Draw-Tite 75105 Class III Trailer Hitch Installation Instructions

INSTALLATION INSTRUCTIONS

Product No.

44729, 75105

TOYOTA TUNDRA

87588, 78198UH

PLYMOUTH, MI

SMALL PARTS

PACKAGE K75105

WARNING: DO NOT LUBRICATE THREADS, BOLT FAILURE MAY

OCCUR DUE TO OVER TIGHTENING.

WARNING: DO NOT DRILL OR WELD TO THIS HITCH .

IMPORTANT NOTES

USE ONLY TOWING PRODUCTS SUPPLIED OR APPROVED BOLTS,

LOCKNUTS, AND WASHERS TO INSTALL THIS HITCH

Accessory Rating C

1/2” SERRATED WASHER

12mm HEX BOLT

TOOLS REQUIRED

3/4” SOCKET

18mm SOCKET

TORQUE WRENCH

1/2” CARRIAGE BOLT

BOLT PLATE

TO WELD NUTS IN THE FRAME

1/2” SERRATED WASHER

1/2” LOCK NUT

1. Lift the receiver up to the frame of the vehicle. Locate the large holes in the receiver brackets over the rivet heads in the

frame.

2. Install four (4) 1/2” serrated washers over four (4) 12mm hex bolts and insert the bolts up through the receiver brackets

and into the weld nuts in the frame. See the diagram above.

3. Install two (2) bolt plates over two (2) 1/2” carriage bolts and insert the bolts down through the frame and the receiver brackets. Install 1/2” serrated washers and 1/2” lock nuts on the bolts. See the diagram above.

4. Torque the 12mm bolts to 75 LB-FT.

Torque the 1/2” nuts to 75 LB-FT.

(OVER)

For Installation Assistance or Technical Help,

U.S.A. 800-632-3290

CANADA 800-565-0351

N75105 5-20-14 PCN3764 © 2002, 2007, 2011, 2014 CEQUENT PERFORMANCE PRODUCTS Printed in Mexico Rev. C

For Installation Assistance or Technical Help,

U.S.A. 800-632-3290

CANADA 800-565-0351

THIS PRODUCT COMPLIES WITH SAFETY SPECIFICATION AND REQUIREMENTS FOR THE STATE OF NEW YORK AND VESC

REGULATION V-5 FOR CONNECTING DEVICES AND TOWING SYSTEMS. WEIGHT DISTRIBUTING HITCH RATING IS 7500 LB. MAX.

GROSS TRAILER WEIGHT AND 750 LB. MAX. TONGUE WEIGHT. WEIGHT CARRYING HITCH RATING IS 5000 LB MAX GROSS TRAILER

WEIGHT AND 500 LB MAX TONGUE WEIGHT. CONSULT VEHICLE OWNERS MANUAL FOR TOWING RECOMMENDATIONS AND

LIMITATIONS.

LIMITED WARRANTY

Towing Products warrants its Hitches, custom Hitch Receivers, and Sway Controls from date of purchase against defects in material and workmanship under normal use and service, ordinary wear excepted, for the ownership life of the original consumer purchaser. Towing Products will replace FREE OF CHARGE any part which proves defective in material or workmanship when presented to any Towing Products dealer,

Towing Products Warehouse, or returned to factory, TRANSPORTATION CHARGES PREPAID, at the address below. THIS WARRANTY IS

LIMITED TO DEFECTIVE PARTS REPLACEMENT ONLY. LABOR CHARGES AND/OR DAMAGE INCURRED IN INSTALLATION OR

REPLACEMENT AS WELL AS INCIDENTAL AND CONSEQUENTIAL DAMAGES CONNECTED THEREWITH ARE EXCLUDED. Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to you. Any damage to the Hitch, Custom Hitch receiver or Sway Control as a result of misuse, abuse, neglect, accident, improper installation, or any use violative of instructions furnished by Towing Products, WILL VOID THE WARRANTY.

This warranty gives you specific legal rights, and you may also have other rights which vary from state to state. In the event of a problem with warranty service or performance, you may be able to go to a small claims court, a state court, or a federal district court.

N75105 5-20-11 PCN3764 © 2002, 2007, 2011, 2014 CEQUENT PERFORMANCE PRODUCTS Printed in Mexico Rev. C