IP Link® Device Interface
Ethernet Communication Sheet
acti_19_6841_1.pkn
Revision: 11/5/2013
This document provides additional assistance with wiring your Extron IP Link enabled product to your device.
Different components may require a different wiring scheme than those listed below.
For complete operating instructions, refer to the user’s manual for the specific Extron IP Link enabled product or
the controlled device manufacturer supplied documentation.
Device Specifications:
Device Type:
Manufacturer:
Firmware Version:
Model(s):
Camera
ACTi
N/A
KCM-8111
Minimum Software and Firmware Requirements:
IP Link
Compiler
IP Link
Firmware
1.6.0
1.17
GC Version
3.5.1
Version History:
Driver
Version
Date
1
10/1/2013
Notes
Initial version.
Driver Notes:

This driver is unidirectional and does not provide any feedback.
Page 1 of 3
IP Link® Device Interface
Ethernet Communication Sheet
acti_19_6841_1.pkn
Control Commands & States:
Camera Preset Recall
1 to 32
Flip
Enable
Disable
Mirror
Enable
Disable
Motion Detection
Enable
Disable
Output 1
High
Low
Output 2
High
Low
Power LED
Enable
Disable
Status Available:
N/A
Page 2 of 3
Revision: 11/5/2013
IP Link® Device Interface
Ethernet Communication Sheet
acti_19_6841_1.pkn
Revision: 11/5/2013
Network communication:
When configuring the Ethernet driver, be sure device settings match that of the GC configuration.
Port Type:
Ethernet
Logon Credentials
Supported:
Default User Name:
Yes
Default Port:
80
Multi-Connection
Capable:
Port Changeable:
No
admin
Yes
Ethernet Driver Configuration Description:
Please refer to user manual for settings and changes to the network communication parameters such as: User Name,
Passwords and Port Number.
Notes for the Device:
Page 3 of 3
Open as PDF
Similar pages
QSC
JESCO Lighting KIT-SD122-A Installation Guide
attached document