PIXAPRO® POWERPACK Flash Cable
Foreword
Thank you for purchasing this PowerPack cable. This cable is made of high-quality, wear-resistant, and highly-insulated wires. It is designed
to connect to the PIXAPRO® PowerPack Dual Output to a flash This user manual applies to all models of PowerPack cable.
Contents
Foreword
Warnings
Cables Compatibility
Instructions for Battery
Warnings
Please use according to instructions as there is high voltage output on both terminal ends.
Please check the surface of cable carefully before use. Do Not Use if cable is damaged.
Homemade cablse should not be used on PowerPack Dual Output.
Cable Compatibility
Consumers can choose different flash cables compatible with corresponding flashes according to their own needs.
Based on the compatibility, the available flash cables are listed as below: Canon, Nikon, Sony and Metz
Canon Cable
Nikon Cable
Sony Cable
Metz Cable
Instructions for Battery
“AA” Batteries (see the chart column “AA Batt's”)
Some flashes require that you install AA batteries into the battery compartment for powering the inner circuits, even when using the flash power
connector cable. See the Chart.
If AA batteries are required, the PIXAPRO® PowerPack will nevertheless provide most of the power required for the flash.
In dedicated flash modes, the flash unit will draw power from AA batteries too. This is down to the design of the flash, not the PowerPack itself.
Refer to the list of specific instructions for your flash listed in the Table:Compatibility of PowerPack Cables
Compatibility of PIXAPRO® PowerPack Flash Cables
Flash Cable
CANON CABLE
Flash Model
Cannon 600EX-RT, 430EZ, 540EZ,
550EX, Cannon 580EX, 580EX II, and
other flash model with same type of
input power port
AA Batt's
Special Instruction
Yes
Switch on Flash
NIKON CABLE
Nikon SB910, SB28 EURO, SB28DX,
SB80DX,SB800,SB900 and other flash
model with same type of input power port
Yes
Switch on Flash
SONY CABLE
Sony HVL-F58AM and other flash model
with same type of input power port
Yes
Switch on Flash
No
Switch off flash, and the connected
battery pack will power the flash.
METZ CABLE
Metz 58AF-1 / 58AF-2 (C/N/OP/P/S)
and other flash model with same type
of input power port
82.APB820L0-00 VB
Made in China