COLOR CAMERA  

ISD-A31

 

INSTALLATION PROCEDURE  

 

Precautions ●   Do not remove the blue sheet off the dome cover until the camera has been completely installed.

 

●   When taking out the camera unit, be careful not to damage the cable.

 

●   During the set-up work, be very careful not to get yourself injured.

1 Make the four pilot holes in the mounting face, as shown below, that fit the wiring holes and the mounting screw positions.

Drill the wiring holes to the diameters of

50-60 mm.

83.5

Ceiling wiring hole size:

50-60 mm dia.

4 Loosen the two camera unit fixing screws from the camera unit.

Camera unit

Holes for camera fixing

Front side

2 Peel the sheet off the rubber sealing gasket (waterproof) according to the housing base hole positions.

Rubber sealing gasket

Camera unit fixing screws

5 Turn the camera unit until the concaves of the camera unit match the mounting screw hole positions of the housing base.

Housing base

3 Using the supplied wrench, loosen the three fixing screws from the dome cover.

Detach the dome cover.

Dome cover

Supllied wrench

Housing base Mounting screw hole

6 Using the two supplied specific screws, secure the camera unit on the mounting face.

Supplied screws

1

2

7 Similarly to Step 5 above, turn the camera unit until the concaves of the camera unit match the remaining mounting screw hole positions of the housing base.

8 Using the remaining two supplied specific screws, secure the camera unit on the mounting face.

Supplied screws

9 After positioning the camera, attach the dome cover in place.

Dome cover

Ikegami Tsushinki Co., Ltd.

KY8-0172