When you contact your Dealer regarding service or warranty please quote the
model number and serial number as shown on the heater control panel inside
the control access door.
OWNER’S MANUAL
Wall Furnace - WF2000
Affix serial & model
numbers sticker here
Warranty Service
Australia 1-300-650-644
seeleyinternational.com
It is the policy of Seeley International to introduce continual
product improvement. Accordingly, specifications are
subject to change without notice. Please consult with your
dealer to confirm the specifications of the model selected.
(English) (WF2000)
612195g
seeleyinternational.com.au
AU 1102
OPERATING INSTRUCTIONS
OPERATING INSTRUCTIONS
Care Instructions
External surfaces should be cleaned
with warm water and detergent with the
heater turned off. Do not use abrasive
cleaners as scratching of the surface
will occur.
Introduction
Heat Setting
For satisfactory performance of your
Braemar gas wall furnace, please read
these instructions carefully. The
operation of the heater is controlled by
the gas control knob and fan switch
located behind the access door on the
front cover.
- Turn gas control knob anti-clockwise to
desired heat setting between “1” and
“7”.
- The heater will automatically adjust the
gas flow to maintain the room
temperature corresponding to the
selected heat setting.
Fan Operation
To Increase Heat Setting
The fan will start automatically in both
AUTO and BOOST positions when the
unit is warm enough after the burner is
turned on, and stop automatically when
the unit has cooled sufficiently after the
burner turns off. With AUTO selected
the unit will automatically select
between "low" and "normal" (and
“boost” on 40MJ models) fan speeds
based on the heated air temperature no further user adjustment is necessary.
When BOOST is selected the fan will
run only on its boost speed. It is
recommended that the manual fan
switch be set to AUTO for normal
operation, or BOOST for rapid heat-up.
- Turn gas control knob anti-clockwise
towards “7”.
Gas Control
- Turn gas control knob clockwise
to the “0” position.
Recommended Maintenance
Periodic maintenance of your Braemar
Wall Furnace will ensure a long and
satisfactory service life with the heater
delivering optimum performance.
It is recommended that you contact your
authorised Braemar service agent to
arrange a routine maintenance check at
the start of each heating season.
Service and maintenance work must
only be carried out by Authorised
personnel.
Fan
Auto / Boost
switch
Igniter button
Warning
To light the heater:
- Turn the gas control knob anticlockwise from the “0” position to the
position.
- Depress knob fully and hold down.
- Press the igniter button located next to
the gas control knob 3-4 times.
- Observe the pilot meter to indicate
operation of the pilot.
- Wait 20 seconds then release the gas
control knob and check the pilot meter
stays on.
- Repeat the process if required.
Do not place articles on or against this
appliance.
Do not use or store flammable materials
near this appliance.
Do not spray aerosols in the vicinity of
this appliance while it is in operation.
Do not modify this appliance.
Pilot meter
2
WF2000
To Decrease Heat Setting
- Turn gas control knob clockwise
towards “1”.
To Turn Off Main Burner
- Turn gas control knob clockwise
towards “PILOT” position. It is
recommended that the pilot be left in
operation during the heating season.
To Turn Off Completely (end of
heating season)
Gas control knob
SEELEY INTERNATIONAL – OWNER’S MANUAL
3