Clarke CHT718 User Instructions

UNIVERSAL HUB/BEARING

PULLER

Model No: CHT718

Part No: 1801718

USER INSTRUCTIONS

GC06/12

INTRODUCTION

Thank you for purchasing this CLARKE product. The kit may be used for installing seals and bearings into the hubs of most vehicles. It may also be used for pulling hubs where the wheel flange is drilled and tapped so that the road wheel is secured with bolts.

Please read and follow the instructions carefully. In doing so you will ensure the safety of yourself and others around you, and you can look forward to the product giving you long & satisfactory service.

Please keep these instructions in a safe place for future reference

KIT CONTENTS

1

2

3

7

8

9

Disc - 55.5mm (2-3/16”) HTCHT71801

Disc - 59mm (2-11/32”) HTCHT71802

Disc - 62mm (2-7/16”)

Disc - 78mm (3-3/32”)

Disc - 84mm (3-5/16”)

HTCHT71803

4 Disc - 65mm (2-9/16”) HTCHT71804

5 Disc - 66mm (2-19/32”) HTCHT71805

6 Disc -71.5mm (2-13/16”)HTCHT71806

Disc - 73mm (2-7/8”) HTCHT71807

HTCHT71808

HTCHT71809

A Sleeve 76mm (3”) HTCHT71810

B1 Cup- 86mm (3-13/32”) HTCHT71811

B2 Cup- 91mm (3-19/32”) HTCHT71812

C1 Bolt M14 x 90

D Flat Washer

HTCHT71813

HTCHT71814

E Sleeve 36mm (1-7/16”) HTCHT71815

F Centre Bolt HTCHT71816

G Thrust Washers

H Long Nut

C2 Bolt M12 x 90

HTCHT71817

HTCHT71818

HTCHT71819

2

Parts & Service: 020 8988 7400/E-mail:[email protected] or [email protected]

METHOD OF USE

WARNING: THE VEHICLE MUST BE PROPERLY PREPARED, AND

ADEQUATELY SUPPORTED ON AXLE STANDS, ON FIRM LEVEL GROUND,

BEFORE ANY OPERATION USING THIS TOOL IS PERFORMED.

INSTALLING SEALS & BEARINGS

Assemble the parts as shown in the example, selecting the components which fit the job in hand. Ensure the large nut (H) is screwed fully on to the bolt (F), and all components are entirely square before tightening.

HUB PULLING

It is possible to remove a hub from the swivel joint, using the bolts (C) supplied.

The appropriate size bolts are screwed into the holes in the wheel flange, so that they bear up against the surface of the swivel joint.

Screw in the bolts progressively to pull off the hub.

For hubs where the wheel is mounted on studs, a slide hammer type puller must be used.

GUARANTEE

This product is guaranteed against faulty manufacture for a period of 12 months from the date of purchase. Please keep your receipt which will be required as proof of purchase.

This guarantee is invalid if the product is found to have been abused or tampered with in any way, or not used for its intended purpose. Faulty goods should be returned to their place of purchase. No product can be returned to us without prior permission. This guarantee does not effect your statutory rights.

3

Parts & Service: 020 8988 7400/E-mail:[email protected] or [email protected]