Luxor ATV-56 Instruction Sheet

Instruction Sheet

Models ATV-56, ATV-56B, ATV-56C & ATV-56BC

1 - Top Stand Assembly

1 - Bottom Stand Assembly

1 - Rubber Mat

4 - 4˝ Casters, 2 w/brake

LUXOR

2245 Delany Road

Waukegan, IL 60087

Ph: 847/244-1800 • 1-800-323-4656

Fax: 847/244-1818 • 1-800-327-1698 ATV56

8 - Bolts

8 - Nuts

1 - Power Cord Assembly

With Hardware

Parts List

For model ATV56C, ATV56BC

2 - Keys

2 - Chrome Recessed Handles

4 - Black Screws

Tools Required

1 - Slotted Screwdriver

1 - Rubber Mallet

For Big Wheel Models

3 Slots On Wheel Hub

Facing Inside

End

Cap

Axle

Axle

Bracket

Bottom

Stand

Assembly

Back

Place Locking Casters as Illustrated

Washer

8˝ Big

Wheel

Table Top

(Upside Down)

2.

The big wheel is to be installed along the most narrow side of the table. Install axle brackets as illustrated. Tap one axle cap onto one end of the axle and slide the big wheel onto the axle from the opposite end. Slide one washer onto axle so it rests against the big wheel. Install axle by sliding it through axle brackets so that big wheel is resting against side of bracket. Slide washer onto the open side of the axle and then slide the remaining big wheel into place.

Table Illustrated

Upside Down

Front

1.

Turn bottom stand assembly upside down on a smooth surface.

Push the four casters firmly into the caster socket holes in bottom of each leg, as illustrated.

IMPORTANT: Casters must be fully seated. Tap firmly with a rubber mallet properly seat casters. Turn the bottom stand right side up.

Axle Is

Being Held

Firmly In

Place

Use Hammer

To Tap Axle

Cap Into Place

Tap remaining axle cap onto axle end. Big wheels should be snug fit with little side-to-side play. Push the two locking casters firmly into the holes in the front of the cart. Important: Casters must be fully seated. Tap firmly with rubber mallet.

Top

Stand

Assembly Nut

Bottom

Stand

Assembly

Bolt

3.

Position top stand assembly over bottom stand assembly as illustrated.

Adjust top stand assembly up or down to desired height. Align holes in all four legs, insert bolts and fasten with four wing nuts, as illustrated.

4.

Place metal cordwrap onto metal top shelf making sure that the holes on the cordwrap align with the holes on the shelf. Place the two screws through the holes of the electrical assembly. Place the electrical assebly with the two screws through the holes of the cordwrap and mounting bracket. Secure screws with wingnuts.

Cabinet Models Only

Recessed

Handles

For Models With a Cabinet

5.

Press recessed handle into door and fasten with 2 phillips head screws.