Contact Chauvet
USA
Tecnical Assistance: 1-800-762-1084 (954) 929-1115
E-Mail tech@chauvetlighting.com
9 Foot Tripod Stand
Caution
CH-01
Always use safety pins.
Never exceed the load capacity.
Technical Specifications
User Guide
Maximum Load: 45 Kg / 100 lbs
Please read these instructions carefully before use
Extends: 3.7 m / 9 ft
W eight: 6.6 Kg / 14.75 lbs
World-wide Headquarters:
3000 North 29th Ct., Hollywood, Florida, USA, FL 33020
Tel: +1-954-929-1115 Fax: +1-954-929-5560
User Informtion (Please complete for your records)
Date Purchased:
Dealer Stamp:
/
/
Serial No: ________________
Model: CH-01 9 Ft Tripod Stand
www.ChauvetLighting.com
Lower Lighting Bars
Loosen top lighting bar knob. Snap lighting bar into upper pole
extension.
Upper Pole
Extension Knob
Using supplied mounting screws, secure lighting effects to lighting
bar. Take care to balance weight evenly. Do not exceed 100 lbs.
Lower Pole
Extension Knob
Loosen upper pole extension knob and raise pole to desired height.
Stand extends a maximum of 9ft.
Leg Extension
Knob
Installation/Mounting
Top Lighting Bar
Mounting Screws
Lighting Bar Knob
This unit has been designed to be set on a flat level surface.
Failure to do so could cause serious injury.
Introduction
Congratulations on the purchase of your new CHAUVET lighting
stand. We are confident you will enjoy many trouble free hours with
this unit. To assist with the care and use of the product we have prepared this short guide.
Cleaning
The body of the unit should be cleaned with a soft damp cloth.
Other Products from Chauvet
Operation
This tripod stand has been designed to hold a maximum of 100lbs.
balanced evenly on the lighting bars.
PAR38C
Chrome
Also Available in
black
F750
Category I
Fogger
Loosen leg extension knob and pull outwards on legs to widest position for optimum stability.Tighten leg extension knob. Tighten set
screw with supplied allen wrench.
Loosen lower pole extension knob and pull pole upwards to fully
extend lower pole. Tighten pole extension knob. Tighten set screw
with supplied allen wrench.
Loosen lower lighting bar knobs. Slide the lighting bars onto upper
pole extension and tighten. Be sure that the support bracket is fully
extended.
CH-219
CH-323
Obsession
Zipper