy manually
| | by pressing the "OFF" button.
EJ |e For an especially dazzling and
NE T= OFF delightful light display, view Musical
"ON" BUTTON BUTTON/ Dream Screen in a dark room.
The 8 songs are: *Brahms' Lullaby + Hush Little Baby e Beautiful Dreamer
eTwinkle Twinkle Little Star eRock-A-Bye Baby eRow Row Row Your Boat
e Three Blind Mice Baa Baa Black Sheep
To Attach Musical Dream Screen To Crib
bre LOWER SLOT STRAP
( TOP RAIL UPPER SLOTS
\ CRIB BAR
1. Position toy inside crib near top rail.
2. Line up arrow on strap with arrow on one of the upper slots on
back of toy.
3. Slide strap through slot, around top crib rail, and back down
through slot until strap is holding top of toy firmly onto rail.
4. Press strap tab into one of the three strap holes as shown.
5. Repeat process for other strap and upper slot.
6. Line up arrows and slide the remaining strap through lower slot
on back of toy (in either direction).
7. Slide strap around one of the crib bars and back down through
slot until strap is holding bottom of toy firmly onto bar.
8. Press strap tab into one of the three strap holes.
To Replace Light Bulb
Replace burned out light bulb with a new PR-24 or PR-18 light bulb.
1. On back of toy, loosen screw that attaches light bulb cover to toy
(screw will remain attached to toy).
2. Slide light bulb holder out of toy.
3. Remove screw that attaches light bulb cap to holder. Remove
cap.
4. Discard old bulb and replace it with a new PR-24 or PR-18 light
bulb.
5. Replace cap and screw. Slide holder into toy and tighten screw.
© 1990, 1996 Hasbro, Inc., Pawtucket, Rl 02862 USA. All Rights Reserved.
® denotes Reg. U.S. Pat. & TM Office.
Questions? Call:
MADE IN CHINA. 1-800-PLAYSKL
TM
P/N 46873400