George Kovacs P3836-077 Soft™ - 1 Light Pendant Instruction Manual

 INSTALLATION INSTRUCTIONS
For Models # P3834 /P3836 (Dated Sep 21, 2009)
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER
AVERTISSEMENTI COUPER LE COURANT AUNIVEAU DES FUSIBLES OU DU DISJONCTEUR |
HANGING THE FIXTURE (Fig. 1)
1. Carefully remove the fixture from the carton
and check that all parts are included as
shown in the illustration. |
. Shut off power at the circuit breaker.
3. Install screws (B}) into crossbar (C).
. Attach the Crossbar (C) to the Outlet box in
the ceiling with two screws (E). The side of
the Crossbar with “GND” marked on it and
two convex points must face out.
5. At this point, connect the electrical wire as
shown in Figure 2, making sure that all wire
connectors (A) are secured. If your outlet
has a ground wire (green or bare copper),
connect the fixture Ground Wire to it.
Otherwise, connect the fixture Ground Wire
direclly to the crossbar using the Green
Screw (О) provided.
6. Place the Canopy (F) up to. the ceiling and
secure by threading the Cap Nuts (G) onto
the screws (B).
7. Place the Washer (1) to the fitter then the
Large Glass. (J) followed a washer (R) and
pial gasket (K) secure with threaded sleeve
MN
bu
8. Install washer (M) followed by, the inner
Glass & then washer (QO) followed by
spacer (P). Secure all with Check ring (Q).
9. Install the light bulb in accordance with the
fixture’s specifications. (DO NOT EXCEED
THE MAXIMUM WATTAGE RATING!SNE
PAS DEPASSER LA PUISSANCE
NOMINALE MAXIMALE?S
Your installation is now complete. Return
power to the junction box and test the fixture.
IMPORTANT: Fixture should be installed by a
qualified electrician to ensure proper wiring
and installation. |
american
us Ite hting_
| association
Interte
Fig. 1
5 OUTLET BOX
~d (CEILING)
с ok N
E— Ti
F- F ~D
G—=7
H
E WSROBSA2T20L EI
T
+ | > 3, ——M WSRO5S4ZT20LE ©
£ \ASRO8542T2C ~ -
A
|
+
a VWSROS343T2CLE ©
-P