Removing the Filter Case
1 . Hold the top of the front panel and pull towards you to remove the cover.
2. Push down on the middle tabs located on the top and bottom of the Filter
Case and then pull towards you to release the Filter Case.
3 . Once you have removed the Filter Case , lay it on a flat surface .
4 . Remove the Pre-Filter by pinching the two tabs on the top left and right side of the frame .
3 .
Installing
Your New Filters
1. Unwrap all of your new replacement filters.
2. Insert the new filters into the Filter-
Case . Make sure to ident i fy the orientation and direction for each filter . i. Customized Filter
Ensure that the filter label faces outwards and is located on the top . The top right corner is different from the other 3 corners and should be aligned accordingly.
•
ii. BioGS HEPA Filter
•
iii. Activated Carbon Filter iv. Medium Filter
Make sure the edge of the med i um filter lines up and sticks to the velcro on the
Act i vated Carbon Filter .
•
v. Pre-Filter
3. With the new filters inside the case, place the Pre-Filter in last, making sure all the filters are packed snugly .
4 . Insert the Filter Case with all the new filters back into the MinusA3 .
. v . e m. .
ii. i. iv .
4.
.,,, /
'
\
I
I