Zonet ZFS3308E Installation Manual

All manuals and user guides at all-guides.com

Package Contents

•

One ZFS3308E

•

One Quick Installation Guide

•

One Power Adapter

•

Four Rubber Pads

Contact your local authorized reseller or the store purchased from for any items damaged and/or missing.

Application

all-guides.com

All manuals and user guides at all-guides.com

Front Panel

LED

PWR

Status Operation

Steady Power is ON

1~8

Steady Network cable connected and connection

Flash established

Rear Panel

Item Name

DC

1~8

Description

Power connector, connects to power adapter

RJ-45 ports 1 to 8

All manuals and user guides at all-guides.com

I n s t a l l l l a t i i o n

1 Connect the provided power adapter to the

Power connector of the

ZFS3308E

2 Connect your network devices to the RJ-45 ports of the ZFS3308E with UTP/STP Category

3/4/5 cables

All manuals and user guides at all-guides.com

C a u t i i o n

•

The switch must put on a surface that is able to hold at least 5kgs weight

•

Power adapter must be connected to the switch properly and securely

•

Suggested at least 10cm empty space around the unit for sufficient

• ventilation and cooling

Do not recommend to put any items on top of the switch

•

ZFS3308E is not ideally to work in a high electromagnetic

• environment, under direct sunlight, dust and vibrating surfaces

Maximum distance between the switch and the end node is 100 meters

•

Must use an unshielded or shielded twisted-pair (UTP/STP)

Category 5 or better cables to ensure proper transmission

•

Loss of data packet may encounter when using cable other than

Category 5

All manuals and user guides at all-guides.com

T r o u b l l e s h o o t i i n g

1.

Check the power adapter and power wall-jet to make sure they are function properly. Check if the switch is turned-ON and power LED is steady.

2.

Check all cable connections between computer and the switch to make sure they are connected properly.

3.

Maximum distance is 100 meters from the switch to end nodes.

4.

Link LED(s) is ON/flashing at the connected port(s) of the switch.

5.

Test your computer’s network adapter to make sure it is installed and functioned properly.

6.

Check issues such as network collisions, domain limitations, and other physical installation aspects. Make sure they all meet IEEE standard network installation requirements, more details can be found at www.ieee.org

.

7.

If problem still persists, write down your software/hardware configuration and LED error indications and contact your local retailer or the store purchased for further assistance.

8.

If the provided power adapter is missing, purchase 9V / 700mA power adapter for replacement.