RAM RAM-316-3SW1U Pod III Swing Arm Laptop Mount Instructions

Parts Index

* not to scale

A rammount.com

1.800.497.7479

[email protected]

RAM ® Pod ™ III Universal No-Drill

B

™ Base

C x 3

D

E

F

G x 3

I

H

J K x 1 x 3 x 1 x 1 x 3

1/4”-20 x 1” x 3

1/4”-20 x 3

#10-24 x 1 1/2” x 3

#10-24 x 3

Before installation, locate the best possible attachment points for (D) foot bases, such as a seat bolt or any other existing screw, nut or bolt.

If desired, you may drill your own attachment point using a bolt, washer and nut, or with a sheet metal screw.

1 Pre-bend (A) flex rods to brace against another object while mounted, such as the center console of your vehicle. Assemble the seat base as shown. Make sure you have each (A) flex rod pre-bent to the desired angle before sliding on (B) tube coverings.

2 Locate 3 attachment points and use existing seat bolt and washer to secure the foot base assembly. Align the top of each flex rod with the grooves of (E) housing wedge as shown. Install (F) top housing along with a RAM ® ball base or post (not included) using (I and J) screws and nuts.

Tighten using (C) allen key. Screws may need to be re-tightened after mount is used or until wedge is fully engaged.

I

B K

A

F

E

H

D

J

G

RMR-INS-316

Safety Precaution

Do not install this product near or over an airbag deployment area or in a location that obstructs the driver’s vision or interferes with vehicle operation. National Products, Inc does not assume responsibility or liability for any such personal injury, death or property damage.

To see more mounting options, visit rammount.com

This document, including images, may not be reproduced partly or fully without the expressed written consent of National Products, Inc.