advertisement
◉
Touch to zoom
47260191 FALCON. 218 Series Pull Plate Trim For use with Economy Type Exit Devices Installation Instructions Install Cylinder Install Pull Plate ¢ For dummy pull plate, skip to steps for “Install Pull Plate”. 1. Use template to mark hole locations on door. If all holes have been drillled or cut, see next step to install cylinder. 2. Install rim cylinder through provided cylinder collar. 3. Insert the rim cylinder through hole in pull plate, and insert cylinder retaining cup from the back side of the pull plate. 4. Fasten rim cylinder assembly using two break-off screws provided. Note: The thinner cylinder collar provided with the rim cylinder is for use with cylinders purchased from competitor cylinder suppliers. Cylinder Collar For 1-1/8" (28mm) long cylinder use only Cylinder Retaining Cup Break-off screws ) By - provided with cylinder Tab must fit into >) slot on puli plate > _/ Rim Cylinder 1-1/8"(28mm) with IC or standard core Fasten these 2 screws Cylinder tailpiece goes thru this cylinder guide Customer Service 1-877-671-7011 www.allegion.com/us 1. 2. . Fasten pull plate and exit device using the three (3) mounting screws provided. Insert pull plate assembly on the door. The rim cylinder tailpiece should insert into the exit device cam approximately 7/16” (11 mm). If the tailpiece is too long and extends beyond the inside face of the door, carefully measure and mark at the closest break-off line. Then use pliers to break the tailpiece to the appropriate length. Mounting Screw (x2) Install it thru device chassis Device Chassis ь / N g 1-5/8"(41mm) Cylinder Hole Las @ 15/32"(12mm) mounting Hole (x3) — — — — Mounting Screw oc) Install it thru inside face of door AO) у \ CLIN | u © Allegion 2017 u UY. Printed in U.S.A. ALLEGION 47260191 Rev. 12/17-a
advertisement
Related manuals
advertisement