AMPIRE VSC-E-BM14 Griffleisten-Kamera BMW, E-Serie Installation Manual
Add to my manuals
1 Pages
Ampire VSC-E-AU05 is a vehicle-specific camera with a 1/4" CMOS NTSC sensor, a 110° horizontal angle, a 90° vertical angle, and a 140° diagonal angle. It is water-resistant (IP68), has a power supply of 10V-15V, and a power consumption of 1.5W/200mAh. The camera has a video input RCA connector, a connector cable of approximately 7m, and a 2A fuse. It can be used with or without parking guide lines.
Possible use cases:
- Reversing
- Parking
- Monitoring
advertisement
Vehicle-specific camera
VSC-E-AU05/AU11/AU12/BM11/BM13/ME08/ME10/ME13
Delivery content
System cable extension with box 7m
Exchange rear door opener handle with integrated camera
(exemplifying figure)
Product features
Sensor – Typ 1/4“ CMOS NTSC
Angle horizontal 110°, vertical 90°, diagonal 140°
Mirroring (fixed)
Parking guide lines switchable
Water resistance IP 68
Power supply 10V - 15V
Power consumption 1.5W/200mAh
Video-input RCA connector
Connector cable approx. 7m
Fuse 2A
Camera-configuration
(Cut green cable loop if required)
With guide lines
Whithout guide lines
+12 V ONLY if reverse gear is activated
Connection scheme: reversing signal by reversing light
To
Vid eo in pu t
To camera
Black-Box
ACC 12V
Accessory-Power
Cable labelling of connection cable
Monitor test (+12V Out)
ACC -
ACC +12V
Reverse (+12V)
Reverse GND
-- +
Reversing light
Note: If the camera is powered by reverse signal we recommend to install a relay between power supply of reverse signal and power supply of the camera to ensure a stable and uninterrupted power supply and avoid unwanted errors in the board computer.
In case the isolation of the camera is harmed in the moisture section close to the camera, it is mandatory to repair the isolation. Otherwise the camera will inevitably become moist inside sooner or later.
Camera not suitable for permanent operation!
Tip for dealers:
Inform your end customers that the rearview camera mustn‘t be cleaned by steam cleaner!
Made in China
10R-04.1484
Connection scheme: reversing signal generated by a interface
+12 V ONLY if reverse gear is activated
To the reverse cable of the video interface
To vid eo in pu t
To camera
Black-Box
Isolate - without function
Reverse GND
HAS TO BE connected to Ground
ACC 12V
Accessory-Power
Cable labelling of connection cable
Monitor test (+12V Out)
ACC -
ACC +12V
NavLinkz GmbH - Eurotec-Ring 39 - D-47445 Moers - Germany - www.navlinkz.de - [email protected]
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
Related manuals
advertisement