Owner’s Manual
Marketed in Australia and New Zealand by Bzooma Pty Ltd ABN 37 640 907 507
1
TABLE OF CONTENTS
Table of Contents .................................................................................................................2
Bzooma PTY LTD...................................................................................................................2
Manufacturing Company Profile..........................................................................................2
Operating Procedures ..........................................................................................................3
Repair & Maintenance .........................................................................................................3
Charging the Battery ............................................................................................................4
Product Specifications .........................................................................................................4
BZOOMA PTY LTD
This User Manual is written and published according to the latest BZOOMA PTY LTD specifications. We
will continue the policy of improvement and may make some changes in the design and specifications
without notice. If you have any enquiries, please contact your local dealer or buy directly from this web
site bzooma.com.au. Delivery will be via your nearest Bzooma dealer.
This manual is published by Bzooma Pty Ltd
MANUFACTURING COMPANY PROFILE
Your Bzooma Roller is manufactured by AVIC Guangzhou Aviation Industry Group Company Ltd,
founded in 1951. The company was founded to conduct scientific, production and management
research. The enterprise belongs to China Aviation Industry Corp, and has a staff of more than 10,000
people. Development of electric cars is a focus of the company’s efforts.
2
OPERATING PROCEDURES
1. Make sure the new scooter is fully charged upon first use.
2. Check the controller is in the neutral position.
3. When seated fasten your seat belt.
4. Insert the key to the power switch and turn ON (at night use Night mode P). An alarm will sound
to indicate that power is on. Speed level setting and battery level will be indicated.
5. Operate the joystick controller to move forward/back/left/right.
6. Release the joystick controller and the electronic brakes will stop the scooter. A quick stop is
possible by moving the joystick in the reverse direction. Never turn the key off while moving
because the brakes are electrically operated and power must remain available to the brakes while
in operation.
7. Collision avoidance is employed by Intelligent Function on the left arm rest. When collision is
imminent (obstacle or person within 2.2 meters) the Roller will stop and a voice warning will sound.
To continue, it must be switched off and back on again before the joystick is active again. Please
note that this function is a rider assistance only and driver diligence is vital at all times.
8. When the scooter is not in use, turn off the power and remove the key.
REPAIR & MAINTENANCE
The Roller is a low maintenance machine, however a 6 monthly inspection by your Bzooma dealer is
advised to check tyres and brakes.
3
CHARGING THE BATTERY
1. Insert charger into the controller charge point, then insert power port to the AC outlets, then
switch on the power.
Battery power indicator
Power button
Speed controller
Horn button
Joystick
2. Now turn key to ‘POWER ON’ to start charging.
On
Power
Off
3. Do not press the button to turn on the controller. Fully charge the new battery for at least 7
hours in a well ventilated area before use.
Power
4. The LED light of the charger will turn RED while charging.
5. When fully charged the LED light will turn GREEN. The charger is a smart charger which will
not continue charging when the chair is full charged.
6. After charging, first turn off power and pull the AC power plug, then pull out the charger port.
4
7. The battery is a high quality unit, and with normal use and care it is capable of approximately
2000 cycles. It will only gradually lose range and power but remain functional, and should give a
long serviceable life if this simple advice is followed.
PRODUCT SPECIFICATIONS
Dimensions
1060 x 650 x 1200
Maximum Speed (km/h)
6 km/h
Maximum Endurance
25 km/h
Driving Mode
Front Wheel Drive
Brake Mode
Electro-Magnetic Brake
Turning Radius (mm)
700
Maximum Gradient
10
Controller
PG controller imported from UK
Motor Specification
200w X 2
Battery Specification (V)
24v Lithium Battery
Battery Capacity (Ah)
30 amp
Charge Time
5-6hrs
Special Feature
Intelligent Obstacle Avoidance
5
WARRANTY
Bzooma Pty Ltd Limited Warranty
Bzooma Pty Ltd provides this Limited Warranty to the
original purchasers of new Bzooma machines in Australia
and New Zealand.
Bzooma Pty Ltd guarantees the machine, power base
including Motor, Battery and charger, against defects in
materials and workmanship for a period of one (1) year,
from date of delivery to the original purchaser. Damage
caused by accident or obvious abuse is not covered by this
warranty.
To make a claim covered by this warranty the purchaser
must contact an authorised BZOOMA Pty Ltd Dealer for
inspection and service. Indications of abuse, accident, or
unauthorised tampering with the machine power base
mechanical, or electrical equipment, will void any claim.
Bzooma Pty Ltd is not responsible for transport costs
associated with obtaining service or repairs under this
warranty.
6