advertisement
MONOGRAM 36" PROFESSIONAL
GAS RANGETOP WITH 4 BURNERS
AND GRIDDLE (NATURAL GAS)
ZGU364NDPSS
AUTHENTIC PROFESSIONAL APPEARANCE
Stainless steel with smoothly finished edges and large electronic control knobs
SEALED, DUAL-FLAME STACKED BURNERS
Deliver a full spectrum of heat settings, from an ultra-low 140° F simmer to an intense 18,000 BTU
STAINLESS STEEL AND ALUMINUM-CLAD GRIDDLE
Offers 18,000 BTUs* of cooking power, allowing fast and consistent heating across the entire cooking surface
ELECTRONIC IGNITION WITH AUTOMATIC
REIGNITION
Ensures a continuous flame and reignites automatically if accidentally extinguished
REVERSIBLE BURNER GRATES
Flat on one side and uniquely contoured on the other to accommodate round-bottom woks
STAINLESS STEEL GRIDDLE COVER
Included with the range
*Natural gas
For questions about your appliance, please call 1-800-626-2000.
PAGE 1 OF 4 Product Specification Revised 11/20
OVERALL DIMENSIONS
SPECIFICATIONS
Overall Width
Overall Depth
Overall Height
Volts/Hertz/Amps
Net Weight
Approx. Shipping Weight
35 7/8" (91.1 cm)
27 1/2" (69.8 cm)
8 1/2" (21.6 cm)
120v; 60Hz; 15A
135 lbs (61.2 kg)*
163 lbs (74 kg)
ATTENTION ELECTRICIAN:
Rangetops must be supplied with 120V, 60Hz, and connected to an individual, properly grounded branch circuit protected by a 15 amp circuit breaker or time-delay fuse.
For more details refer to the installation instructions for this product.
SIDE VIEW WITH A BACKSPLASH
ZGU364NDPSS
For questions about your appliance, please call 1-800-626-2000.
Dimensions in parentheses are in centimeters unless otherwise noted.
Actual product dimensions may vary due to manufacturing tolerances.
PAGE 2 OF 4 Product Specification Revised 11/20
DIMENSIONS AND INSTALLATION
INFORMATION (IN INCHES)
HELPFUL TIPS
Professional rangetops offer a number of choices in size and rangetop configurations.
PRODUCT DIMENSIONS AND
CLEARANCE
A 36"- or 42"-wide professional vent hood is recommended for installation over this rangetop.
Clearances between rangetop and side wall or combustible material must be at least 12" on each side.
Allow 8" free space below the top surface of countertop. Allow additional clearances below the burner box to install the regulator and make house gas supply connections. Use a 90° elbow to route the gas connections and limit interference with drawers or other cabinetry.
WARNING
Installations without a hood require 48" minimum to combustibles above the rangetop. A custom hood installation with exposed horizontal combustible surfaces must have an "auto-on" feature.
Refer to hood installation instructions for specific hood clearances. The surface of the entire back wall above the countertop and below the hood must be covered with a non-combustible material such as metal, ceramic tile, brick, marble or other stone.
Front of deep cabinets can align with control panel beveled edge.
* The opening between a 4" high backsplash must be 36" to allow the rangetop to slide back against the wall.
For questions about your appliance, please call 1-800-626-2000.
PAGE 3 OF 4 Product Specification Revised 11/20
DIMENSIONS AND INSTALLATION
INFORMATION (IN INCHES)
Utility Locations
HELPFUL TIPS
BACKSPLASH ACCESSORIES
The rangetop requires a 12" minimum clearance to a vertical combustible surface at the rear. A backsplash is required for installations with less than 12" clearance.
A custom, non-combustible backsplash can be used.
BACKSPLASH WITH WARMING
SHELF
All Monogram Professional Hoods feature infrared warming lights. The 30"-36" adjustable backsplash with warming shelf is a perfect complement when installed with the tapered or straight-sided hoods.
• 36"-wide range backsplash options
UX12B36PSS –12" high backsplash
UXADJB36PSS –30"-36" adjustable height
ADVANCE PLANNING FOR 36"
PROFESSIONAL RANGETOPS
Professional rangetops offer a number of choices in size and rangetop configurations.
• All professional rangetops are factory set for natural gas. Conversion orfices for liquid propane are packed with product.
High Altitude kit, WB28K10553, is also available. The kits must be installed by a qualified service technician at additional cost.
ELECTRICAL REQUIREMENTS
Rangetops must be supplied with 120V, 60Hz, and connected to an individual, properly grounded branch circuit protected by a 15 amp circuit breaker or time-delay fuse.
GAS SUPPLY
• Natural gas models are designed to operate at 5" water column pressure. For proper operation, the pressure of the natural gas supplied to the regulator must be between 7" and 13" water column.
• If converted to liquid propane, the models are designed to operate at 10" water column pressure. For proper operation, the pressure of the LP source to the regulator must be between 11" and 13" water column.
For questions about your appliance, please call 1-800-626-2000.
PAGE 4 OF 4 Product Specification Revised 11/20
advertisement
Related manuals
advertisement