advertisement
IB-H2 Installation Instructions
HONDA& ACURA TRANSPONDER BYPASS KIT (NO KEY REQUIRED)
* See Select Vehicle List Below
HONDA/ACURA
IMMOBILIZER
MODULE
Bro w l ck
GR
U D
SYN
C HRO
DAT
A
To ECM
Programming LED
Ground (-) out from remote car starter
IMPORTANT
12 volts Batt.
BLACK(-): Chassis ground
RED (+) : +12VDC Battery
ORANGE: SYNCHRO
PINK: Not used
PINK /TRACER : Not used
VIOLET: Data ECM side
VIOLET/TRACER: Data key side
BLUE: Not used
GREEN: Not used
BROWN (-) : Neg. Out (ground) when running
Programming Jumper
IB-H2
PROGRAMMING: (IMPORTANT):
1998-2003 VEHICLES: GREY OR BLACK KEY CAN BE USED TO PROGRAM. TESTING EITHER GREY OR BLACK
KEY IS THE ONLY METHOD TO DETERMINE WHICH KEY WILL PROGRAM.
When the IB-H2 is correctly installed, put the programming jumper to the “Programming” position “A”. The LED must be “On” in order to proceed to the next step:
1 Turn the ignition key to the “ON” position, when the “SYNCRO” is programmed the LED will blink quickly.
2 Turn the ignition key to the “OFF” position then wait until the security light (green key symbol) on the cluster is off.
3- Return key to the “IGNITION ON” position. When the second step of programming is complete: the “LED” will
blink slowly, at this point turn the “IGNITION” to the “OFF” position & remove the programming jumper.
Place the jumper in the operating mode position.
Note: the LED will stop blinking when the jumper is removed from the programming mode.
JUMPER POSITION:
Programming Position
Fig:C
Not use
Operating position
VEHICLE
ACCORD
1998-2002
ACURA MDX
2001
ACURA CL
1998-2002
ACURA TL
1998-2002
ACURA TL
2003
ODYSSEY
1999-2002
PILOT
2003
PILOT
2004
Data (Code)
Red
Pos.:#2
Red
Pos.:#2
Red
Pos.:#2
Pos.:#2
Syncro (TxCt)
Blue
Pos.:#3
Blue
Pos.:#3
Blue/White
Pos.:#3
Blue/White
Pos.:#3
Pos.:#3
Blue/Green
Pos.:#2
Red or Black/Brown
Pos.:#2
Red
Pos.:#2
Orange/Blue
Pos.:#3
Orange or Blue
Pos.:#3
Blue
Pos.:#3
Ground (Gnd)
Brown/Black
Pos.:#4
Brown/Black
Brown/Yellow
Pos.:#4
Brown/Yellow
Pos.:#4
Pos.:#4
Brown/Black
Pos.:#4
Brown/Yellow
Pos.:#4
Brown/Yellow
Pos.:#4
IB-H2 COMPATIBILITY RULE:
I B-H2 CAN BE USED ON THE TYPE "A" HONDA/ACURA IMMOBILIZER
SYSTEMS. TO IDENTIFY LOOK FOR THE " GREEN 5 PIN w/ 4 WIRES CONNECTOR ".
IF YOU SEE 4 WIRES COMING FROM THE GREEN PLUG,
THE IB-H2 IS THE RIGHT TRANSPONDER BYPASS KIT TO USE.
advertisement
Related manuals
advertisement