IF-2/IF-4/IF-8

IF-2/IF-4/IF-8
®
6955 VALJEAN AVE, VAN NUYS, CA 91406
PH: (818)994-6498 / FAX: (818)994-6458
[email protected] / www.louroe.com
AUDIO INTERFACE ADAPTERS
INSTALLATION AND OPERATING INSTRUCTIONS
DESCRIPTION
The LOUROE IF-2, IF-4 and IF-8 are two, four zone and eight
zone audio interface adapters designed for connecting up to two
(IF-2), four (IF-4) or eight (IF-8) Louroe™ microphones with:
! DVR’s
! IP Network Cameras with audio inputs
! Video Servers with audio inputs
! PC Sound Card Modules
IF-2 AUDIO
INTERFACE ADAPTER
(two audio inputs and outputs)
The input side of the IF-2/IF-4/IF-8 has terminal blocks for
receiving the wiring from the microphones. The output side has
RCA types of output. The following cables and adaptors are
included with each IF series.
IF-4 AUDIO
INTERFACE ADAPTER
(four audio inputs and outputs)
RCA to RCA type - For connection to a DVR, etc. with RCA
audio inputs.
RCA to 3.5mm mono type adaptor - For connection to an IP
Network Camera, etc. with a 3.5mm audio input
These three units also contain individual “audio level control”
potentiometers for audio gain adjustment. Output from the
Louroe™ microphone can be increased 10dB or decreased 30dB.
WIRING CONNECTIONS
IF-8 AUDIO
INTERFACE ADAPTER
(eight audio inputs and outputs)
MICROPHONE TO INPUT SIDE OF IF-2/IF-4/IF-8
All Louroe microphones contain a terminal block
marked A, B, C
A = 12Vdc power (Red)
B = Audio output (Black)
C = Ground
(Bare)
WIRING REQUIREMENTS
2 Conductor shielded cable, 22
gauge with a 24 gauge drain wire
NOTE:
Unshielded cable is not
satisfactory for audio systems
If using recommended wiring, connect as follows:
Red wire goes to Terminal A of microphone (12Vdc power)
Black wire goes to Terminal B of microphone (Audio Output)
Bare wire goes to Terminal C of microphone (Ground)
After all microphones have been connected, bring other end of wiring to the IF-2/IF-4/IF-8 location
and connect each microphone to the terminal blocks of the unit marked A, B, C. Be sure to properly
match wire colors. If using cable from other manufacturers, color code may vary.
LOUROE ELECTRONICS® 6 9 5 5 VA L J E A N AVENUE, VAN NUYS, CA 91406 TEL (818) 994-6498
website: www.louroe.com
e-mail: [email protected]
Page 1 of 4
FAX (818)994-6458
If_248_inst_5/11
INSTALLATION AND OPERATING INSTRUCTIONS
CONNECTION BETWEEN IF-2/IF-4/IF-8 AND DVR (OR OTHER AUDIO RECEIVING
DEVICES)
The output side of IF-2/IF-4/IF-8 has an RCA output per microphone with two types of connectors
1. RCA to RCA type cable; for connection to a DVR, etc. with RCA audio inputs
2. RCA to 3.5mm mono adaptor: for connection to a DVR, IP Network Camera or Video Server
that has 3.5mm audio inputs.
If the receiving device contains RCA type “audio in” jacks, then connect from Audio Out of IF-2/IF-4/IF-8 to
Audio In of DVR, using the provided RCA connector cables.
If the receiving device contains 3.5mm mono audio inputs, connect 3.5mm RCA to mono adaptor to one
end of the RCA cable (supplied) and plug that end to the DVR. Connect the RCA end of the cable to the
output of the IF-2/IF-4/IF-8.
Included with the units are:
2, 4 or 8 RCA to RCA cables
2, 4 or 8 RCA to3.5mm mono adaptors
APPLYING POWER TO THE IF-2/IF-4/IF-8
Included with the IF-2/IF-4/IF-8 is a power supply (120V/12Vdc). Connect the small end of the 90° female
plug into the 12Vdc jack, located on the input side. Then connect the two-prong large end into a
standard 110/120V electrical outlet.
Turn ON/OFF power switch, located behind green power LED to ON position. The green LED will illuminate,
indicating power to the system. The system will now provide audio to the DVR, Soundcard Module, IP
Network Camera, etc.
AUDIO LEVEL ADJUSTMENT
Located on the input side are potentiometers (round, with adjustment arrow) for each microphone. This is
for adjusting the audio gain and to prevent overdriving or underdriving the audio signal.
The adjustment arrows are shipped in the straight-up position. Turn slowly counterclockwise to lower
the gain, and clockwise to increase. This will provide the desired level of audio signal into the Audio
Receiving Device (DVR, Soundcard Module, etc.). A full turn clockwise increases the gain to 10dB. A
full turn counterclockwise will decrease the gain -30dB.
AUDIO TEST SWITCH
The purpose of this switch is to indicate the presence of audio and to assure the user that the IF-2/IF-4 or IF8 is driving the audio signals into the audio input of receiving device (DVR, IP Network Camera, Video
Server, Soundcard module, etc.)
Located on the audio output side of IF-2/IF-4/IF-8 is a DIP switch labeled Audio Test Switch. To the left
of the switch is a red LED marked Audio Indicator.
For testing:
1) Select a zone that has a microphone connected to the microphone terminal block.
IF-2 utilizes pins 1&2. IF-4 utilizes pins 1-4. IF-8 utilizes pins 1-8.
2) Push pin to the ON position. The red LED will illuminate, indicating audio is present. With
short bursts of audio, the LED will flicker and with continuous flow of audio LED
illumination is constant. Only one microphone can be tested at a time
NOTE: When testing is complete, all pins on DIP switch must be in the OFF position
LOUROE ELECTRONICS® 6 9 5 5 VA L J E A N AVENUE, VAN NUYS, CA 91406 TEL (818) 994-6498
website: www.louroe.com
e-mail: [email protected]
Page 2 of 4
FAX (818)994-6458
If_248_inst_5/11
INSTALLATION AND OPERATING INSTRUCTIONS
INTERCONNECTION DIAGRAM
FOR
CONNECTING LOUROE VERIFACT™ MICROPHONES
TO A DVR WITH MULTIPLE AUDIO INPUTS USING
LOUROE MODEL IF-2, IF-4 OR IF-8 AUDIO INTERFACE ADAPTER
(IF-4 used as an example)
Back side of
Verifact™ A Microphone Shown
VERIFACT
A
VERIFACT
N
A B C
A
VERIFACT
A
N
L
A B C
L
VERIFACT
N
L
A B C
A
N
Red - 12Vdc power
Black - Audio Output
Bare - Ground
L
A B C
A B C
RED
BARE
BLACK
2 CONDUCTOR
SHIELDED
22 GAUGE
WEST PENN
452 OR EQUIV.
R
All Louroe microphones
VERIFACT™ A, B, C, D, D-V, E, K, L-DT
are compatible with Louroe IF-2,
IF-4 and IF-8 Audio Interface Adapters
BLACK
+12 Vdc POWER
SUPPLY (INCLUDED)
RED
BARE
MIC INPUTS
LOUROE
E
AUDIO LEVEL CONTROL
LECTRONIC S
Verifact™ A Microphone shown as an example
with IF-4 Interface Adapter
IF-4
FOUR ZONE AUDIO INTERFACE ADAPTER
AUDIO OUTPUTS
ON
1
1
C BA
RS
2
31 4
1
2
1
3
4
1
Audio Indicator Light
Audio Out
Audio Test Switch
RCA output
LOUROE MODEL IF-4
AUDIO INTERFACE ADAPTER
(Connections for IF-2 and IF-8 are same as above)
RCA CABLE CONNECTS FROM
“AUDIO OUT” OF IF-4 TO
“AUDIO IN” OF DVR, ETC.
Use 3.5mm mono to RCA
cable of IF-4 for
connection to
Video Server
IF-2 will accommodate
2 Louroe™ microphones
IF-4 will accommodate up to
4 Louroe™ microphones
audio input
Audio Path
1
2
3
4
Audio In
IF-8 will accommodate up to
8 Louroe™ microphones
VIDEO SERVER
West Penn 452
AUDIO IN
AUDIO OUT
or equivalent
DVR WITH RCA TYPE AUDIO INPUTS
LOUROE ELECTRONICS® 6 9 5 5 VA L J E A N AVENUE, VAN NUYS, CA 91406 TEL (818) 994-6498
website: www.louroe.com
e-mail: [email protected]
Page 3 of 4
FAX (818)994-6458
If_248_inst_5/11
MANUFACTURED
IN THE
SPECIFICATIONS
Input (3-pin terminal block)
Audio Input Impedance
Audio Output Impedance
Audio Output Gain
Power Requirements
Dimensions (IF-2)
Dimensions (IF-4/IF-8)
Weight, net including
power supply & cables
Line Level (0dB@1KW
)
5kW
600W
+10dB
+12 Vdc, 500mA
6 ”L x 4½”W x 1¼”H
11½”L x 4¾”W x 1¼”H
IF-2 1.7 lbs (0.8 Kg)
IF-4 2 lbs (0.9 Kg)
IF-8 2.5 lbs (1.1 Kg)
IMPORTANT NOTICE
When this equipment is used as part of an audio
monitoring system, the law requires that the public
be given notice of AUDIO MONITORING ON THE
PREMISES. A decal notice is included with each
microphone shipped.
AUDIO
MONITORING
On
These Premises
®
Federal Law References:
Federal Regulations, US Code, Title 18. Crime
and Criminal Procedure, Sec 2510.
WARRANTY
LOUROE ELECTRONICS® warrants that at the time of shipment products manufactured by LOUROE ELECTRONICS® to be free of defects in material and workmanship.
Should a defect appear within one year (12 months) from date of shipment, LOUROE ELECTRONICS will, at its sole discretion, repair or replace the defective equipment.
This equipment shall not be accepted for repair or return without prior notification by LOUROE ELECTRONICS®.
This warranty does not extend to any Louroe product that has been subjected to improper or incorrect installation, misuse, accident, or in violation of installation
instructions provided by LOUROE ELECTRONICS.®
Returned shipments to LOUROE ELECTRONICS® shall be at customer’s expense. LOUROE ELECTRONICS® will return the equipment prepaid via best way.
LOUROE ELECTRONICS® 6 9 5 5 VA L J E A N AVENUE, VAN NUYS, CA 91406 TEL (818) 994-6498
website: www.louroe.com
e-mail: [email protected]
Page 4 of 4
FAX (818)994-6458
If_248_inst_5/11