advertisement
MATERIAL SAFETY DATA SHEET
1. Product and Company Identification
Material name
Use of the preparation
Version #
Revision date
CAS #
Manufacturer information
CC640Series
Inkjet printing
09
08-13-2008
Mixture
Hewlett-Packard Company
1000 NE Circle Boulevard
Corvallis, OR 97330-4239 US
(Direct) 1-503-494-7199
(Toll-free within the US) 1-800-457-4209
Hewlett-Packard health effects line
(Toll-free within the US)
(Direct)
1-800-457-4209
1-503-494-7199
General information telephone number
HP Customer Care Line
(Toll-free)
(Direct)
1-800-474-6836
1-800-474-6836
1-208-323-2551
Date prepared
MSDS number
Aug 06, 2008
302446
2. Hazards Identification
Emergency overview
Acute health effects
Contact with skin and eyes may result in irritation.
Any potential hazards are presumed to be due to exposure to the components.
Potential health effects
Routes of exposure
Chronic health effects
Carcinogenicity
Potential routes of overexposure to this product are skin and eye contact
Inhalation of vapor and ingestion are not expected to be significant routes of exposure for this product under normal use conditions.
Complete toxicity data are not available for this specific formulation
Carbon Black: Chronic inhalation studies performed with fine dust particles resulted in lung tumors in animals. The IARC classification was based upon these results. IARC also concluded "there is inadequate evidence in humans for the carcinogenicity of carbon black."
Inhalation of fine dust particles is not expected to occur during normal conditions of use of this ink.
None of the components present in this formulation at concentrations equal to or greater than
0.1% are listed by EU, MAK, IARC, NTP or OSHA.
3. Composition / Information on Ingredients
Component/substance
Water
1,5-pentanediol
2-pyrrolidone
Modified Carbon Black #6
Substituted diol
Composition comments
CAS number % by weight
7732-18-5
111-29-5
616-45-5
Proprietary
Proprietary
< 80
< 10
< 10
< 10
< 2.5
This ink supply contains an aqueous ink formulation.
This product has been evaluated using criteria specified in 29 CFR 1910.1200 (Hazard
Communication Standard).
Material name
Creation date
CC640SERIES
Sep 29, 2003
Version number
11
MSDS US
1 / 5
MATERIAL SAFETY DATA SHEET
4. First Aid Measures
First aid procedures
Eye contact
Skin contact
Inhalation
Ingestion
Do not rub eyes. Immediately flush with large amounts of clean, warm water (low pressure) for at least 15 minutes or until particles are removed. If irritation persists get medical attention.
Wash affected areas thoroughly with mild soap and water. Get medical attention if irritation develops or persists.
Remove to fresh air. If symptoms persist, get medical attention.
If ingestion of a large amount does occur, seek medical attention.
5. Fire Fighting Measures
Flash point and method
Hazardous combustion products
Flammable properties
Extinguishing media
Suitable extinguishing media
Unsuitable extinguishing media
Unusual fire and explosion hazard
Special firefighting procedures
> 200 °F (> 93.3 °C); Pensky-Martens Closed Cup
Refer to section 10.
None known.
Dry chemical, CO2, water spray or regular foam.
None known.
None known.
None established.
6. Accidental Release Measures
Personal precautions
Environmental precautions
Methods for containment
Methods for cleaning up
Other information
Wear appropriate personal protective equipment.
Do not let product enter drains. Do not flush into surface water or sanitary sewer system.
Dike the spilled material, where this is possible. Absorb with inert absorbent such as dry clay, sand or diatomaceous earth, commercial sorbents, or recover using pumps.
Soak up with inert absorbent material.
Soak up with inert absorbent material. Slowly vacuum or sweep the material into a bag or other sealed container. Dispose of in compliance with federal, state, and local regulations.
See also section 13 Disposal considerations.
7. Handling and Storage
Handling
Storage
Avoid contact with skin, eyes and clothing.
Keep out of the reach of children. Keep away from excessive heat or cold.
8. Exposure Controls / Personal Protection
Exposure guidelines
Exposure limits have not been established for this product.
Personal protective equipment
General
General hygeine considerations
Use personal protective equipment to minimize exposure to skin and eye.
Handle in accordance with good industrial hygiene and safety practice.
9. Physical & Chemical Properties
Color
Odor threshold
Physical state pH
Melting point
Black
Not available.
Not available.
7.5 - 8.2
Not available.
Material name
Creation date
CC640SERIES
Sep 29, 2003
Version number
11
MSDS US
2 / 5
MATERIAL SAFETY DATA SHEET
Freezing point
Boiling point
Flash point
Evaporation rate
Flammability
Flammability limits in air, upper, % by volume
Flammability limits in air, lower, % by volume
Vapor pressure
Vapor density
Specific gravity
Relative density
Solubility in water
Partition coefficient
(n-octanol/water)
Auto-ignition temperature
Decomposition temperature
VOC
Viscosity
Not available.
Not determined
> 200 °F (> 93.3 °C); Pensky-Martens Closed Cup
Not determined
Not available.
Not available.
Not determined
Not determined
> 1 (air = 1.0)
1 - 1.2
Not available.
Soluble in water
Not available.
Not available.
Not available.
< 3 %
> 2 cp
10. Chemical Stability & Reactivity Information
Chemical stability
Incompatible materials
Stable under recommended storage conditions.
Incompatible with strong bases and oxidizing agents.
Hazardous decomposition products
Possibility of hazardous
Upon decomposition, this product may yield gaseous nitrogen oxides, carbon monoxide, carbon dioxide and/or low molecular weight hydrocarbons.
Will not occur.
reactions
11. Toxicological Information
Not available.
12. Ecological Information
Aquatic toxicity
Persistence and degradability
13. Disposal Considerations
Disposal instructions
LC50/96h/Fathead minnows =>750 mg/L.
Not available.
Dispose of in compliance with federal, state, and local regulations.
HP's Planet Partners (trademark) supplies recycling program enables simple, convenient recycling of HP original inkjet and LaserJet supplies. For more information and to determine if this service is available in your location, please visit http://www.hp.com/recycle.
Material name
Creation date
CC640SERIES
Sep 29, 2003
Version number
11
MSDS US
3 / 5
MATERIAL SAFETY DATA SHEET
14. Transport Information
IATA
Proper shipping name
Hazard class
UN number
Packing group
Packaging exceptions
Packaging non bulk
Labels required
Not applicable
Not applicable
None
N/A
None
None
None
15. Regulatory Information
US federal regulations
US TSCA 12(b): Contains sodium nitrite (CASRN 7632-00-0), subject to export notification requirements.
CERCLA (Superfund) reportable quantity
None
Superfund Amendments and Reauthorization Act of 1986 (SARA)
Hazard categories
Section 302 extremely
Immediate Hazard - No
Delayed Hazard - No
Fire Hazard - No
Pressure Hazard - No
Reactivity Hazard - No
No hazardous substance
Section 311 hazardous chemical
No
International regulations
All chemical substances in this HP product have been notified or are exempt from notification under chemical substances notification laws in the following countries: US (TSCA), EU
(EINECS/ELINCS), Switzerland, Canada (DSL/NDSL), Australia, Japan, Philippines, South
Korea, New Zealand, and China.
State regulations
US - Pennsylvania RTK - Hazardous Substances: Listed substance
2-pyrrolidone (616-45-5) Listed.
16. Other Information
HMIS® ratings
NFPA ratings
Issue date
Revision
Disclaimer
Health: 1
Flammability: 1
Physical hazard: 0
Health: 1
Flammability: 1
Instability: 0
Aug 6 2008 1:21PM
9
This Safety Data Sheet document is provided without charge to customers of Hewlett-Packard
Company. Data is the most current known to Hewlett-Packard Company at the time of preparation of this document and is believed to be accurate. It should not be construed as guaranteeing specific properties of the products as described or suitability for a particular application. This document was prepared to the requirements of the jurisdiction specified in
Section 1 above and may not meet regulatory requirements in other countries.
Material name
Creation date
CC640SERIES
Sep 29, 2003
Version number
11
MSDS US
4 / 5
MATERIAL SAFETY DATA SHEET
Explanation of abbreviations
REC
REL
SARA
STEL
TCLP
TLV
TSCA
VOC
ACGIH
CAS
CERCLA
CFR
COC
DOT
EPCRA
IARC
NIOSH
NTP
OSHA
PEL
RCRA
American Conference of Governmental Industrial Hygienists
Chemical Abstracts Service
Comprehensive Environmental Response Compensation and Liability Act
Code of Federal Regulations
Cleveland Open Cup
Department of Transportation
Emergency Planning and Community Right-to-Know Act (aka SARA)
International Agency for Research on Cancer
National Institute for Occupational Safety and Health
National Toxicology Program
Occupational Safety and Health Administration
Permissible Exposure Limit
Resource Conservation and Recovery Act
Recommended
Recommended Exposure Limit
Superfund Amendments and Reauthorization Act of 1986
Short-Term Exposure Limit
Toxicity Characteristics Leaching Procedure
Threshold Limit Value
Toxic Substances Control Act
Volatile Organic Compounds
Material name
Creation date
CC640SERIES
Sep 29, 2003
Version number
11
MSDS US
5 / 5
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
Key Features
- Original
- Print technology: Inkjet printing
- Printing colours: Photo black
- Colour ink type: Dye-based ink
- Standard Yield
- 1 pc(s)