advertisement
▼
Scroll to page 2
“> DOMETIC RE-HINGING DOOR RM2356 INSTALLATION Tm INSTRUCTIONS Left or right hand hinge conversion kit required. Left hand hinge kit part number. SP-378-L.HINGE-AS-A 4, Remove lower hinge pin. Right hand hinge kit part number. SP-378-R.HINGE-AS-A Ë Pa . fra e ME | } TE a я Ti Ta HS wi с - a * ; ea я } re sy, ÿ CM a AM = Ge Ко ес | ЗАО я и чт + a № His = Fs; TAR hand bir hein To re-hinge the door, follow these steps: 1. Before working on the refrigerator, make sure the 230-240 V AC voltage and 12 V DC voltage leads are disconnected! 5. Remove lower hinge by unscrewing the three screws. Save screws for later use. 2. Use a 10mm wrench to loosen the upper hinge pin. Remove pin and save for later use. 6. Remove plugs that cover the screw holes located on the side opposite of the present hinge location. 3. Lift door off the lower hinge pin. Place door on soft material to prevent any damage to the door. 7. Locate the new hinge and fasten with the 3 screws removed earlier. Insert hinge pin. 8. Insert plugs to cover the unused screw holes on the opposite side. 54-378-MAW40B 9. Unscrew and remove upper travel catch reinstall on opposite side. 12. Using the new door top corner cover supplied in the hinge conversion kit, fit using saved screw. 10. Remove screw and door top corner cap. Save the screw and discard corner cap. 13. Place door on lower hinge pin (a). Mount upper hinge pin (b) and fasten it using a socket wrench (c). Close the door. 11. Remove top and bottom door hinge bushings and move to opposite corners of door. 14. Check the travel catch to make sure it works properly, that the door closes easily and that the gasket seals well on all sides. 15. Check the door is parallel with side of cabinet. To adjust loosen the screws on the bottom hinge and move hinge side ways. Re tighten screws.
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project