User Manual - Cleaningshop.com.au

OPERATING GUIDELINES
SC1500
ATTENTION! Do not use the machine before you have read and understood the User Manual
1. Check the battery charge gauge
(and if necessary re-charge).
2. F ill-in the tank with clean water.
Check if the Ecoflex bottle is well
installed (only for machine with
3. C heck the vacuum hose is
connected to the squeegee
4. Check the brush is clean
5. Install the brush on the deck
8. Press the One-Touch button
9. Adjust to the desired water flow
10. A djust to the desired chemical
concentration
13. P ress the forward pedal, select the
14. Open the crew cap and empty the
15. If necessary, empty the solution
Ecoflex)
6. Check if the solution filter is clean
7. Stand on the machine and turn on
the key (squeegee lowers automatically)
11. Select double pressure if needed
16. Remove and clean the debris tray
12. Select silent mode if needed
17. Wash the recovery tank with clean
water
direction and start operating the
recovery tank with the squeezable
machine
hose
18. Remove debris from the brushes
19. Take the squeegee off and check
the blades’ wear status
tank through the solution valve and
clean the filter net
20. Clean the machine using a damp
cloth and park it with the recovery
tank open
If the machine has been used until the Red light illuminates on the battery level indicator on the machine, a full recharge of the batteries (10-12 hours) will be required. Failure to
carry out this this procedure may cause damage to the batteries. Charging the batteries after every use is recommended.
PLEASE ENSURE RED SOCKET IS LEFT DISCONNECTED AFTER RECHARGE IF THE MACHINE IS NOT TO BE USED ON A DAILY BASIS
TROUBLESHOOTING
SC1500
ATTENTION! Do not use the machine before you have read and understood the User Manual
The machine
doesn’t work
as it should?
1 Check if the power cable is
2 Check the battery charge gauge
(and if necessary re-charge)
correctly connected
The suction
doesn’t work
as it should?
1 Check the vacuum hose is
connected to the squeegee
The machine
doesn’t clean
2 Open the recovery tank and
check if the gasket and
3 Check if squeegee blades
are damaged or dirty
vacuum grid are cleaned
4 Close the recovery tank
properly and/or verify the
gasket wear
as it should?
1 Check to have solution into the
tank
2 Check if you have the right water
setting
3 Check if the filter is cleaned
1 Check if the brush is correctly
installed and not worn out
2
3 Check if there are external materials
avoiding brush rotating
The brush
don’t work as they
should?
Check the brush is cleaned
5 Check to have suction
button activated