advertisement
INSTALLATION INSTRUCTIONS
Jeep Wrangler JK/JKU Turn signal
1. Remove the (6) six plastic fasteners at the top of the grille.
2. Lean grille forward. Using panel pry tool, release the metal clips.
3. Unclip turn signal by rotating it out of socket. To removing signal, push plastic retainer inward to release, pushing housing out of grille.
4. Insert JP-TSL1 into grille, pushing locking clips into place. 5. Connect yellow wire to +12VDC accessory power, to activate halo. 6. Complete install by doing step 3, 2, 1 in reverse order.
Login to continue