Avantco Equipment 177C10 User Manual

User Manual
Thermo Pump System
Coffee Brewers – User Manual
Models: 177C10, 177C15
04/2018
Please read and keep these instructions. Indoor use only.
www.AvantcoEquipment.com
1
User Manual
Parts Diagram
2
177C15
177C10
5
8
3
6
3
4
4
9
2
6
7
5
1
9
Parts Key
2
Parts Diagram #
Part Name
Replacement Part Item #
1
Warming Plate
177CPLATE (C10)
2
Reservoir Lid
177CRESLID
3
Stainless Steel Brewing Funnel
177C1015BASK
4
Decanter or Airpot
5
Power Switch
6
Indicator Light
7
Power Switch for Upper Warming Plate - C10 only
8
Warming Plate
177CPLATE (C10)
9
Foot
177CFOOT
Not Pictured
Wire Funnel Guard
177C1015GARD
Not Pictured
Automatic Thermostat
177CATHM
Not Pictured
Manual Thermostat
177CMTHM
Not Pictured
51" Power Cord
177CCORD
Not Pictured
Heating Element
177CELEMENT
Not Pictured
Warmer Plate Heating Element - C10 only
177CPLTELM (C10)
Not Pictured
Relay
177CRELAY
Not Pictured
Reservoir Screen
177CRSCREEN
www.AvantcoEquipment.com
User Manual
Specifications
Model: 177C10, 177C15,
Electrical: 120V, 50-60Hz; 1650W(C10), 1450W(C15),
Water Capacity: 2.2 liters
!
Read and understand all instructions before using
the appliance. CAUTION! HOT SURFACE!
Warnings
• This appliance is designed for commercial use only.
• This appliance must be placed on a level surface able to adequately support its weight.
• Users should not leave the appliance unattended while it is in operation.
• Never immerse the appliance in water.
• Never pour hot water, coffee, or coffee powder into the water reservoir.
• Do not overfill the water reservoir.
• Do not unplug the appliance if your hands are wet.
• Do not unplug the appliance by pulling the cord.
• Do not attempt to repair or replace the power cord if it becomes damaged. Contact a qualified service agent.
• While the appliance is in use, some parts will become very hot. Ensure that the cord does not come in contact with
any hot parts.
• Be careful not to touch any hot surfaces.
• Do not allow empty decanters to sit on the hot plate.
Installation
Carefully unpack the coffee brewer and inspect for
damage and missing parts.
1. Position the brewer on a sturdy, level surface. Allow enough room above it for safe and easy filling of the water reservoir.
2. Place an empty glass decanter or airpot under the funnel.
3. F
ill the brewer’s reservoir with water (approximately 75 ounces).
4. Turn the power switch to “ON”. The Readiness Indicator should light. After approximately 2 minutes, the machine will begin brewing.
5. After 4-5 minutes, the Readiness Indicator should turn off, indicating that the brewing process has ended.
6. Repeat
steps 2 through 5 twice to clean the machine’s internal parts before brewing coffee for the first time.
NOTE: It is normal to hear some brewing and pumping sounds and to see water vapor coming out of
the machine during this procedure.
!
In case of overflow, turn the power switch
“OFF” immediately to stop the process.
www.AvantcoEquipment.com
3
User Manual
Operation
1. R
emove the funnel, and insert a paper coffee filter. Add the appropriate amount of coffee grounds.
Return the funnel to its correct position.
2. Make sure the empty airpot or decanter is positioned correctly under the funnel.
3. Fill the water reservoir, and turn the brewer “ON”.
a. Note: Do not add more than 1 decanter (64 oz.) of water to 177C10 to prevent overflow.
b. The Readiness Indicator should light up and brewed coffee will start flowing into the airpot or decanter. When the
Readiness Indicator light turns off, the brewing cycle is complete.
CAUTION: To prevent spills or burns, wait until coffee has stopped dripping from the funnel before removing it.
4. D
ispose of the used coffee grounds and coffee filter and rinse the funnel with clean water. The unit is now ready to
brew another batch.
CAUTION: Do not leave empty decanters on the hot plates as this can damage the unit as well
as the decanter.
NOTE: After the first use, a small amount of water will always remain in the machine. If it will not be
used for an extended period, you should always pour out the remaining water and clean the machine
to prepare it for storage or transport.
Cleaning
Regular cleaning ensures long life. For dirt or smudges on the brewer’s exterior, a damp cloth will suffice. If necessary,
a non-corrosive, non-abrasive detergent or cleaner may be used. Be sure to unplug the appliance before cleaning.
Klearly
Koffee
Klearly Koffee is a simple, easy-to-use product that should be used daily to
remove or prevent oil residue and mineral build-up, which turns rancid, causing
bitter tasting coffee or tea.
Directions for Cleaning Glass Decanters
Use daily for best results.
1) Shake bottle. Apply 3-4 squirts (approx. 1/4 oz. Per 1 gal. of liquid) Klearly Koffee into the decanters (not included).
Add very hot water (not boiling).
2) Use a carafe brush for best results on tough stains.
3) Empty solution and rinse vessel thoroughly with clean, warm water. Air dry or wipe clean before next use.
The Importance of Deliming
To prolong your coffee brewer’s life and maintain a consistent, quality product, regular deliming is recommended.
When hard water is heated, minerals are left behind which can inhibit optimum performance. You should perform the
following deliming process at least every 6 months. If your water is extremely hard, monthly deliming is recommended.
4
www.AvantcoEquipment.com
User Manual
Deliming Procedure
• Mix 10 oz. of fresh or condensed lemon juice with 32 oz. of water and pour it into the water reservoir.
• Make sure an empty decanter is underneath the funnel, and turn the unit “ON” as if you are brewing a pot of coffee.
• If the brewer has stopped working, the use of a deliming spring (sold separately) may be necessary to loosen lime
deposits in the spray head.
• After the brewer has completed its cycle, turn it “OFF” and empty the decanter.
• Run two or three brewing cycles of plain water through the machine to rinse out all traces of the lemon water solution
before brewing more coffee.
If the brewer suddenly stops working during a normal brewing cycle, deliming may be necessary.
20” Deliming Spring 3591901033
This deliming spring fits into the sprayhead opening of pour-over coffee
makers to loosen lime deposits. Made of stainless steel. Sold Separately.
Limited 6 Month Warranty
All equipment, which is sold under the Avantco Equipment trademark and used for commercial purposes, is warranted
against defects in materials and workmanship. The warranty runs for 6 months from the date of installation and is for
the benefit of the original purchaser only. All other Warranties, Expressed, or Implied, Statutory or Otherwise, including
Without Limitation any implied Warranty of Merchantability or Fitness for Purposes are excluded. The Seller shall in no
event be liable for direct, indirect or consequential damages in connection with AVANTCO commercial products. This
warranty is not effective if damage occurs because of accident, carelessness, improper installation, lack of proper set –
up, supervision when required of if the equipment is installed or operated in any manner contrary to the installation and
operating instructions. The use of unfiltered water in this unit will void the warranty.
This warranty does not apply to, and Avantco is not responsible for any warranty claims on products sold or used
outside of the contiguous United States.
This equipment is intended for commercial use only. Warranty is void if equipment is installed in anything other than
commercial applications.
www.AvantcoEquipment.com
5