advertisement
Register your product and get support at
EN User manual
© 2011 Koninklijke Philips Electronics N.V.
All rights reserved.
AJ5030_05_UM_V1.0
AJ5030_05_UM_V1.0.indd 1
AJ5030
A
B
SET A
CLOC
K
L 1 SET AL 2
SET TIM
E
P
R
O
G
S
C
A
N
A
L 1
LE
S
E
P
PROJE
CTION
R ADI
O
SNOOZE
B R I G H T N E S S
A
L
2 a b c d e f g h i j k
B
C
D l m n o p
12/24H TIME ZONE
DST
FLIP
0
°
1 8 0
°
AL
1
RADIO
BUZZ
1
VOL
AL
2
RADIO
BUZZ
2 s r q
12/24H TIME ZONE
DST
FLIP AL 1
0 ° 1 8 0 ° RADIO
BUZZ
1
CLOCK RADIO AJ 5030 VOL
AL 2
RADIO
BUZZ
2
E a c
SET TIME
CLO
SET AL 1
SET AL 2
SET TIM E
L 1
L E
S
PROJE
CTION
R ADI O
SNOOZE
B R I G H T N E S S
CLO
SET
CK
SET AL 2
SET TIM
E
L 1
PROJE
CTION R ADI O
SNOOZE
B R I G H T N E S S
S
L E
M I N b d
HR
CLO
SET AL 1
SET AL 2
SET TIM E
L 1
L E
S
PROJE
CTION
R ADI O
SNOOZE
B R I G H T N E S S
C LO C K
CLO
CK
AL 1 SET AL 2
SET TIM
E
L 1
PROJE
CTION
R ADI O
SNOOZE
B R I G H T N E S S
F b a
SET AL 2
CLO
SET
E
R A D I O
L 1
L E
PROJE
CTION
SNOOZE
R ADI O
B R I G H T N E S S
SET AL 2
SET
CLO
CK
AL 1
E
L 1
L E
PROJE
CTION R ADI O
SNOOZE
B R I G H T N E S S
G
12/24H TIME ZONE
DST
CLOCK RADIO AJ 5000 VOL
AL 1
RADIO 1
AL 2
RADIO 2
VOL
EN
1 Important
Safety
•
•
•
•
•
•
•
•
•
Read these instructions.
Heed all warnings.
Follow all instructions.
Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions.
Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat.
Protect the power cord from being walked on or pinched, particularly at plugs, convenience receptacles, and the point where they exit from the clock radio.
Only use attachments/accessories specified by the manufacturer.
Unplug this clock radio during lightning storms or when unused for long periods of time.
Refer all servicing to qualified service personnel. Servicing is required when the clock radio has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the clock radio, the clock radio has been exposed to rain or moisture, does not operate normally, or has been dropped.
This clock radio shall not be exposed to dripping or splashing.
Do not place any sources of danger on the clock radio (e.g. liquid filled objects, lighted candles).
• Where the MAINS plug or an appliance coupler is used as the disconnect device, the disconnect device shall remain readily operable.
2 Your clock radio
Congratulations on your purchase, and welcome to Philips! To fully benefit from the support that Philips offers, register your product at www.philips.com/welcome.
Introduction
With this unit, you can:
•
• listen to FM radio; know the time; wake up by buzzer alarm, radio, or melody; and view time projected on a wall or ceiling.
What’s in the box
A
Check and identify the contents of your package:
Overview of the main unit
B a Focus ring
• Adjust sharpness of projected image.
b HR/TUNING +/-
Adjust hour.
Tune to radio stations.
• c AL1/AL2
Turn on/off alarm.
View alarm settings.
d PROG/SCAN
• Scan/store radio stations.
e PROJECTION
• Turn on/off projector. f BRIGHTNESS/SNOOZE
•
•
Snooze alarm.
Adjust display brightness.
g RADIO
•
Turn on/off radio stations.
turn off the ringing alarm.
h SLEEP
• Set sleep timer.
i MIN/PRESET +/-
•
•
Adjust minute.
Select a preset radio station.
j CLOCK/SET AL1/SET AL2/SET TIME
•
Set time/alarm.
View time.
k Projector
•
•
Project time onto wall/ceiling.
Adjust projected direction.
l 12/24H·DST
•
•
Select 12/24 hour format.
Select daylight saving time (DST) option.
m TIME ZONE
• Select time zone.
H a
SET AL 1
SET AL 2
CLO
SET AL 1 SET AL 2
SET TIM
E
L 1
PROJE
CTION
R ADI O
SNOOZE
B R I G H T N E S S c
CLO
SET
CK
AL 1 SET AL 2
SET TIM
E
L 1
L E
S
PROJE
CTION R ADI O
SNOOZE
B R I G H T N E S S
MIN
I
AL1
PM b d
HR
CLO
SET AL 1
CK
SET AL 2
SET TIM
E
L 1
L E
S
PROJE
CTION R ADI O
SNOOZE
B R I G H T N E S S
C LO C K
CLO
SET AL 1
CK
SET AL 2
SET TIM
E
L 1
L E
S
PROJE
CTION R ADI O
SNOOZE
B R I G H T N E S S
AL2
J a c b d
17°
90° n FLIP
• 0°/180°: reverse projected image.
o AL1/RADIO·BUZZ· 1
• Select alarm source for Alarm 1.
p AL2/RADIO·BUZZ· 2
• Select alarm source for Alarm 2.
q Power cord & Antenna r Battery tray s VOL
• Adjust volume.
3 Get started
Always follow the instructions in this chapter in sequence.
Install battery
C
Warning
•
•
•
•
Risk of explosion! Keep batteries away from heat, sunshine or fire. Never discard batteries in fire.
Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type.
The battery contains chemical substances, so it should be disposed of properly.
Keep children away from the battery.
2011-4-15 14:23:31
Note
•
•
You can only use AC power as power supply. The lithium
CR2032 battery is only for back-up purpose.
When power is disconnected, the display backlight is off.
When is displayed, you need replace the battery as indicated.
Connect power
D
Caution
•
•
Risk of product damage! Ensure that the power voltage corresponds to the voltage printed on the back or underside of the clock radio.
Risk of electric shock! When you unplug the AC adapter, always pull the plug from the socket. Never pull the cord.
Plug and set
The clock radio has “plug and set” feature. When power is connected, the clock is set automatically.
Select time zone
Check if the time of the clock radio is consistent with the local time.
If not, adjust the time zone settings according to your location.
1
In standby mode, press TIME ZONE.
» The current time zone number blinks on the display panel.
2
Press TIME ZONE repeatedly to select time zone.
For United Kingdom and Ireland:
Western European Time (WET) +0 (by default)
Set clock
E
In standby mode, you can set clock manually.
Select DST (daylight saving time) mode
For countries with daylight saving time (DST), the clock radio offers you DST option to adjust summer time.
In standby mode, press and hold 12/24H·DST for two seconds.
» The clock advances by one hour.
Tip
• To exit DST mode, repeat the above operation.
To select 12/24 hour format, press 12/24H·DST repeatedly.
4 Listen to FM radio
Tune to FM radio stations
F
Note
•
•
Position the antenna as far as possible from TV, VCR, or other radiation source.
For optimal reception, fully extend and adjust the position of the antenna.
Note
• To turn on/off radio, press RADIO.
Store FM radio stations automatically
You can store up to 20 FM radio stations.
1
Press RADIO to turn on the radio.
2
Press and hold PROG for two seconds.
» The clock radio stores all the available FM radio stations and broadcasts the first available station automatically.
Store FM radio stations manually
1
Tune to an FM radio station.
2
Press PROG.
» The preset number begins to blink.
3
Press PRESET +/- or TUNING +/- repeatedly to select a number.
4
Press PROG again to confirm.
5
Repeat Steps 1 to 4 to store other stations.
Note
• To remove a pre-stored station, store another station in its place.
Select a preset radio station
In tuner mode, press PRESET +/- to select a preset number.
Adjust volume
G
5 Set alarm timer
Set alarm time
H
In standby mode, you can set two alarms to ring at different time.
Select alarm sound
For the alarm sound, you can select buzzer, your last heard radio, or the melody stored in the clock radio.
Adjust AL1/RADIO·BUZZ· 1 or AL2/RADIO·BUZZ· 2 to select alarm sound for Alarm 1/Alarm 2.
Activate/deactivate alarm timer
I
1
Press AL1/AL2 to view alarm settings.
2
Press AL1/AL2 again to activate or deactivate the alarm timer.
» AL1 or AL2 appears if alarm timer is on and disappears if it is off.
•
•
To stop alarm, press the corresponding AL1/AL2
(or RADIO).
The alarm repeats ringing for the next day.
Note
• When alarm sounds, you cannot adjust volume by rotating VOL.
Snooze alarm
When alarm sounds, press SNOOZE.
» The alarm snoozes and repeats ringing five minutes later.
To adjust alarm interval (in minutes), press SNOOZE repeatedly.
5 10 15 20 25 30
6 Other features
Set sleep timer
This clock radio can switch to standby mode automatically after a preset period.
Press SLEEP repeatedly to select the sleep timer period
(in minutes).
» When the sleep timer is activated, appears.
To deactivate the sleep timer, press SLEEP repeatedly until [OFF]
(off) appears.
15 30 60 90 120 off
Project time onto wall/ceiling
J
By projecting time onto a wall or ceiling, this clock radio offers you a unique way to read time in the dark.
Warning
• Risk of damage to eyes! Do not look at the glowing red light constantly.
Note
• Before you start, switch CLOCK/SET AL1/SET AL2/SET TIME to CLOCK.
1
Press PROJECTION to turn on the projector.
2
Rotate the projector to adjust the projected direction.
3
Rotate the focus ring to adjust the image sharpness.
4
To reverse the projected image, switch FLIP to left or right.
Tip
• To turn off the projector, press PROJECTION again.
Adjust display brightness
Press BRIGHTNESS repeatedly to select different brightness levels: high, mid, and low.
7 Product information
Note
• Product information is subject to change without prior notice.
Specifications
Amplifier
Rated Output Power 0.6W RMS
Tuner
Tuning Range
Sensitivity
- Mono, 26dB S/N Ratio
Search Selectivity
Total Harmonic Distortion
Signal to Noise Ratio
General information
AC power
Operation Power Consumption
Standby Power Consumption
Dimensions
- Main Unit (W x H x D)
Weight
- With Packing
- Main Unit
FM: 87.5 - 108 MHz
FM: <22 dBu
FM: <28 dBu
FM: <3%
FM: >45 dB
100-240 V~, 50/60Hz
<3W
<1W
135 x 135 x 60.5 mm
0.6 kg
0.3 kg
8 Troubleshooting
Warning
• Never remove the casing of this clock radio.
To keep the warranty valid, never try to repair the clock radio yourself.
If you encounter problems when using this clock radio, check the following points before requesting service. If the problem remains unsolved, go to the Philips web site (www.philips.com/welcome).
When you contact Philips, ensure that the clock radio is nearby and the model number and serial number are available.
No response from the unit
• Disconnect and reconnect the AC power plug, then turn on the unit again.
Poor radio reception
• Increase the distance between the unit and your TV or
•
VCR.
Fully extend the FM antenna.
9 Notice
This product complies with the radio interference requirements of the European Community.
Any changes or modifications made to this device that are not expressly approved by Philips Consumer Lifestyle may void the user’s authority to operate the equipment.
Note
• The type plate is located on the bottom of the apparatus.
Your product is designed and manufactured with high quality materials and components, which can be recycled and reused.
When this crossed-out wheeled bin symbol is attached to a product it means that the product is covered by the European Directive 2002/96/
EC.
Please inform yourself about the local separate collection system for electrical and electronic products.
Please act according to your local rules and do not dispose of your old products with your normal household waste. Correct disposal of your old product helps to prevent potential negative consequences for the environment and human health.
Your product contains batteries covered by the European Directive
2006/66/EC, which cannot be disposed with normal household waste.Please inform yourself about the local rules on separate collection of batteries because correct disposal helps to prevent negative consequences for the environmental and human health.
Environmental information
All unnecessary packaging has been omitted. We have tried to make the packaging easy to separate into three materials: cardboard
(box), polystyrene foam (buffer) and polyethylene (bags, protective foam sheet.)
Your system consists of materials which can be recycled and reused if disassembled by a specialized company. Please observe the local regulations regarding the disposal of packaging materials, exhausted batteries and old equipment.
2011 © Koninklijke Philips Electronics N.V. All rights reserved.
Specifications are subject to change without notice. Trademarks are the property of Koninklijke Philips Electronics N.V. or their respective owners. Philips reserves the right to change products at any time without being obliged to adjust earlier supplies accordingly.
AJ5030_05_UM_V1.0.indd 2 2011-4-15 14:23:32
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
Key Features
- Time projection