Quick Installation Guide
Mini Dome Type Network Camera
2. Loosen the set screw on the front cover to disassemble the camera with the supplied Allen key.
3. Fix the adapter plate to the ceiling with the supplied expansion screws.
8. Use the supplied adjusting tool to adjust the pan [±30°], tilt [0~80°], and rotation direction [0~360°].
9. Tighten the hex screw to fix the well-adjusted surveillance angle.
No.
1
2
3
4
Descrip ti on
Front Cover
Dome Drive
Micro SD Card Slot
Network Cable
No.
8
9
10
11
Descrip ti on
Audio/Alarm Cables
Wi-Fi Antenna
Serial Port Interface
Hex Screw
5 Lens 12 MIC
6 IR LED 13 RESET/WPS Bu tt on
7 Power Cable
WWW.LAVIEWUSA.COM
Note:
Please make sure that the wall is strong enough to withstand three times the weight of the camera.
Installation Steps:
1. Drill the screw holes and the cable hole in the ceiling according to the supplied drill template(2 different types).
4. Fix the dome drive with the supplied screws.
5. Connect the power cable, network cable, and the audio/alarm cables.
6. View the image via the web browser.
7. Slightly loosen the hex screw beside the WPS/RESET button to adjust the surveillance angle.
10. Align the front cover to the dome drive and tighten the set screws on the front cover.
11. Tear off the protection film softly to complete the installation.
For detailed instructions of further configuration, please refer to the user manual of network camera.