- Computers & electronics
- Telecom & navigation
- Mobile phones
- Car kits
- Louroe Electronics
- VeriFact® 535
- Instructions
Louroe Electronics VeriFact® 535 Instructions
Add to My manuals4 Pages
Louroe Electronics VeriFact® 535 is a wall mount speakerphone designed for 2-way audio communication with various audio/video transmission systems. It has built-in Digital Signal Processing (DSP) with echo cancellation, attenuation, and noise filtering, allowing for clear communication. It can operate in either FULL or HALF DUPLEX modes, depending on the transmission device's capabilities.
The VeriFact 535 can be flush or surface mounted, and it requires a 12Vdc, 500mA power supply to operate. It features a 1-inch lighted, vandal-resistant call button with a normally open momentary "dry" contact output, which can be connected to an alarm input or doorbell circuit. It also has adjustable speaker and microphone gain, allowing you to customize the audio levels to your preference.
advertisement
®
6955 VALJEAN AVE, VAN NUYS, CA 91406
PH: (818)994-6498 / FAX: (818)994-6458 [email protected]
/ www.louroe.com
VERIFACT
-535/545
SPEAKERPHONES
INSTALLATION AND OPERATING INSTRUCTIONS
VERIFACT
-535
VERIFACT
-545
DESCRIPTION
Models VeriFact -535 and VeriFact -545 are wall mount speakerphones designed to provide 2-way audio (listen/ talkback) with various modes of audio/video transmission systems such as:
• IP Camera
• DVRs
• Video Servers
The VeriFact-535/545 have built in Digital Signal Processing (DSP) functionality that incorporates features such as echo cancellation, attenuation and noise filtering, as such the units can operate in FULL or HALF DUPLEX mode/s depending on the capability of the transmission device.
A plastic back box is provided with the unit for recessed mounting to a wall, an OPTIONAL metal backbox can be ordered as an accessory if surface mounting is desired. The VeriFact-535/545 must be powered by a 12Vdc, 500mA power supply.
The unit can be used for partial outdoor applications such as mounted to an outdoor exterior wall however the unit must not be mounted in locations that are susceptible to excessive direct water spray.
The VeriFact-535 integrates a 1-inch. lighted, vandal resistant call button with a normally open momentary “dry” contact output, that can be connected to an alarm input, doorbell circuit etc.
OPERATIONS
The gain of the microphone and speaker are factory adjusted. If it is necessary to change the gain of the speaker of the unit, it has to be done in small increments.
To adjust the audio output of the speaker, rotate the potentiometer clockwise (increase) or counterclockwise (decrease) slowly until the desired loudness is attained.
The VeriFact-535/545 provide line level audio input and output. It has amplifier that drives the built-in 4” speaker.
For detailed wiring diagrams to terminate the connection to a 3.5mm mono/stereo or RCA jack please refer to page 2 of this document.
LOUROE ELECTRONICS® 6 9 5 5 VA L J E A N AVENUE, VAN NUYS, CA 91406 TEL (818) 994-6498 FAX website: www.louroe.com e-mail: [email protected]
Page 1 of 4
(818) 994-6458
VERIFACT -535/545 04/2020
INSTALLATION AND OPERATING INSTRUCTIONS
INTERCONNECTION DIAGRAM
CONNECTING LOUROE MODEL VERIFACT -535/545
DIRECTLY TO AN IP CAMERA, DVR,
VIDEO SERVER, ETC. USING 3-COND. SHIELDED CABLE
5-PIN TERMINAL BLOCK IDENTIFIER OF VERIFACT-535/545
(black) PWR = 12VDC
(black w/stripe) GND = Power Ground
( red ) OUT = Audio Output (microphone)
( bare )
(white)
GND = Ground (audio) and Ground (speaker) (black wire)
IN = Speaker in from external device
LOUROE MODEL
VERIFACT
-535
PC BOARD
EXT
MIC SPKR
AUDIO
IN
A B C SP
AUDIO
OUT
+12Vdc
TALKBACK
ADJUST
+12Vdc,
1.5
m
A power required
(AD-1 power supply included)
Connect to this 2-pin terminal block
ELECTRET
CONDENSER
MICROPHONE
(C) BARE
(B) RED
BLACK (C)
WHITE (SP)
WIRING REQUIREMENTS
3 Conductor consisting of:
+ 2 Conductor shielded , 20 gauge with 22 gauge drain
+ 1 Conductor unshielded , 20 gauge
All in the same jacket
TO AUDIO IN OF IP CAMERA, DVR, ETC.
TO AUDIO OUT OF IP CAMERA, DVR, ETC.
NOTE: BLACK AND BARE WIRES ARE COMMON GROUND
3.5mm
STEREO CONNECTION
Black Wire
Bare Wire
White Wire
Red Wire
E
R
E
S
T
E
R
S
T
E
Audio In Audio Out
3.5mm
MONO CONNECTION
Bare Wire
Black Wire
White Wire
Red Wire
M
O
N
O
M
O
N
O
Audio In Audio Out
Red Wire
RCA CONNECTION
Bare Wire
Audio In
Black Wire
White Wire
Audio Out
LOUROE ELECTRONICS® 6 9 5 5 V A L J E A N AVENUE, VAN NUYS, CA 91406 TEL (818) 994-6498 FAX website: www.louroe.com e-mail: [email protected]
Page 2 of 4
(818) 994-6458
VERIFACT
-535/545 04/2020
INSTALLATION AND OPERATING INSTRUCTIONS
SPECIFICATIONS (Microphone)
Type Electret Condenser
Microphone output line level (0 dB @ 1k W)
Microphone element sensitivity
Frequency response
Output Impedance
Supply voltage
SPECIFICATIONS (Speaker)
-45dB
40 Hz to 15 kHz 1 dB
600 W unbalanced
12 Vdc, 500mA
Speaker Power output
Speaker Impedance
Speaker magnet
Speaker size
Weight, net
2W
8
W
3 oz. ceramic
4” (10cm)
3 Lbs. (1.4 Kg)
SPECIFICATIONS (Mechanical)
Dimensions (Face Plate) 6 1/4"H x 8"W metric (158mm H x 203mm W)
Backbox for AOP-535/545
Surface Mount Box (metal) 6 1/4"H x 8"W x 2 3/4”D metric (158mm H x 203mm W x 70mm D)
Flush Mount Box (plastic)
Backbox Portion 5"H x 6 7/8"W x 2 5/8”D metric (127mm H x 175mm W x 67mm D)
Total including flange 6 1/4"H x 8"W x 2 5/8”D metric (158mm H x 203mm W x 67mm D)
IMPORTANT NOTICE
When this equipment is used as part of an audio monitoring system, the law requires that the public be given notice of AUDIO MONITORING ON THE
PREMISES.
A decal notice is included with each microphone shipped.
AUDIO
MONITORING
On
These Premises
®
Federal Law References:
Federal Regulations, US Code, Title 18. Crime and
Criminal Procedure, Sec 2510.
WARRANTY
LOUROE ELECTRONICS warrants that at the time of shipment products manufactured by LOUROE ELECTRONICS to be free of defects in material and workmanship. Should a defect appear within five years (60 months) from date of shipment, LOUROE ELECTRONICS will, at its sole discretion, repair or replace the defective equipment. This equipment shall not be accepted for repair or return without prior notification by LOUROE ELECTRONICS .
This warranty does not extend to any Louroe product that has been subjected to improper or incorrect installation, misuse, accident, or in violation of installation instructions provided by
LOUROE ELECTRONICS.
Returned shipments to LOUROE ELECTRONICS shall be at customer’s expense. LOUROE ELECTRONICS will return the equipment prepaid via best way.
LOUROE ELECTRONICS® 6 9 5 5 V A L J E A N AVENUE, VAN NUYS, CA 91406 TEL (818) 994-6498 FAX website: www.louroe.com e-mail: [email protected]
Page 3 of 4
(818) 994-6458
VERIFACT
-535/545 04/2020
INSTALLATION AND OPERATING INSTRUCTIONS
MANUFACTURED
IN THE
LOUROE ELECTRONICS ® 6 9 5 5 V A L J E A N AVENUE, VAN NUYS, CA 91406 TEL (818) 994-6498 FAX website: www.louroe.com e-mail: [email protected]
Page 4 of 4
(818) 994-6458
VERIFACT
-535/545 04/2020
advertisement
Related manuals
advertisement