Inhand IR302 Industrial Iot LTE 4G VPN Router User Manual

How to use the router with SIM card ?

1.

Insert the SIM card into the slot 1 and attach 4G antennas to the Main and AUX connectors; then power cycle the device. To replace or insert SIM Card, the device must be powered off to avoid data loss or equipment damage.

2. Connect the LAN2 port with your PC.

3. Fill in the IP of the router on the browser (you could find the IP on the label of router).

IP: 192.168.2.1

User name/password: adm/123456

4. Go to 'network >>Cellular', select 'profile 1' under the ‘ network provider( ISP)’ , fill in the SIM card information in the Profiles table down below:

APN, User Name, Password, (User Name and Password are not mandatory), hit 'ok' and

'Apply'.

Notice: Please make sure the APN is correct. If you are not sure, please confirm with ISP or search it on Google.

Below are the most commonly used APN names

5.

Check the network status, 'Status >> Network connection'

IR300#How to do a hard reset

Step 1. Locate the RESET button on the InRouter302;

Step 2. Plug in the power supply; press and hold RESET button within 10 seconds;

Step 3. When STATUS LED is on, release the RESET button;

Step 4. Within a few seconds, STATUS LED should go off; then press and hold the RESET button again;

Step 5. When the STATUS LED is flashing, release the RESET button, and that means the Router is now back to its factory default settings;

Need any support ?

Please feel free to contact us: [email protected]