A 5 Lux Scooter

Owner’s Manual

Read and understand this entire manual before allowing child to use this product!

For assistance contact Razor. DO NOT RETURN TO STORE.

NOTE: Manual illustrations are for demonstration purposes only. Illustrations may not reflect exact appearance of actual product. Specifications subject to change without notice.

SAFETy WARNINgS

AN IMPORTANT MESSAGE TO PARENTS: This manual contains important information. For your child’s safety, it is your responsibility to review this information with your child and make sure that your child understands all warnings, cautions, instructions and safety topics. Razor

USA recommends that you periodically review and reinforce the information in this manual with younger riders and that you are required to inspect and maintain your child’s scooter to insure their safety.

GENERAL WARNING: Scooter riding can be a hazardous activity.

Scooters can, and are intended to move and it is therefore possible to get into dangerous situations and/or lose control and/or fall. If such things occur you can be seriously injured or die. LIKE ANY OTHER MOVING

PRODUCT, USING A SCOOTER CAN BE A DANGEROUS ACTIVITY AND MAY

RESULT IN INJURY OR DEATH EVEN WHEN USED WITH PROPER SAFETY

PRECAUTIONS USE AT YOUR OWN RISK AND USE COMMON SENSE.

• Always wear safety equipment such as a helmet, knee pads and elbow pads. Always wear a helmet when riding your scooter and keep the chinstrap securely buckled.

• Always wear shoes.

• Ride on smooth, paved surfaces away from motor vehicles.

• Avoid sharp bumps, drainage grates, and sudden surface changes.

Scooter may suddenly stop.

• Avoid streets and surfaces with water, sand, gravel, dirt, leaves, and other debris. Wet weather impairs traction, braking, and visibility.

• Do not ride at night.

• Brake will get hot from continuous use. Do not touch after braking.

• Avoid excessive speed associated with downhill rides.

• Adults must assist children in the initial adjustment procedures to unfold scooter, adjust handlebar and steering to height, and finally to fold scooter.

• Obey all local traffic and scootering laws and regulations.

• Watch out for pedestrians.

• Do not exceed 220lbs (100 kgs) total weight on the A5 scooter.

• Do not allow children under age eight (8) to use the scooter. All children and preteens should ride with adult supervision at all times.

• Rider weight does not necessarily mean a child’s size is appropriate to fit or maintain control of the scooter.

• A parent’s decision to allow his or her child to ride this product should be based on the child’s maturity, skill and ability.

• Refer to the section on safety for additional warnings.

ACCEPTABLE RIDING PRACTICES AND CONDITIONS

Direct parental supervision is required. Scooters are meant to be used only in controlled environments free of potential traffic hazards and not on public streets. Do not allow your child to ride a scooter in any areas where vehicle traffic is present. The child must maintain a hold on the handlebars at all times. Never allow more than one child at a time to ride a scooter. Never use near steps, sloped driveways, hills, roadways, alleys or swimming pool areas.

Keep fingers and other body parts away from the product when folding or unfolding. Adults must not allow children to assist in folding or unfolding the scooter.

Do not ride a scooter in wet weather. Scooters are intended for use on solid, flat, clean and dry surfaces such as pavement or level ground without loose debris such as rocks or gravel. Wet, slick or uneven and rough surfaces may impair traction and contribute to possible accidents. Do not ride a scooter in mud, ice, puddles or water. Avoid excessive speeds that can be associated with downhill rides. Never risk damaging surfaces such as carpet or flooring by use of a scooter indoors. Do not ride at night or when visibility is impaired.

PROPER RIDING ATTIRE

Always ensure child is wearing proper protective equipment such as an approved safety helmet. A helmet may be legally required by local law or regulation in your area. A child should always wear shoes, never ride barefooted or in sandals, and keep shoelaces tied and out of the way of the wheels.

FAILURE TO USE COMMON SENSE AND HEED THE ABOVE WARNINGS

FURTHER INCREASES RISK OF SERIOUS INJURY. USE AT YOUR OWN RISK

AND WITH APPROPRIATE AND SERIOUS ATTENTION TO SAFE OPERATION.

USE CAUTION.

WARNING: ALWAYS INSPECT THE SCOOTER PRIOR TO RIDING.

Properly inspecting and maintaining your scooter can reduce the risk of injury.

Always inspect your scooter before riding and regularly maintain it.

WARNING: CHECK LOCAL LAWS REGARDING SCOOTER USE. Check local laws and regulations to see where and how you may use your Razor scooter legally. In many states and local areas scooter riders are required

BY LAW to wear a helmet. Check local laws and regulations regarding laws governing helmet use and scooter operation in your area.

BEFORE yOU BEgIN

Remove contents from box. Remove the foam separators that protect the components from damage during shipping.

Inspect the contents of the box for scratches in the paint, dents that may have occurred during shipping. Because your scooter was assembled and packed at the factory, there should not be any problems, even if the box has a few scars or dents.

Handlebar

WARNINg: DO

NOT USE NON-RAZOR

PRODUCTS WITH YOUR

SCOOTER.

Razor scooters have been built to certain Razor design specifications.

The original equipment supplied at the time of sale was selected on the basis of its compatibility with the frame, fork and all other parts.

Certain aftermarket products may or may not be compatible.

T-tube

Steering tube quick-release lever

Extension tube/steering column

Collar clamp

Front fork

Joint lever/pivoting mechanism

Rear Fender/brake

Deck q

Required Tools

We recommend the use of mechanic’s grade tools.

Steering column adjusting screw

3mm & 5mm hexagonal key wrench

SET Up AND USAgE INSTRUCTIONS

Unfolding the scooter for first time use.

1

Insert and secure the left and right handlebars by pressing the spring-loaded buttons and inserting them into the T-tube.

2

Make certain the spring-loaded button engages the hole in the

T-bar for each handlebar.

3

To release the folding mechanism, hold the T-tube with one hand between the collar clamp and the quick-release lever and place your foot on the deck plate.

With the other hand, pull the joint lever up to release the steering column from the locked position and allow you to pivot it to the upright position.

WARNINg: Failure to properly engage the spring-loaded buttons may cause the handlebars to dislodge while riding and may cause you to lose control and fall. When correctly engaged the handlebars will not rotate nor will they move sideways. Note that when properly engaged, the springloaded buttons are clearly visible in the holes on the T-tube.

WARNINg: Keep your fingers clear of the pivoting mechanism when folding or unfolding the scooter. Make sure others are standing clear.

4

The Joint lever is spring-loaded and will automatically lock in the upright position when fully upright.

5

To adjust the height of the handlebars, unlock the extension tube by pulling outward on the quick-release lever and pushing the button located on the extension tube. Slide the T-tube to the desired position and secure by pushing inward on the quick release lever.

6

The tension of the quick-release lever can be adjusted by tightening or loosening the allen bolt. Be careful not to over-tighten. You should always be able to open and close the quick-release lever by hand and the T-tube should slide freely with the quick-release open.

CHECk BEFORE RIDINg

Collar Clamp

WARNINg: Failure to properly engage the quick-release lever may cause the T-tube to side up or down while riding which may cause you to lose control and fall. With the quick-release properly adjusted and engaged, the handlebars will not move up or down.

Using the 5mm Allen wrench, check that the collar clamp bolt is tightened securely. This item is tightened and quality inspected at the factory, but there is a slight chance that the effects of shipping or handling may have caused this bolt to loosen.

CHECk BEFORE RIDINg

Baseboard/Steering Column Adjusting Screw(s).

WARNINg: Keep your fingers clear of the pivoting mechanism when folding or unfolding the scooter.

With the scooter in the upright and locked position, using a 3mm Allen wrench, adjust the set screw at the baseboard until there is no free-play between the baseboard and the steering column. Be careful not to over-tighten this screw as it only needs to be snug against the steering column. Verify the adjustment by releasing the steering column from the locked position and folding the scooter. The locking lever should not bind and the folding movement should be smooth.

The spring-loaded mechanism should automatically lock and be fully seated in the upright position.

Wheels and Bearings

Under normal circumstances and conditions, Razor wheels and wheel bearings are maintenance free. Nonetheless, it is the responsibility of the owner or guardian to periodically inspect the wheels for wear and tear, the axle for proper tightness, and bearings for side-to-side play and loose parts. When a wheel or wheel bearing develops play, this is an indication of excess wear and replacement is necessary. Replace immediately with only genuine Razor wheels. Worn wheels and bearings are considered normal wear-and-tear and are not covered by the Razor Warranty. Wheels other than genuine Razor wheels may not be compatible with your Razor scooter. The use of anything other than genuine

Razor replacement parts may affect your safety and will void your warranty.

WARNINg: Wheelies and other stunt-type riding reduces your ability maneuver and control your scooter. Take the necessary precautions, such as wearing appropriate protective gear and practice in a area safe for stunt riding and free from obstructions.

Cleaning your Scooter

Wipe with a damp cloth to remove dirt and dust. Do not use industrial cleaners or solvents as they may damage the surfaces. Do not use alcohol, alcohol-based or ammonia-based cleaners as they may damage or dissolve the plastic components or soften the decals or decal adhesive.

How to Ride

Place one foot on the baseboard, push forward with the other foot. Steer. For enhanced cornering, lean slightly into the direction of the turn. For controlled stops, apply the brake by stepping on the rear fender/brake. Razor recommends that you practice applying the brake at various speeds and in an open area free from obstructions before riding your Razor around others.

SAFETy REMINDERS pRE-RIDE CHECkLIST

q q

Loose parts

Check and secure all fasteners before every ride. Make sure the steering tube clamps, steering tube extension quick release, and handlebars spring buttons are locked properly in place before riding.

Safety gear

Always wear proper protective equipment such as an approved safety helmet. Elbow pads and kneepads are recommended.

Always wear shoes (lace-up shoes with rubber soles), never ride barefooted or in sandals, and keep shoelaces tied and out of the way of the wheels.

q

Be Careful!

You will see people on TV and maybe even people you know doing tricks and stunts. These are people who have been practicing on scooters for a very long time. Don’t try something until you are ready. Avoid steep inclines and don’t ride too fast — you can lose control and fall. Skateboard parks are not designed for scooters.

Never ride in traffic or on the street and watch your surroundings for pedestrians, bikers, boarders and skaters.

Maintain a hold on the handlebars at all times.

DO NOT RETURN TO STORE

Failure to follow these instructions may damage your scooter and void your warranty.

WARRANTy

Razor Limited Warranty

The manufacturer warranties this product to be free of manufacturing defects for a period of 6 months from date of purchase. This Limited Warranty does not cover normal wear and tear, tires, tubes or cables, or any damage, failure or loss caused by improper assembly, maintenance, or storage.

This Limited Warranty will be void if the product is ever

• used in a manner other than for recreation

• modified in any way

• rented

The manufacturer is not liable for incidental or consequential loss or damage due directly or indirectly to the use of this product.

Razor does not offer an extended warranty. If you have purchased an extended warranty, it must be honored by the store at which it was purchased.

For your records, save your original sales receipt with this manual and write the serial number below.

__________________________________________

RAZOR MISCELLANEOUS MISCELLANEOUS