Installation Instruction
Siphonic Two-Piece Toilet
Inside the box:
Wax Ring
G
T-Bolts with Retainer (2)
A
B
Bowl-To-Floor Knobs (2)
C
D
Bolt Caps (2)
Tank-To-Bowl Gasket
T
Tank-To-Bowl Knobs (2)
E
F
Tank-To-Bowl Knobs (2)
Toilet Seat Assembly
Wax Ring
G
1. Filled into the foundation
screw mounting holes.
2. Press the wax ring firmly.
3. Apply the toilet weight,
do not remove after installed.
C
A
T
Tank-To-Bowl Gasket
G
4. Tighten the assembly with the order,
adjust it until fixing the floor.
5. Put the toilet seat on the bow,
install the accessories in order.
6. Rubber washer goes inside
the tank.
F
E
7. Tighten nuts alternately to
make them stable on the
toilet bowl.
Installation achieved.
8. Front lever installation
Turn plastic nut clockwise to remove it from the lever arm. Insert lever arm through the square hole on the front side of tank. Then screw the plastic nut counterclockwise to tighten it on. Hook chain from flapper to trip lever arm. Leave only enough chain to fully raise the flapper when the trip lever arm.
Leave only enough chain to fully raise the flapper when the trip lever is activated. Leave 5 or 6 extra links at the end of the chain of any future adjustment. Cut to length and insert the refill tube into the overflow tube.
Secure the refill tube using the clip provided. Refill tube should not extend into the overflow tube more than one inch.